Welding of Poles

Amount

Digging of Proper size of pit for following work of damaged steel support with the provision of temporary support:- Then reinforcement fosteel support by welding of 04 Nos. 2 feetlong M.S. Angle iron of 5x50x6 mm. at equal distance around each pole/rail & also welding of these angle iron with each other by providing M.S. flat of size35x6 mm. in round. After this construction of round plinth of pole will be done with cement, sand and concrete in 1:3:6 ration of size 450 mm. dia & 600 mm height (300 mm. under the ground + 300 mm the ground.). The plinth should be plastered with 1/2 inch. thick cement and sand of ratio 4:4 & taper rounding the upper most part of the plinth. The rate will include all cost of material, labour and T&P etc. for completion of the above work which will be provided by the contractor at his own cost.

Construction of around plinth around the S.T Poles// Rs joist/Rail will be done with ement, sand and concrete in 1:3:6 ration of size 450 mm. dia & 600 mm height (300 mm. under the ground the ground + 300 mm. the ground). The plinth should be plastered with 1/2 inch. thck cement and sand of ration 1:4 & taper rounding the upper most part of the plinth. The rate will include all cost of material labour and T&P contractor at his own cost.

M/S Kamaruddin Electricals