Replacement of One motor for Lift Irrigation scheme Verinag

Design, Manufacture, Supply, Installation, Testing & Commissioning of Horizontal Centrifugal Pumping unit to be installed at the existing Lift Irrigation Scheme Verinag. The pumping unit shall have the following specifications:- PUMP:- Make = Reputed Make (M&P/Kirlosker/KSB/Sintech/Flow more or equivalent) Discharge = 2.5 Cusec (0.07079 m3/sec) Dynamic Head = 56 m. Speed = 1480 RPM Type of pump = Horizontal Split Casing Centrifugal. NPSH A at site = 3.60 m MATERIAL OF CONSTRUCTION: Impeller = Bronze grade V of IS : 318 or CF-8M Wearing Ring = Bronze grade V of IS: 318 Impeller Shaft = Stainless Steel AISI 410 Gland = Bronze grade V of IS: 318 Fasteners = High tensile Steel Shaft Sleeve = Stainless Steel AISI 410 Pump Casing = Close fine grained Cast Iron conforming to IS:210 Grade 20 Coupling = Tyre coupling of suitable size Base frame =M.S fabricated as per IS 2062 Motor Specifications:- Type---------------Horizontal Type Squirrel Cage Induction Motor No of phases-------------------------03 Horse Power----------------------as per design but not less than 85 HP Speed---------------------------------1480 RPM Enclosure-----------------------------TEFC Rated Voltage------------------------415 ±10% Rated Frequency--------------------50±3% Class of Insulation---------------------“F” Temperature Rise------------ Limited to class B Type of Duty--------------------------Continuous Motor efficiency .......... ≥IE2 Make/(BHEL/Marthon/Crompton/Kirlosker/Jhoti/Havells/ABB or equivalent .) The job includes coupling of the Motor with the Pump by way of providing and fitting of a suitable size tyre coupling with allied works and necessary modifications required, if any for fitment of the Pump Motor assembly to existing delivery and suction of diameter 150mm and 125mm respectively. The job includes costs on account of all duties, taxes, freight, transportation, transit insurance, handling, tools and tackles and consumables required for carrying out the said job and dismantling of old worn-out equipment. Note: The Pumping unit shall have to be got inspected by the Third Party Inspection Agency namely CEIL/EIL/Rites etc and the Certificate of the same shall be provided at the time of the supply of the equipment, for which the scope has been kept in the estimate cost. The equipment must be supplied this test certificates and pump curves/QAP need to be uploaded at the time of tendering. The Govt. Circular of Finance Department issued vide No. DGAT/PS/DR/7865508/86 Dated: 06-03-2026 shall be applicable.

Providing, Fitting, Installation, Testing and Commissioning of Priming Sewage Submersible pump of 1 HP capacity Kirloskar/Crompton/KSB/Mather plate make for priming purpose of Pumping units with following specifications : a.Type ------ Sewage submersible b.Head ------ suitable for 6 Mtrs. c. Phase /Voltage ------ 1 phase , 220 +/-10% V d. Power/RPM ------ 1 HP/2900 The priming pump shall be suitable for operation under submerged conditions and shall be suitable for wide water level fluctuations taking place in suction side. The job shall include providing of PVC Flexible Pipe (10 M) of required size including fitting like ball valve, Nipples, clamps, Elbows/Bends as required for priming of the pumping units and complete installation as required. The job also includes suitable capacity compact starter and P/F of 6mm Sq. Submersible cable=10 metres