REPAIRS TO FENCING GATE INCLUDING THEIR PERIODICAL SERVICES AT CME

Amount

Demolition of Brick work or stone / boulder masonery built in cement mortar complete all as specified incl coping.

M & L for pre cast PCC block mosonary Type C-1 1:3:6 exc 10 cm width and set in CM 1:4 all as specified

Demolition of cement concrete (un re-inforced) in ground floor and paving n.exc. 15 cm thick below or above ground level complete all as specified .

M&L cement concrete type D-2, 1:4:8(using 40mm graded stone aggregate) as in foundation , filling and mass concrete complete all as specified and directed.

M&L 15mm thick cement plastering on concrete surfaces in CM (1:4) finishing surfaces even and fair without using extra cement complete all as specified and as directed.

M&L for prepration of newly plastered surfaces of walls and applying two coats of cement base paint over a coat of cement primer on walls etc complete all as specified and directed.

Dismantling posts or struts (wood, steel or R.C.C.) any section embeddedin concrete, including taking out embedded portion and making good disturbed ground etc. Complete all as specified and as directed.

Dismantling fencing wire mesh, any type

S&F For ms angle as in posts and struts in fencing including cutting tops to shape as directed, drilling holes, notching for wire, etc.; flat iron fillets (for securing wire mesh etc.) including all necessary drilling, bolting or riveting, etc., and similar work conforming to Fe-290 Gde E-165 etc. complete all as specified and as directed.

Supply onlyChain link MS galvanisd fencing, any size or type etc. Complete all as specified and as directed by Engr - in - charge

Fixing only chain link fencing including line wires, any mesh, size and type to any type of standards, rails, straining bolts, etc. including provission of binding wire etc. Complete all as specified and as directed.

S & F For 5 to 10 mm dia. of neck ,mild steel screw bolts (machine made) with hexagonal or square heads at one end and screwed the other, or screwed both ends, each screwed end to be fitted with washers and one hexagonal or square nut, n exc 5cm long etc. Complete

S&F For round mild steel bars 10mm dia and over, cut to length, bent to shape required, including cranking, bending spirally for hooping for columns, hooking ends and binding with and including mild steel wire (annealed) not less than 0.9mm dia or securing with clips etc. complete all as specified and as directed.

S & F For in repair galvanised. 2 strand, steel barbed wire 2.24mm dia barbed with 2mm dia barbs at 75mm spacings and straining and fixing to any type of standard rails strain- ing bolts, including, securing or tying at crossings with and provision of galvanised mild steel wire, staples or steel pins, etc. as directed (each line wire to be measured) etc. complete all as specified and as directed.

Preparation of new or previously untreated surfaces of iron of any description over 10 cm in width or girth and applying two coats of synthetic enamel paint over and including a of red oxide primer complete all as specified and directed

Preparation ofold surfaces of iron of any description over 10 cm in width or girth and applying one coat of synthetic enamel paint complete all as specified and directed

Dismantling structural steel work including doors, gates but excluding framed truss etc. Complete.

S & F For framed work as in doors or gates of angle or other section with gusset plates, rails, braces, etc., complete, drilled for fixing of steel sheeting or other covering. Doors, etc. to be prepared for hanging or sliding with and including either hooks and hinges or steel hanging door fittings (exclusive of steel sheeting or other covering, running rails and guides) and hanging; also fastening and fixing etc. complete all as specified and as directed.

Priyanka Power line (BID ID -3330928)

Sunrise Traders (BID ID -3328693)

Mukund Engineers and Contractors (BID ID -3322106)