REPAIR TO SECURITY WALL, HARDSTANDING, FENCE, GATES, DRAINAGE ETC AT 515 ABW, HARRIS BK, MARSHAL BK ETC UNDER GE (SOUTH) BANGALORE

Amount

Demolition of brickwork or stone boulder masonry, built in cement mortar or cement lime mortar including all quoins, arches, pillars, etc, and precast concrete articles, staking serviceable material and removing debris outside MD land complete all as specified and directed.

Demolition of Reinforced cement concrete of any description and in any position not otherwise specifically provided for incl staking serviceable material and removing debris outside MD land complete all as specified and directed.

Demolition of cement concrete (unreinforced) in ground floors and pavings n. exc. 15 cm thickness (below or above ground level) incl staking serviceable material and removing debris outside MD land complete all as specified and directed.

M&L for cement concrete 1:4:8 type D-2 (40 mm graded stone aggregate) as in foundations, filling & mass concrete complete all as specified and directed.

M & L for Reinforced cement concrete nominal mix type B1, 1:2:4 (20 mm graded crushed stone aggregates) as in columns, pillars, piers, posts and struts complete all as specified and directed.

M & L for Reinforced cement concrete nominal mix type B1, 1:2:4 (20 mm graded crushed stone aggregates) as in beams, cantilevers, bressummers, lintels over 1.5 m span complete all as specified and directed.

M & L reinforced cement concrete 1:2:4, type B-1 (using 20 mm graded crushed stone agg) as in foundation, incl rafts, footings, foundation beams, plinth beams, bases for columns etc, basement slabs under reamed piles and mass concrete.

Formwork to sides of flat concrete foundations, footings, based of columns, rafts and raft beams, sides and soffits (if any) of foundation and plinth beams and similar work vertical or to batter.

Formwork to sides of pillars, posts, struts, piers, columns and stanchions etc Square/ Rectangular, rough finished surfaces of concrete complete all as specified and directed.

Formwork to sides and soffits of floor or roof beams, beam haunchings, girders, bressummers, lintels, cantilevers, shelves including supports, overhangs, etc. also splays between floors and beams, etc rough finished surface complete all as specified and directed.

S&F mild steel TMT bars 10 mm dia and over, cut to length, bent to shape required, incl cranking, bending spirally for hooping for columns, hooking ends and binding with and incl mild steel wire (anealed) not less than 0.9 mm dia or securing with clips complete all as specified and directed.

S&F mild steel TMT bars 5mm dia and over upto and incl 10 mm dia, cut to length, bent to shape required, incl cranking, bending spirally for hooping for in stirrups, spaces and binders and incl mild steel wire (anealed) not less than 0.9 mm dia or securing with clips complete all as specified.

M&L for Precast cement concrete type C1, 1:3:6 block masonry with solid blocks exc 10cm in width & setting in CM 1:6 complete all as specified.

M&L for Walling of random rubble, uncoursed ,well bonded, bedded and solidly hearted, built in and setting in cement mortar 1:6,Except Stone complete all as specified and directed.

M&L for providing cement concrete type B1, 1:2:4 (using 20mm graded stone aggregate) in lintels upto 1.5m clear span, cills, copings, kerbs and the like including weathering, slightly rounded or chamfered angles and throating, as directed complete all as specified and directed.

M&L for providing Broken glass coping on top of walls in cement mortar 1:3 complete all as specified and directed.

Taking down cement or cement lime plaster on brick or stone walls, etc. including raking out joints, hacking for key, scrubbing down with water, etc

M&L rendering 15 mm thick on fair faces of brick work or concrete surfaces in cement mortar 1:4 incl finished even and fair without using extra cement complete all as specified and directed.

M&L for preparation of newly plastered surfaces of walls and applying two coats of cement based paint complete all as specified and as directed.

M&L for preparation ol new plastered/unplastered surfaces of walls Finishing walls with Acrylic Smooth exterior paint of required shade two or more coat applied @ 1.67 ltr/10 sqm over and including priming coat of exterior primer applied @ 2.20 kg/10 sqm) complete all as specified and directed.

S&F mild steel hand rails, half round or other stock section or core for wooden hand-rail straight portion, drilled and countersunk for balusters running bars, for doors, balusters, nosing to steps including embeding in concrete and screwing etc, wind ties for roof including securing bolts, posts and struts in fencing including cutting tops to shape as directed, drilling holes, notching for wire, etc., flat iron fillets (for securing wire mesh etc.) including all necessary drilling bolting for riveting etc., and similar work conforming to Fe-290 Gde E-165 complete all as specified and as directed.

S & F twin wall/multi wall built, 6-8mm thick, high impact resistance, co-extruded UV layer on both sides, polycarbonate sheet of approved colour and dimension as in roof covering/cladding to walls fixed with self tapping screws including dismantling old sheeting all as specified and directed.

Demolition of Stone slabs and tiles of any description or thickness in floors, aprons etc. laid bedded and pointed in any mortar incl removal of debries out side MD land.

Dismantling of wrought iron or mild steel work of any description not otherwise provided for complete all as specified and directed.

S & F galvanised 2 strand, steel barbed wire 2.24mm dia barbed with 2mm dia barbs at 75mm spacings and straining and fixing to any type of standard rails, straining bolts, including, securing or tying at crossings with and provion of galvanised mild steel wire, staples or steel pin etc including dismantling the existing barbed wire, etc complete all as speecified and directed.

M&L for framed work as in doors or gates of angle tubes etc with gusset plates, rails, braces, etc, complete, drilled for fixing of steel sheeting or other covering. Doors, etc. to be prepared for hanging or sliding with and including either hooks and hinges or steel hanging door fittings (exclusive of steel sheeting or other covering, running rails and guides) and hanging; also fastening and fixing complete with Mild steel grad Fe 410 -W (GdeE- 250) qualityA all as specified and directed..

M&L for 20mm thick Granite (of any type ) work (table rubbed and polished) for wall lining (veneering to wall) over 12 mm thick backing coat in cement mortar (1:3) and pointing with white cement (1:2) using marble dust with admixture of pigment to match with shade of granite complete all as specified and directed.

M&L for Cement concrete type C-2, 1:3:6 (Using 40 mm graded stone aggregates) as in surface channels and drains complete all as specified.

M&L 75 mm thick cement concrete type D-2, 1:4:8 (using 40 mm graded crushed stone aggregate), as in sub base of floors complete all as specified and directed.

M&L Sand filling under floors or in foundations including watering and consolidation as sand cushioning complete all as specified and directed.

M&L Machine pressed Pre cast concrete interlocking paver block any shape and size confirming to IS 15658-2006 of 60 mm thickness M-40 grade with grey cement and pigment as in ramps/Hardstandings complete all as specified and directed.

S&F chequered cement concrete tiles 20 cm x 20 cm x 25 mm thick with grey cement and pigments, set, jointed and pointed in neat cement slurry in floors over 15 mm thick screed bed in cement mortar 1:6.

M&L for preparation of new or previously untreated steel or iron surfaces exc. 10 cm in width or girth and applying two coats of synthetic enamel paint over a coat of red oxide primer complete all as specified and as directed.

Preparation of old decorated surfaces of wall and applying one coat of cement base paint all as specified and as directed.

M&L for preparation of old decorated surfaces of walls and applying one coat of exterior emulsion paint second grade complete all as specified and as directed.

M&L preparation of old painted steel and iron surfaces of any description, over 10 cm in width or girth, not otherwise described and applying one coats of synthetic enemel paint.

ABHISHEK CONSTRUCTIONS (BID ID -3336156)

PRAGATHI BUILDERS (BID ID -3337147)

Srisrinivasaenterprises (BID ID -3332982)

Annapoorneshwari Construction (BID ID -3321489)