ADDITION / ALTERATION AND SPECIAL REPAIRS TO CERTAIN MD ACCN AT SUKNA MIL STATION UNDER GE SUKNA

Taking down chowkats or frames exc 1.5sqm and not exc 4.0 sqm each with shutters ( without taking off shutters from the frame ) complete all as specified and as directed.

Taking down chowkats or frames not exc 1.5sqm each with shutters( without taking off shutters from the frame ) complete all as specified and as directed.

S&F 125X60mm size pressed steel door frames of doors with one or more rebates including necessary fixing lugs, hinges lock strike plate, etc complete all as specified and as directed.

S&F 105X60mm size pressed steel door frames of doors with one or more rebates including necessary fixing lugs, hinges lock strike plate, etc complete all as specified and as directed.

S & F 30mm thick factorymade flush shutters, solid core construction, with block board core and plywood face panels, commercial type on both sides and covered on both side with 6mm thick decorative face veneer with lipping/frame to match complete all as specified and directed.

S&F factory made wire guazed (panel will be wire guazed in lieu of plain PVC sheet) PVC door shutter 30 mm thick (style) consisting of frame made out of M.S. tubes for top rails, bottom rails stiles & lock rail. MS frame shall be covered with heat moulded plain colour PVC ‘C’ channel having a PVC sheet strip of 20 mm width stuck inside with solvent cement for stiles and plain colour PVC sheets for top rail, lock rail & bottom rail on either side & as gap insert for top rail & bottom rail. The wire gauze shall be wrapped on an additional square 8 mm MS Solid tube and this tube shall be welded to MS tubes. The wire gauge shall be stretched to tighten firmly complete all as specified and directed. Note:- Wire cloth / wire mesh shall be measured seperately

S&F Powder coated aluminium (minimum thickness of powder coating 50 micron) work for doors, windows, ventilators and partitions (Fixed portions) with extruded built up standard tubular sections/ appropriate Z sections and other sections of approved make conforming to IS:733 and IS:1285, fixing with dash fasteners of required dia and size, including necessary filling up the gaps at junctions, i.e. at top, bottom and sides with required EPDM rubber/ neoprene gasket etc. Aluminium sections shall be smooth, rust free, straight, mitred and jointed mechanically wherever required including cleat angle, Aluminium snap beading for glazing/ paneling, C.P. brass/ stainless steel screws, all complete as per architectural drawings all as specified and directed.

S&F Powder coated aluminium (minimum thickness of powder coating 50 micron) for shutters of doors, windows & ventilators including providing and fixing hinges/ pivots and making provision for fixing of fittings wherever required including the cost of EPDM rubber/neoprene gasket required (Fittings shall be paid for separately) with extruded built up standard tubular sections/ appropriate Z sections and other sections of approved make conforming to IS: 733 and IS:1285, fixing with dash fasteners of required dia and size, including necessary filling up the gaps at junctions, i.e. at top, bottom and sides with required EPDM rubber/ neoprene gasket etc. Aluminium sections shall be smooth, rust free, straight, mitred and jointed mechanically wherever required including cleat angle, Aluminium snap beading for glazing/ paneling, C.P. brass/ stainless steel screws all complete as per architectural drawings and the directions complete all as specified and directed.

S&F 4mm thick heat absorbing glass, and glazing with beads fixed with brass screws complete all as specified and directed.

S&F 4 mm thick frosted/ pin headed glass in ventilator shutters complete all as specified and directed.