ADDN/ALTN OF PA EQPT OF OUTDATED PA OF ASHOKA AUDITORIUM AT MANEKSHAW CENTRE UNDER AGE E/M, OF GE (SOUTH) DELHI CANTT-10

Amount

Supply, Installation, testing and commissioning of 4 individual boxes or “cells” made of poly-resin material, Each cell shall have a complement of 2 x 5.5” low-frequency speakers symmetrically positioned on either side of the front baffle and each shall be flanked by bass reflex ports at the outside edge. Between the low-frequency speakers shall be a multi-slotted, high-frequency wave-guide manifold, which shall be rear-loaded with a 1” high-frequency compression driver. Connection shall be by way of both dual 2-way Speakon™ & parallel screw terminal connections on the middle cell’s rear panel. It shall be possible to adjust the vertical angle between each cell in 15 degree increments to provide a coverage angle of between 0 degrees vertically to 45 degrees vertically by changing the position of these joints. It shall also be possible to extend the angle to 60 degrees with an optional extender bracket. The horizontal angle shall be fixed at 100 degrees. The speaker shall be capable of true line array-type projection with consistent front-back room coverage. Each unit shall be deliver a sound pressure of 100dB with 1W of input measured at 1m distance and be capable of maximum power handling up to 750 watts continuous program with a rated impedance of 8 Ohms. The frequency response of the speaker shall be 75Hz-20kHz. including all accessories as required for proper functioning of above item and taking down old accessories etc. complete all as specified and as directed. Make : TOA/JBL/EV

Supply, Installation, testing and commissioning of compatible sub-woofer enclosure designed to extend the frequency response of the speaker system down to 40Hz. The subwoofer enclosure shall be a bass-reflex type constructed of MDF wood and it shall be front-loaded with a 15” low-frequency speaker and shall be covered by a perforated steel grille. The cabinet shall have recessed handles on either side to allow easy transport. The connections shall be on a recessed rear panel and consist of both dual 2-way Speakon™ & parallel screw terminals. The sub enclosure shall measure 505 mm W x 528 mm H x 477 mm D including all accessories as required for proper functioning of above item and taking down old accessories etc. complete all as specified and as directed. Make : TOA/JBL/EV

Supply, Installation, testing and commissioning of compatible sub-woofer enclosure designed to extend the frequency response of the speaker system down to 40Hz. The subwoofer enclosure shall be a bass-reflex type constructed of MDF wood and it shall be front-loaded with a 15” low-frequency speaker and shall be covered by a perforated steel grille. The cabinet shall have recessed handles on either side to allow easy transport. The connections shall be on a recessed rear panel and consist of both dual 2-way Speakon™ & parallel screw terminals. The sub enclosure shall measure 505 mm W x 528 mm H x 477 mm D. including all accessories as required for proper functioning of above item complete all as specified and as directed. Make : TOA/JBL/EV

Supply, Installation, testing and commissioning of steel rigging frame with multiple fly points for flying one or more (up to four) line array speaker in a vertical array along with seating for and subwoofer to be placed on top of the frame. including all accessories as required for proper functioning of above item complete all as specified and as directed. Make : TOA/JBL/EV

Supply, Installation, testing and commissioning of Compact two-way speaker systems designed for high efficiency, wide range, and high power input handling capability. Compact wide-dispersion speaker Up to 180 W continuous program (F-2000B / F-2000W) Dispersion angle of 110° x 100° Easily mountable 80° x 80° horn adapter for increased dispersion control included 2-way speaker with high quality 20 cm woofer and balanced dome tweeter Paintable including all accessories as required for proper functioning of above item and taking down old accessories etc. complete all as specified and as directed. Make : TOA/JBL/EV

Supply, Installation, testing and commissioning of two-way speaker with a sealed box enclosure with polypropylene and a protective punched front grill with a surface-treated steel plate. The continuous pink noise shall be 100 W at 8 ohms and continuous program power rating of 300 W at 8 ohms. The speaker shall feature a 38 cm (15”) woofer and a 6-balanced-dome tweeters array with a 90° x 40° dispersion. Frequency response shall be 70 to 20k Hz, with crossover at 3k Hz. Sensitivity shall be rated at 98 dB (1 W, 1 m). The speaker system shall be designed for both fixed installation uses and on-the-road and shall be capable of being easily carried with an accessory handle. Its built-in overload protection circuitry for tweeter shall cut off a signal when an excessive input signal is received. Input connections shall be via a speakon connector or screw terminal. including all accessories as required for proper functioning of above item complete all as specified and as directed. Make : TOA/JBL/EV

Supply, Installation, testing and commissioning of two-way bass reflex enclosure suitable for ceiling or wall mounting. The low frequency component shall be a 13 cm (5") cone-type woofer. The high frequency component shall be a 25 mm (1") dome tweeter. Up to 150 W continuous program (F-1300B / F-1300W) Dispersion angle of 110° x 100° Multiple taps (1 W, 3 W, 10 W, 30 W at 100 V and 0.5 W, 1.5 W, 5 W, 15 W, 30 W at 70 V) adjustable via the rear of the enclosure. The sensitivity at a distance of 1 m with 1 W of input level applied shall be 90 dB. The speaker shall have a frequency response from 80 to 20k Hz. including all accessories as required for proper functioning of above item complete all as specified and as directed. Make : TOA/JBL/EV

Supply, Installation, testing and commissioning of Amplifier shall operate on 220 – 240 V AC or 24 V DC power, and shall control and mix 1 balanced (screw terminal) Line in and 1 unbalanced (screw terminal) 100 V Line inputs. Outputs shall be balanced Loop out and balanced high and low impedance (floating) Speaker out. The amplifier shall meet the following performance criteria: Power output shall be 240 W at less than 1% THD (at 1 kHz, 1/3 rated power). Frequency response shall be 50 Hz to 20 kHz (+/-3 dB), with an S/N ratio of over 60 dB. Bass Tone Control shall be +/-10 dB at 100 Hz, and Treble Tone Control shall be +/-10 dB at 10 kHz. including all accessories as required for proper functioning of above item complete all as specified and as directed. Make : TOA/JBL/EV

Supply, Installation, testing and commissioning of 32-Channel Premium Mixing Console the Evolution of Analog: the verdict is in—nothing beats the warmth and musicality of analog sound. By incorporating state-of-the-art digital technologies into the development process of our premium professional analog equipment,D-PRE: igh-end recording gear, these studio-grade, discrete Class-A mic preamps employ an inverted Darlington circuit design that features multiple circuitry elements in a multi-layered configuration in order to deliver more power with lower impedance. This means all the character, depth and feel of your original signal will be delivered with fat, natural sounding bass and smooth, soaring highs. Rediscover a favourite mic or trusted instrument by capturing the full range of your musical expression with sound that you don't hear, so much as feel. With 48V phantom power for each channel and a sound that is incomparable in a compact mixer. X-pressive EQ, 1-Knob Compressors, Hybrid Channel including all accessories as required for proper functioning of above item and taking down old accessories etc. complete all as specified and as directed. 24 Mic Inputs with 48V Phantom Power and HPF per Channel 32 Line Inputs (24 mono and 4 stereo) 6 AUX Sends + 2 FX Sends 4 GROUP Buses + ST Bus 2 Matrix out 1 Mono out All complete Cable, Connector and Accessories as required. Make : Yamaha/Allen & Heath/Dynacord

Supply, Installation, testing and commissioning of Gooseneck Microphone with Tablestand:- Pick-up pattern cardioid, Transducer principle pre-polarised condenser microphone, Frequency response 50 Hz - 20 kHz, Nominal impedance < 100 Ω, Maximum sound pressure level 130 dB SPL, Phantom powering P12 - P48 V, Connectivity XLR 3M, Bi-color light ring for clear visual feedback, Switchable microphone modes, Logic port for seamless integration. including all accessories as required for proper functioning of above item complete all as specified and as directed. Make : TOA/SHURE/AUDIO TECHNICA

M&L in replacement of 2C x 4 Sq. mm Speaker Cable complete including all accessories as required for proper functioning of above item complete all as specified and as directed. Make : Polycab/Havells/Grandly/KEI/Standard

M&L in replacement of 2C x 2.5 Sq. mm Speaker Cable including all accessories as required for proper functioning of above item complete all as specified and as directed. Make : Polycab/Havells/Grandly/KEI/Standard

M&L in replacement of 18 AWG -24/0.20mm x 2 core Microphone Cable including all accessories as required for proper functioning of above item complete all as specified and as directed. Make : Polycab/Havells/Grandly/KEI/Standard

M&L in replacement of coaxial cable for wireless microphone including all accessories as required for proper functioning of above item complete all as specified and as directed. Make : Polycab/Havells/Grandly/KEI/Standard

Note :- The contract sum shall be after deducting the amount of credit shown in Sch of Credit of this tender

JINDAL ENTERPRISES