Extension/Modification of Assembly Shop towards NBS Phosphating Plant area in NBS section inside factory at Ordnance Factory Bhusawal.

Amount

WORK-Extension/Modification of Assembly Shop towards NBS Phosphating Plant area in NBS section inside factory at Ordnance Factory Bhusawal

Excavating over areas, n. exc 1.5m deep and getting out Hard/dense soil; And disposal of debris exc. 1.5 km and n. exc. 5 km as directed

Excavation in trenches, n exc. 1.5 m wide & n exC. 1.5 m in depth for foundation etc or for shafts, wells ,cesspits, manholes, etc n exc 10 sqm on plan and exc 1.5 in depth |beyond the first 1.5 mm & getting out in hard soil. And disposal of debris exC, 1.5 km an n. exc.5 km as directed

Moorum/red bajri filling in floors or pavings, laid in layers n exc. 15 cm thick, spread, levelled and rammed including watering

Hardcore of guage N exc 63mm deposited, spread and levelled in layers n,exc. 15 cm thick watered and rolled/rammed to a true surface M & L broken stone or boulders.

Shingle filling in floors or pavings, laid in layers n exc. 15 cm thick, spread, levelled, and blinded with earth and rammed including watering M & L

Cement concrete in foundations, filling and mass concrete Type C2 1:3.6(40mm graded aggregate), M & L

Cement concrete in foundations, filling and mass Concrete Type B2 1:2:4 (40mm graded aggregate), M & L

Formwork to sides of concrete foundations, footings bases of columns, raft and raft beams. sides and soffits (if any) of foundation and plinth beams; and similar work: vertical or to batter Rough finished surfaces of concrete flat

RCC nominal mix in Foundations, including rafts, footings, foundation beams; plinth beams: bases for columns, etc; basement slabs, under-reamed piles and mass concrete. Cement concrete Type B0 (12.5 mm graded aggregates), M&L

Supply and fixing deformed MS reinforcement 10 mm dia and over cut to length bent to shape and binding with wire annealed not less than 0.90 mm dia. TMT bars.

Supply and fixing deformed MS reinforcement 6-8 mm dia cut to length bent to shape and binding with wire annealed not less than 0.90 mm dia. TMT bars.

S&Fplates (plain or chequered) channels,square cut or notched (ordinary and sunk) counter forming holes, without any attachment Fe 410-W (Gde-E-250) Quality-B.

S&F structural steel in joist ,channel, angle, or tee sections, fixed independently, without connecting plates, etc Fe 410-W (Gde-E-250) Quality-A.

Structural steel work in Roof truSses (framed), trussed, purlins, crane gantries, rails and |fastenings and heavy bracket framing (Beam, tee. angle, channel or flat sections) including distance pieces. cleats etc. Fe 410-W (Gde-E-250) Quality-A... M&L

Pre- painted galvatume aluminum zinc coating Gi based corrugated steel sheet O.50mm thick of any colour having tensile strength of 550 Mpa as in roof covering/cladding to wall, fixed with self tapping screws as specified

S&F fibre glass reinforced translucent corrugated sheeting with two corrugations side |lap fixed with coach screw and washer in roof wall etc.etc.

Preparation of new surfaces of steel and application of one coat of red oxide zinc chromate primer and two coats of synthetic enamel painting.

Cutting grooves in brick wal, 75mm wide and 65mm deep and shaping horizontal face of groove with cement mortar 1:3

Meena Construction

devdas pawar