WBPWD/AE/NRSH/NIT-27/2025-26_6

Dismantling all type of plain cement concrete works, stacking serviceable materrials at site and removing rubbish as directed with in a lead of 75 m In ground floor including roof.

(a) upto 150 mm. thick. --Ground Floor

Cement concrete (1:1.5:3) with graded stone chips 5.6 mm size with hexagonal square mesh wire netting, I.R.C. fabric mesh or X.P. M. fitted and fixed after tying the existing reinforcement on concrete without distributing the same and with proper scarping and cleaning the reinforcement and disturbed concrete with wire brush etc. after applying a coat of cement including the cost of wire netting I.R.C or X. P. M. & cost of all handling and scaffolding complete as per direction of Engineer-in -charge.

c) 37.5mm thick

Plaster ( to wall, floor, ceiling etc.) with sand and cement mortar including rounding off or chamfering conrners as directed and raking out joints including throating, nosing and drip course, scaffolding/staging where necessary (ground floor). [Excluding cost of chipping over concrete surface].

(i) with 1:6 cement mortar.

(b) 20 mm. thick plaster. Ground Floor

(ii) With 1:4 cement mortar .

(c)10 mm. thick plaster. Gr Floor

Dismantling artificial stone flooring upto 50 mm.thick by carefully chiselling without damaging the base and removing rubbish as directed within a lead of 75 m. .

a) In ground floor

Hire and labour charge for shuttering with centreing and necessary staging up to 4 m. using approved stout props and thick hard wood planks of approved thick ness with required bracing for concrete slabs, beams, columns, lintels curved or staight including fitting fixing and striking out after complection of works. (up to roof of ground floor).

(a) 25 mm. to 30 mm. thick wooden shuttering as per decision & direction of the Engineer-in-charge. . Gr Floor

Ordinary cement concrete (mix 1:1.5:3) with graded stone chips (20mm nominal size) excluding shuttering and reinforcement, if any, in ground floor as per relevant codes.

(i) Pakur Variety. Gr Floor

Reinforcement for reinforced concrete work in all sorts of structures including distribution bars, stirrups, binders etc. initial straightening and removal of loose rust (if necessary), cutting to requisite length, hooking and bending to correct shape, placing in proper position and binding with 16 gauge black annealed wire at inter-section, complete as per drawing and direction.

(a) For works in foundation, basement and up to roof of ground floor/up to 4m. Tor steel/Mild steel.

other than SAIL/TATA/RINL/JSW/JSPL/Shyam/SRMB/ISSL/BMASL/Electrosteel (Add. above ground floor - 1st. floor)

Artificial stone in floor, dado, staircase etc. with cement conctrete (1:2:4) with stone chips laid in panels as directed with topping made with ordinary or white cement (as necessary) and marble dust in proportion (1:2) including smooth finishing and rounding off corners including raking out joints or roughening of concrete surface and application of cement slurry before flooring works, using cement @ 1.75 kg./sq.m. all complete including all materials and labour In ground floor. 3 mm. thick topping (High polishing grinding on this item is not permitted) with ordinary cement. Using grey cement.

(ii) 25 mm. thick. Gr Floor

Labour for taking out door and window frame including shutter for repair or replacemnt of different part of the frame and refixing the same including mending good all damages complete.(Concrete and brick work for mending damage will be paid separately).

(a) up to area 2.5 sq.m.

Wood work in door and window frame fitted and fixed in position complete including a protective coat of painting at the contact surface of the frame excluding cost of concrete, Iron Butt Hinges and M.S clamps. (The quantum should be corrected up to three decimals).

(f) sishu , Gamar, champ, badam, bhola, mogra, Hallak. (Add. above ground floor - 2nd floor) (Add. above ground floor - 2nd floor) (Add. above ground floor - 1st. floor) (Add. above ground floor - 1st. floor) (Add. above ground floor - 1st. floor)

Panel (made of single plank) of door and window shutters to design as directed:.in ground floor ( payment to be made on area of exposed new work ). ( in case of non-supply of single plank panel rate of reduction to a maximum of a 30% will be made).

(i) 12 mm thick panel of 30cm to 45cm width. (Add. above ground floor - 1st. floor) (Add. above ground floor - 1st. floor)

(b) sishu,gamar,Champ,badam,bhola, mogra,Hallak, .

Anodise aluminium barred/tower/socket bolt (full covered) of approved manufactured from extruded section conforming to I.S.204/74 fitted and Fixed with cadmium plated screws:.

(vi) 200 mm long x 10 mm dia. bolt.

Anodised aliminium D-type handle of approved quality manufactured from extruded section conforming to I.S. specification (I.S.230/72) fitted and fixed complete:.

(a) With continuous plate base (hexagonal/round rod).

(vii) 150 mm grip x 12 mm dia rod.

Supplying best Indian sheet glass panes set in putty and fitted and fixed with nails and putty complete (In all floors for internal wall & upto 6m height for external wall ).

(i) 3 mm. thick (weighing 7.4 kg/sq.m.).

(A) Painting with best quality synthetic enamel paint of approved make and brand including smoothening surface by sand parpering etc. in cluding using of approved putty etc. on the surface , if necessary.

(a) On timber or plastered surface: .

(1) With super gloss (hi-gloss).

(iv) Two coats (with any shade except white).

(b) On steel or other metal surface: .

(1) With super gloss (hi-gloss).

(iv) Two coats (with any shade except white).

Supplying, fitting and fixing PVC pipes of approved make of of Schedule 80 (medium duty) conforming to ASTMD-1785 and threaded to match with GI Pi;es as per IS:1239 (Part-I) with all necessary accessories, specials viz. socket, bend, tee, union, cross, elbo, nipple, longscrew, reducing socket, reducing tee, short piece etc. fitted with holder bats clamps, including cutting piles, making threads, fitting, fixing etc. complete in all respect including cost of all necessary fittings as required, jointing materials and two coats of painting with approved paint in any position above ground. (Payment will be made on the centre line measurements of total pipe line including all specials. No separate payment will be made for accessories, specials. Payment for painting will be made seperately).

For Exposed Work PVC Pipes.

15 mm dia.

For Exposed Work PVC Pipes.

Supplying, fitting and fixing pillar cock of approved make.

PTMT Pillar Cock-15 mm. (Prayag kor equivalent).

Supplying, fitting and fixing towel rail with two brackets.

C.P. over brass.

25 mm dia. and 600 mm long.

Supplying, fitting and fixing bib cock or stop cock.

PTMT (Polytetra Bib Cock / Stop Cock ( Prayag or equivalent)15 mm

Supplying, fitting and fixing stainless steel sink complete with waste fittings and two coats of painting of C.I. brackets.

Sink only.

530mm x 430mm x 180mm.

Wash basin white vitreous china of approved make (without fittings) supplied, fitted and fixed in position on 75mm X 75mm X 75mm wood blocks and C.I. Brackets including two coats of painting of C.I. Brackets.

450 mm x 300 mm size.

Please Enable Macros to View BoQ information