PROVN OF 01 TOILET WITH BATHROOM MOTIVATIONAL HALL AT ADM AREA OF 3 INF DOU 01 COMBINED TOILET BATHROOM CTB FOR LADIES OFFRS IN 14 CORPS ZONAL WKSP AREA UNDER AGE BRI OF GE 865 EWSLEH

Surface excavation n.exc (not exceeding) 30 cm deep and averaging 15cm deep and getting out in hard/dense soil, complete all as specified and as directed by Engr-in-Charge.

Excavation in trenches n.exc 1.50m wide and n.exc 1.50m in depth and getting out in hard/dense soil, complete all as specified and as directed by Engr-in-Charge.

Returning,filling in ,including spreading,levelling ,watering and well ramming in layers not exe 25cm in hard/dense soil, complete all as specified and as directed by Engr-in-Charge.

Removing excavated material n, exe 50m and depositing where directedat a level n, exe 1.5 m above the starting point, complete all as specified and as directed by Engr-in-Charge.

M&l for PCC type D-2(1:4:8) using 40mm graded crushed stone aggregate as mass conc and filling of foundation, complete all as specified and as directed by Engr-in-Charge.

M&L pre-cast cement concrete(20mm graded crushed stone aggregate) 1:3:6 type C-1 as in block masonery with solid block masonery with solid blocks,exc.10cm in width and setting in cement mortar 1:6, complete all as specified and as directed by Engr-in-Charge.

M&L for reinforced cement concrete 1:2:4, nominal mix (20 mm graded Aggregate) as in beam cantilevers, bressummers, lintels over 1.5 m span, complete all as specified and as directed by Engr-in-Charge.

M&L form work for rough finished concrete surfaces to sides and soffits of floor or roof beam ,beam haunchings ,girders, bresum-mers,lintles,cantilevers,shelves including supports ,overhanging, etc. also splays between floors and beams,etc, complete all as specified and as directed by Engr-in-Charge.

Mild steel TMT bars 10mm dia and over (for tie bar of chain link fencing), cut length, bent to shape required , including cranking , bending spirally for hooping for coloumns, hooking ends and binding with and including mild steel wire (annealed) not less than 0.9mm dia or securing with clips, complete all as specified and as directed by Engr-in-Charge.

All as per srl item No 9 above but 6 to 8mm dia as in stirups, complete all as specified and as directed by Engr-in-Charge.