MAINT/SOPD-G/2025-26/16

i) SPT Bridge No.3/1 on Suapata Pt-IV to Suapata Pt-V Road : Heavy dressing of the existing road including dressing high spots and filling low spots, cambering, watering, rolling with 8 to 10 tonne roller to obtain a specified compaction etc. to obtain a uniform formation surface with cross fall from the road centre line to the outer shoulder edge with allowance, made for required quantity of shoulder materials to remain in place to contain the new gravel layer. Works to be carried out in accordance with Technical Specification and as directed by the Engineer.

Construction of embankment with approved material obtained from borrow pits with a lift upto 1.5 m, transporting to site, spreading, grading to required slope and compacting to meet requirement of Tables 300.1 and 300.2 with a lead upto 1000 m as per Technical Specification Clause 301.5 (ii) From Private Land

Construction of subgrade and earthen shoulders with approved material obtained from borrow pits with all lifts and leads, transporting to site, spreading, grading to required slope and compacted to meet requirement of Table 300.2 with lead upto 1000 m as per Technical Specification Clause 303.1. (ii) From Private Land

Construction of granular surface course by providing well graded material, spreading in uniform layers with motor grader on prepared surface, mixing by mix in place method with rotavator at OMC, and compacting with three wheel 80-100 kN static roller capacity to achieve the desired density, complete as per Technical Specification Clause 402

Supplying and driving timber piles of 25cm to 30cm diameter, dressed to heart wood including making length in every 30 cm interval, coal tarring two (2) coats with best tar applied hot (Rate inclusive of the cost of the required quantity of tar.) (i) Portion of pile actually driven under ground.

Supplying and driving timber piles of 25cm to 30cm diameter, dressed to heart wood including making length in every 30 cm interval, coal tarring two (2) coats with best tar applied hot (Rate inclusive of the cost of the required quantity of tar.) (ii) Portion of pile remaining above ground.

Scarfing and joining piles 25 cm to 30 cm diameter, dressed to heartwood of 90 cm in length includng supplying, fitting and fixing with 2 nos. of 50mm x 10mm MS FI clamps and 16 mm dia MS bolts and nuts etc. complete as directed. (Timber for piles and coal tarring shall be measured and paid separately.)

Labour for making and fitting MS F.I. Straps and cleats etc. in position including drilling holes complete with all lead and lifts from PWD Godown.

Supplying, fitting and fixing timber beam and bearing beam rectangular in size fitted with M.S. etc. supplying spikes etc. as necessary and coal tarring two (2) coats with best tar applied hot as directed (Rate inclusive of cost of the required quantity of tar) a) Using Sal timber

Supplying fitting and fixing "U" shaped flat iron strap making 0.5m x 0.3m size from 150mm x 12mm size MS flat including providing 10 bolts holes and fitting with 0.35m long 20mm dia MS bolts including fitting tightly with bearing beam, pile and RSJ beams etc. complete as directed.