Construction of Boundary Wall, Guard Room and MS Gate at Government Leather Institute Kanpur Nagar

Earth work in exacavation in foundation in ordinary soil including lift upto 1.5 m and lead upto 30m. and dressing of sides and ramming of bottom and disposal of surplus excavated earth as directed by the Engineer i/c with in a lead of 50 m.

Providing and laying in cement concrete 1:4:8 (1 cement : 4 fine sand : 8 brick aggregate 40 mm nominal size) and curing complete, including cost of form-work, in foundation and floors.

R.C.C. work with cement approved coarse sand and 2 cm (3/4") gauge approved stone ballast in the proportion 1:1.5:3 (1 cement :1.5 coarse sand : 3 aggregates) , in beam excluding supply of reinforcement and its bending the same with 24 WG binding wire and necessary centring and shuttering etc and also including supply of all materials labour and tools and plants etc. required for proper completion of the works. Strength of the concrete shall not be less than with M-20 concrete nominal mix

Mild steel or iron in plain work such as reinforced concrete or reinforced, brick work (when not included in an over all rates ) wrought to required shape as necessary including bending for proper completion of the work and including supply of steel its wastage bend hooks and authorised over lapping shall be measured upto floor two level.

Half brick masonry with common burnt clay F.P.S. (non modular) bricks of class designation 7.5 in superstructure above plinth level up to floor V level.6.13.2 Cement mortar 1:4 (1 cement :4 coarse sand)

Extra for providing and placing in position 2 Nos 6mm dia. M.S. bars at every third course of half brick masonry.

15 mm cement plaster 1:6 (1 cement : 6 fine sand)

Finishing walls with water proofing cement paint of required shade

Providing and applying white cement based putty of average thickness 1 mm, of approved brand and manufacturer, over the plastered wall surface to prepare the surface even and smooth complete.

Finishing with Epoxy paint (two or more coats) at all locations prepared and applied as per manufacturer’s specifications including appropriate priming coat, preparation of surface, etc. complete.