PROVISIONING OF DEFICIENT AIR CONDITIONERS AT VARIOUS LOCTION CONTROLLED ACCESS GATE AT SENTRY POST ON THE ROAD LEADING DIRECTLY TO PEB4 HARD STAND AT AKASHGANGA NEAR B BLOCK FOR MULTI PURPOSE ACTIVITIES PERMANENT SUPPLY OF ELECTRICITY IN RESS NO 3 4

Amount

Supply and fix Air cooled split unit Air Conditioner electric driven single phase of capacity 2.0 TR with copper condenser coil and evaporator coil, green gas R32, mounting stand with all accessories 5 star rated inverter AC all as specified and as directed. Make:- Panasonic/DAIKIN/Mistubushi/O General

Supply and fix Air cooled split unit Air Conditioner electric driven single phase of capacity 1.5 TR with copper condenser coil and evaporator coil, green gas R32, mounting stand with all accessories 5 star rated inverter AC all as specified and as directed. Make:-Panasonic/DAIKIN/Mistubushi/O General Note for SL NO. 1.00 and 2.00 The rate quoted be the tenderer shall inclusive of the following provisions :- (i) UPVC drain pipe not less than 20 mm dia from indoor unit (any floor) to upto ground level/near to drain to be fixed with proper size base plate with clamps complete. (ii) Copper pipe 20mm dia and 15 mm dia with 20SWG thickness refrigerant piping with 19 mm thick closed cell rubber nitrile, Class "O"- arm-flex insulation and including connection and extra length of coppper wire and tubing as per site requirement to be included in the quated rate. (ili) GI powder coated brackets 16 SWG of required size : 02 Nos including grouting with suitable size fastners, bush etc for fixing of outdoor units as per site requirment. (iv) If any extra legth of suction and delivery Copper pipes, drainage pipe and connection flexible cable (4 sq mm 3 core) is required at site up to 3 mtr. (v) After completion of installation of ACs, the MES No and SM stickers are to be pasted over the indoor and outdoor units of AC as per direction of Engr-in-Charge.

S &F Copper tube with insulation for suction and discharge line (same size as the AC installed as above Sl No.1 & 2) for connection between indoor and outdoor unit (beyound 3 mtr) complete all as specified and as directed.

S & F 3 core 4 Sq mm muti stranded copper conductor cable for connection between indoor and outdoor unit (beyound 3 mtr) complete all as specified and as directed..

Supply & Installation Voltage Stabilizer for automatic operation single phase natural air cooled indoor type and designed for input variation between 90 Volt to 300 volt with output voltage stabilized at 230 volt with accuracy +/- 2.5% and capacity 5 KVA or 15 Ampre complete all as specified and as directed.

Supply & Installation Voltage Stabilizer for automatic operation single phase natural air cooled indoor type and designed for input variation between 90 Volt to 300 volt with output voltage stabilized at 230 volt with accuracy +/- 2.5% and capacity 4 KVA or 12 Apmere complete all as specified and as directed.

&F Sheet metal enclosure single pole and neutral with a two pin and earth, plug top and socket complete with one single pole MCB of capacity 32 A complete all as specified and as directed.

S&F Sheet metal enclosure single pole and neutral with a two pin and earth, plug top and socket complete with one single pole MCB of capacity 20 A complete all as specified and as directed.

Material and labour for Sub main wiring with two run single core 6 sqmm and one run single core 6 sqmm ass earth wire with multi stranded copper conductor PVC insulated unsheathed FRLS cable 1100 volts grade confirming to IS-694 continuity conductor drawn into and including non-metallic rigid PVC conduit not less than 25 mm dia concealed wiring through wall/ceiling/floor/roof etc including conduit accessories including taking down old sub main wiring with PVC conduit and taken as credit complete all as specified and as directed.

Material and labour for Sub main wiring with two run single core 4 sqmm and one run single core 4 sqmm ass earth wire with multi stranded copper conductor PVC insulated unsheathed FRLS cable 1100 volts grade confirming to IS-694 continuity conductor drawn into and including non-metallic rigid PVC conduit not less than 25 mm dia concealed wiring through wall/ceiling/floor/roof etc including conduit accessories including taking down old sub main wiring with PVC conduit and taken as credit complete all as specified and as directed. Notes: (For Sub main Wiring Item No. 9 & 10) (i) The disturbed surfaces shall be made good with existing surface including matching with existing paint as applicale. (i) Three different color wires shall be used for phase, neutral and earth . (iii) Connections of cables with MCBs or bus bars shall be done through appropriate size brass/ copper thimbles .

M&L for Cutting chases on brick walls/ concrete surfaces not exc 10 cm girth and making good in cement mortar (1:3) the existing surface after carryiing out the concealed wiring and making good disturbed surfaces matching with existing paint complete all as specified and as directed

Supply, laying & testing cable XLPE insulated, screened, PVC bedded, galvanized steel strip or wire armoured, electric power cables (heavy duty)with stranded aluminium conductor, 11000 volts grade, of 35 sqmm 3.5core complete including fixing and termination of both end with existing flameproof TPN DB and feeder pillar DB/Busbsr box fixed at RESS Hanger complete all as specified and as directed.

Excavation in trenchesfor n. exc 1.5 m wide and n. exc 1.5 m in depth for taking up / laying cable/pole foundation etc and getting out for soft/loose soil complete all as specified and directed.

Spreading riddled earth for low thermal resistivity UG cable cushioning complete all as specified and directed

Supply and lay standard size common burnt clay building bricks sub class 'B' for cable protection, laid dry complete all as specified and directed.

Returning, filling in, including spreading, levelling, watering and well ramming in layers not exc 25cm for soft/loose soil ccomplete all as specified and as directed.

Removing excavated material n.exc 50m and depositing where directed at a level n.exc 1.5 m above the starting point complete all as specified and as directed .

M&L for cutting of Hardstanding for passes cablle through GI tube complete all as specified and directed.

Material and labour for PCC for cutting of hardstanding where ever necessary, 1:3:6 type C-1 (Using 20mm graded stone aggregate) including dismantling old existing any size complete all as specified and as directed

Supply and lay pipe galvanised iron tubing light grade of 40 mm dia in trenches/under road or floor/on wall / near pole/panel etc all as per site requirement complete all as specified and directed.

Earthing of machinery/equipment installed at power house/substation using 32x6 mm galvanized plate of size 600x600x6 mm as earth electrode. complete all as specified and as directed .

S&F for Bollard crompton twister IP65 10 watt CDL complete all as specified and as directed

S&F PVC junction box for bollard complete with TPN connector nut bolt clamp complete all as specified and as directed

S&F PVC round cable 2.5 sqmm 3 core complete all as specified and directed

Supply,laying XLPE insulated, screen, PVC bedded, galvanised steel strip or wire armoured, electric power cables (heavy duty) with aluminium conductor of size 10 sqmm 4 core, connecting with proper size Aluminium lugs, glands whereever necessary near LT Panels / Bus bar chamber panel / all as per site requirement , testing complete all as specified and directed.

Rigid non-metallic PVC conduit 40 mm dia exclusive of boxes (junction/ terminal) but inclusive of all tees, bends, elbows, reducers, bell mouth tube ends and fixing accessories such as couplers, lock nuts, saddles, pipe hooks etc complete all as specified and as directed.

Supply and fixing post top lantern LED type 40 watt 230 watt volts AC outdoor type with decorative post top for 360 degree indirect light IP 65 protection with impact and corrosion resistant complete with driver and lamp complete all as specified and as directed.

Supply and fixing LED flood light 70 watt 230 V AC outdoor type with thermal management in multiple optics and equipped with IP66 protection, with impact and corrosion resistant complete with driver and lamp (Flood light for parking roof top) complete all as specified and as directed.

Supply and fixing LED street light fitting 60 Watt 230 V AC outdoor type with high pressure die cast aluminum hosing and heat resistant complete with driver, lamp bracket with impact and corrosion resistant including thermal management in multiple optics complete with IP 65/66 protection (Street light near washing bay) complete all as specified and as directed.

Supply, Fixing and Testing Powder coated Outdoor street light control box of size not less than 300 x 200 x 80 mm CRCA 3 mm thick IP 65 fabricated by CPRI certified panel manufacturer including suitable terminal TPN 10 KA SMC Connector ( for 3 Phase Cable Line IN & OUT) and provision of dimrail for mounting 3 Nos MCB SP including S&F 01 No MCB 10 A SP C curve , canopy weather proof, hinged door with allen key locking arrangement for fixing on PCC / Steel Poles in and including necessary MS Clamps - 02 Nos of size 300mmx25mmx5mm shape and size with nut, bolts and washers as per site requirement for wall/pole complete all as specified and directed

Supply,laying XLPE insulated, screen, PVC bedded, galvanised steel strip or wire armoured, electric power cables (heavy duty) with aluminium conductor of size 16 sqmm 4 core, connecting with proper size Aluminium lugs, glands whereever necessary near LT Panels / Bus bar chamber panel / all as per site requirement , testing complete all as specified and directed.

Supply and lay pipe galvanised iron tubing light grade of 50mm dia in trenches / under road or floor /on wall / near pole / panel etc., including taking out the corroded old pipe complete all as specified and as directed.

Material and labour for cutting of PCC/ bituminous road for laying of pipe / cables n. exc 1.5m wide and n. exc 1.5m deep including refilling with material and watering well ramming compacting and making good with PCC 1:3:6 type B1 suitable thick complete all as specified and directed. Note-PCC shall measured and paid separately under relevant itemof schedule.

PCC (1:3:6) type M-10 using 20 mm graded aggregrate for making good the disturbed surface complete all as specified and as directed.

Rigid non-metallic PVC conduit 25 mm dia exclusive of boxes (junction/ terminal) but inclusive of all tees, bends, elbows, reducers, bell mouth tube ends and fixing accessories such as couplers, lock nuts, saddles, pipe hooks etc complete all as specified and as directed.

Supply and fixing LED flood light 100 watt 230 V AC outdoor type with thermal management in multiple optics and equipped with IP66 protection, with impact and corrosion resistant complete with driver and lamp including additional clamp& bracket for fixing on pole of existing dia (Flood light for fixed on pole) complete all as specified and as directed.

Surface dressing n exc 15 cm deep complete all as specified and as directed

Material and labour for plain cement concrete type D-2, 1:4:8 (Using 40mm graded stone aggregates) as in foundations, filling and mass concrete complete all as specified and as directed

Material and labour for old size brick work with sub class 'B' bricks straight or curved on plan exc 6m mean redius built in CM 1:4 complete all as specified and as directed

Material and labour for cement concrete type B-0, 1:2:4 (Using 12.5 mm graded stone aggregates) for edging/coping complete all as specified and as directed

Material and labour for hardcore of gauge not exc 63mm, deposited, spread and levelled in layers not exc 15cm thick, watered and rammed to a true surface complete all as specified and as directed

Material and labour for plain cement concrete bond stones type B1 1:2:4 (using 20 mm graded stone aggregate) complete all as specified and as directed.

Material and labour for 10mm thick rendering in CM 1:4 on fair faces of brick work or concrete surface including finished even and fair without using extra cement complete all as specified and as directed

Material and labour for three coat white wash on newly plastered surfaces of wall including preparation of surface complete all as specified and as directed

Reinforced cement concrete (nominal mix) Type A-1 1:1.5 :3 (using 20mm graded Aggregate) in Foundations, including rafts, footings, foundation beams; plinth beams; bases for columns, etc.; complete all as specified and as directed.

All as per item No 45.00 above but in coloumns, pillars etc.

Formwork to side of concrete foundation,footing,basesof column raft and raft beams, side and soffits (if any)of foundation and plinth beams and similar work;vertical or to batter rougth finished surface of concrete complete all as specified and as directed .

Formwork to side of pillars,posts.struts,piers,column and stsnchions finished surfaces of concrete square,rectangular or polygonal complete all as specified and as directed

M&L Mild steel TMT bars 10mm dia and over, cut to length, bent to shape required, including cranking, bending spirally for hooping for columns, hooking ends and binding with and including mild steel wire (annealed) not less than 0.9mm dia or securing with clips complete all as specified and as directed

All as per item No 49 but 5mm dia and over upto and including 10mm dia in stirrups, spacers and binders complete all as specified and as directed.

S & F Framed work as in doors or gates of angle or other sectionwith gusset plates, rails, braces, etc., complete, drilled for fixing of steel sheeting or other covering. Doors, etc. to be prepared for hanging or sliding with and including either hooks and hinges or steel hanging door fittings (exclusive of steel sheeting or other covering, running rails and guides) and hanging; also fastening and fixing complete Fe 410 -W (GdeE- 250) quality - A. complete all as specified and as directed.

M &L for rendering 15 mm thick on other than fair faces of brick work or concrete surfaces in cement mortar 1:4 complete all as specified and as directed.

M&L preparing new surface on walls and applying 2 coats of cement paint over one coat of primer on external walls complete all as specified and as directed

Material and labour for preparation of new steel surfaces of any description exc 10cm width (or) girth and applying two coats of synthetic enamel paint over one coat of red oxide primer complete all as specified and as directed

M & L 20 mm thick Granite (of any type) work (table rubbed and polished) in steps, jambs, pillars, window-cills, cooking platforms and like in cement mortar (1:4) including pointing in white cement (1:2) using marble dust with admixture of pigment to match with shade of granite complete all as specified and as directed .

Demolition of brick work built in CM including all quoin arches etc complete all as specified and as directed .

Dismantling wrought iron or mild steel work of any description not otherwise provided for complete all as specified and as directed.

RK ENTERPRISES (BID ID -3186167)

rc enterprises (BID ID -3185925)

C SRINIVASAN (BID ID -3185835)

VKR ENTERPRISES (BID ID -3185967)