Construction of P-Way Store Shed At Verna, Madgaon, Karwar, Bhatkal And Surathkal Under SrREN/KAWR Section

2.31 Clearing jungle including uprooting of rank vegetation, grass, brush wood, trees and saplings of girth up to 30cm measured at a height of 1m above ground level and removal of rubbish up to a distance of 50m outside the periphery of the area cleared.

2.8.1 Earth work in excavation by mechanical means (Hydraulic excavator)/ manual 03 means in foundation trenches or drains (not exceeding 1.5m in width or 10 sqm on plan), including dressing of sides and ramming of bottoms,lift upto1.5m including getting out the excavated soil and disposal of surplus excavation soil as directed, within a lead of 50m All kinds of soils

2.25 A Excavation, Supplying and filling of local earth (including royalty) by mechanical transport upto a lead of 5km also including ramming and watering of the earth in layers not exceeding 20cm in trenches, plinth, sides of foundation etc. complete.

2 3 .5 Supplying, filling, spreding & leveling stone boulders of size range 5cm to 20cm,in recharge pit, in the required thickness for all leads & lifts all complete as per direction of engineers- in-charge.

4.1 Providing and lying in position cement concrete of specified grade excluding the cost of centering and shuttering -All work up to Plinth level

10.2 Structural steel work riveted, bolted or welded in built up sections, trusses and framed work, including cuting, hoistng, fixing in position and applying a priming coat of approved steel primer all complete.

12.50 Providing and fixing precoated galvanised iron profile sheets (size, shape and pitch of corrugation as approved by Engineer-in-charge) 0.50 mm (+ 0.05 %) total coated thickness with zinc coating 120 grams per sqm as per IS: 277, in 240 mpa steel grade, 5-7 microns epoxy 09 primer on both side of the sheet and polyester top coat 15- 18 microns. Sheet should have protective guard film of 25 microns minimum to avoid scratches during transportation and should be supplied in single length upto 12 metre or as desired by Engineerin-charge. The sheet shall be fixed using self drilling /self tapping screws of size (5.5x 55 mm) with EPDM seal, complete upto any pitch in horizontal/ vertical or curved surfaces, excluding the cost of purlins, rafters and trusses and including cutting to size and shape wherever required.

10.5.1 Providing and fixing 1mm thick M.S. sheet door with frame of 40x40x6 mm 10 angle iron and 3 mm M.S. gusset plates at the junctions and corners, all necessary fittings complete, including applying a priming coat of approved steel primer. Using M.S. angels 40x40x6 mm for diagonal braces

12.51.1 Providing and fixing precoated galvanised steel sheet roofing accessories 11 0.50 mm (+0.05 %) total coated thickness, Zinc coating 120 grams per sqm as per IS: 277, in 240 mpa steel grade, 5-7 microns epoxy primer on both side of the sheet and polyester top coat 15-18 microns using self drilling/ self tapping screws complete : Ridges plain (500 - 600mm)

13.1.1 12 mm cement plaster of mix : 1:4 (1 cement: 4 fine sand)

13.44.1 Finishing walls with water proofing cement paint of required shade : New work (Two or more coats applied @ 3.84 kg/10 sqm)

13@46>46@1 Painting with synthetic enamel paint of approved brand and manufacture of required colour to give an even shade : Two or more coats on new work over an under coat of suitable shade with ordinary paint of approved brand and manufacture

7.1.1 Random rubble masonry with hard stone in foundation and plinth including levelling up with cement concrete 1:6:12 (1 cement : 6 coarse sand : 12 graded stone aggregate 20 mm nominal size) upto plinth level with Cement mortar 1:6 (1 cement : 6 coarse sand)

4 .1 0 Providing and laying damp-proof course 40mm thick with cement concrete concrete 1:2:4 (1 cement : 2 coarse sand (zone-III) derived from natural sources : 4 graded stone aggregate 12.5mm nominal size derived from natural sources)

4.7.1 Providing and fixing up to floor five level precast cement concrete solid block, 17 including hoisting and setting in position with cement mortar 1:3 (1 cement : 3 coarse sand), cost of required centering, shuttering complete : 1:1½:3 (1 Cement: 1½ coarse sand(zone-III) derived from natural sources : 3 graded stone aggregate 20 mm nominal size derived from natural sources).

13.42.1 Distempering with 1st quality acrylic distemper (ready mixed) having VOC content less than 50 gms/litre, of approved manufacturer, of required shade and colour complete, as per manufacturer's specification Two or more coats on new work

Item Breakup - 01-SCHEDULE

2.33.1 Beyond 30cm girth up to and including 60cm Each girth.

2.33.2 Beyond 60cm girth up to and including 120cm Each girth. Total 42023.20 4.1 Providing and lying in position cement concrete of specified grade excluding the cost of Item- 07 centering and shuttering -All work up to Plinth level S No. Item Description of Item Unit Qty Rate Amount No

4.1.6 1:3:6 (1 cement 3 coarse sand (zone- III) : 6 cum graded stone aggregate 40 mm nominal size)

4.1.4 1:2:4 ( 1 cement : 2 coarse sand (zone- III) cum derived from natural sources : 4 graded stone aggregate 40mm nominal size derived from natural sources Total 404556.70