Bifurcation of 11 kv feeder

Amount

Shifting & loading of following materials on private truck at store centreMaharajganj & carriage up to 33/11 KV Sub-Station Sonauli Distt-Maharajganj to work site & Un-loading of the same with proper stacking (Distance about 0 to 85 km)

(i) 11 KV Switchgear O/G Panel.

(ii) 11 KV Cable XLPE 3x185 mm2

(iii)P.C.C Pole 8.5 Mtr. Long

(iv)S.T. Pole 11 Mtr. Long

(v) Petty (i.e.x-arm,pin with insulator.disc insulator stock materials with fitting etc).

(vi)ACSR Weasel Conductor

Erection of single pole 8.5 Mtr.Long PCC pole & mounting of all its accessories etc.complete work.

Erection of single pole on 11 Mtr.Long S.T. pole & mounting of all its accessories etc.complete work.

Erection of Double pole 8.5 Mtr.Long PCC pole & mounting of all its accessories etc.complete work.

Erection of Double Pole On ST. Pole 11 M long mounting of all its accessories etc.complete work.

Stringing of ACSR Weasel conductor inclouding laying & mounting of conductor,sagging & binding properly.

Making of Sectional T-off Pole with all fitting complete work.

Shifting of 11 KV Switchgear to control room & placing in control room with grouting of bolts & mounting of switchgear pannels properly.

Electrical connection of 11 KV Switchgear pannel & fitting of Bus Bar, Battery & battery Charger & P.T

Testing of 11 KV Switchgear pannel in all respect.

Earthing of 11 KV Switchgear panel at one side by control room properly.

Laying of 11 KV "XLPE" cable including digging of pits of size 0.5x0.5 Mtr. Covering of cable with sand & brick arround and Top of the cable.

Cable jointing charges of 11 KV XLPE Cable.

Hanging/laying of 11 KV XLPE cable air after providing 4" dia M.S. Pipe 3 Mtrs long after mounting of 11 KV cable boxes at double pole of Cable on Double Pole

Extra work for separation of Circuit i.e. Shiffiting the Existing Line from Vertical to Horizontal (By opening the winding from insulator and re-sagging the conductor from Vertical to Horizontal

Cutting of tree branches/bamoos in the path of 11 KV line to get adequate clearance from conductor.

Painting of S.T.Pole with red oxide and alluminium paint(Two coat)

Groutings of stays complete in ratio 1:4:8 (cement:sand:brickballast).

Earthing of support complete.

Guarding of Road /11 KV /L.T.Line crossing.

Making plinth for poles 20 cms above ground level of size 30 cms. In ratio1:4:8(Cement:Sand:Brick:ballast).

Providing following S/s Materials

Rubber Mat 2m x 1m x 12mm thick Black/Red Colour

Hand Gloves (Suitable for 33 KV)

m/s tripathi brothers

VIJAY SHUKLA