Loading…
Loading…
| # | Company | Amount | Rank | Status |
|---|---|---|---|---|
| 1 | L1₹6.4 LAccepted-AOC 2 NO GOVT COLONY MOKDUMPUR ENGLISH BAZAR MALDA WEST BENGAL PIN 732103 | ENGLISH BAZAR | MALDA | WEST BENGAL | 732103 | ₹6.4 L | L1 | Accepted-AOC L1 |
| 2 | L2₹6.5 LRejected-Finance 69 VIVEKANANDA PALLY P S ENGLISH BAZAR P O DISTRICT MALDA PIN 732101 | MALDA | MALDA | WEST BENGAL | 732101 | ₹6.5 L | L2 | Rejected-Finance L2 |
| 3 | L3₹6.6 LRejected-Finance MALANCHA PALLY PO MOKDUMPUR DIST MALDA PIN 732103 | MALDA | MALDA | WEST BENGAL | 732103 | ₹6.6 L | L3 | Rejected-Finance L3 |
Tender Value
₹6.4 L
EMD Value
₹12,899
Closing Date
21 Jan 2026, 3:00 pmClosed
The Executive Engineer, Malda Highway Division
Singatala, Malda
Repair and Rehabilitation of Gazole Highway Sub Division Office Building under Malda Highway Division in the district of Malda. 2nd CALL
2026_SH_984407_1
WBPWRD/EEMHD/eNIT-09/2025-26/2 CALL
Open Tender
CIVIL WORKS
45 days
Malda
Please refer Tender documents.
3 documents required · 3 mandatory
₹12,899
Yes
10 Mar 2026
6 Jan 2026
27 Jan 2026
6 Jan 2026
21 Jan 2026
6 Jan 2026
Spot application for insecticides using Aqua base spray for pest (for bugs, cockroaches, silverfish, spider, termites, mosquitoes) to walls and ceiling etc. with chemical emulsion by admixing chloropyrofos emulsifiable concentrates (1% concentration) with water by weight including spraying the emulsified chemical @ 0.5 litres per sq.m. by a hand operated pressure pump on wall surfaces, ceiling, electrical fixture,electrical lines including drilling holes in places where source of termite is detected squirting chemical solution into the holes and sealing the holes with cement grout. (Rate is per sq.m. of the floor area while actual work will be all walls ceiling, rack, partition and furniture).
Stripping off worn out plaster and raking out joints of walls, celings etc. upto any height and in any floor including removing rubbish within a lead of 75m as directed.
Cleaning the concrete surface by removing dirt and debris, marking defective locations and removing loose concrete by careful stripping untill hard surface is exposed, cutting the concrete to regular shape, wire brushing the exposed surface and removing debris from site complete as per direction of the Engineer - in - Charge.
Cleaning the exposed reinforcement preferably upto full diameter by wire brush, applying two coats of polymer based rust removing compound left for 24 hours, removing the coating and then applying two (2) coats of polymer modified anti corrosive protective coating formulated to inhibit the corrosion of reinforcement as per manufacturer's specification. [Mode of measurement:The affected surface area of reinforcement shall be considered for payment]
Applying 2 coats of bonding agent with synthetic multi functional rubber emulsion having adhesive and water proofing properties by mixing with water in proportion (1 bonding agent : 4 water : 6 cement) as per Manufacturer's specification.
Polymer concrete made with water resistant bonding agent of synthetic rubber emulsion as per manufacturer's specification including the cost of cement concrete (1:1.5:3) (2.75 Kg / bag of cement).
Plaster with sand and cement mortar including rounding off or chamfering corners as directed and raking out joints including throating, nosing and drip course, scaffolding/staging where necessary (Ground floor). i) For Wall Interior Side 20 mm thk Plaster with 1 : 6 Cement Morter
ii) For wall in External Side 15 mm thk Plaster with 1 : 6 Cement Morter
iii) For Celling Interior Side 10 mm thk Plaster with 1 : 4 Cement Morter
Supplying, fitting & fixing 1st quality Ceramic tiles in walls and floors to match with the existing work & 4 nos. of key stones (10mm) fixed with araldite at the back of each tile & finishing the joints with white cement mixed with colouring oxide if required to match the colour of tiles including roughening of concrete surface, if necessary or by synthetic adhesive & grout materials etc. (B) Wall With Sand Cement Mortar (1:3) 15 mm thick & 2 mm thick cement slurry at back side of tiles using cement @ 2.91 Kg/Sq.m & joint filling using white cement slurry @ 0.20kg/Sq.m. (a) Area of each upto 0.09 Sq.m (ii) Other than Coloured decorative including white
Applying Interior grade Acrylic Primer of approved quality and brand on plastered or cencrete surface old or new surface to receive Distemper/ Acrylic emulsion paint including scraping and preparing the surface throughly, complete as per manufacturer's specification and as per direction of the EIC. (In Ground Floor) One Coat Solvent based interor grade Acrylic Primer
Applying Acrylic Emulsion Paint of approved make and brand on walls and ceiling including sand papering in intermediate coats including putty. Two Coats i) Standard Quality
Scraping of moss, blisters etc.thoroughly from exterior surface of walls necessitating the use of scraper, wire brush etc.
Applying Exterior grade Acrylic primer of approved quality and brand on plastered or cencrete surface old or new surface to receive decorative textured (matt finish) or smooth finish acrylic exterior emulsion paint including scraping and preparing the surface throughly, complete as per manufacturer's specification and as per direction of the EIC. In Ground Floor (One Coat)
Protective and Decorative Acrylic exterior emulsion paint of approved quality, as per manufacturer's specification and as per direction of Engineer-in-Charge to be applied over acrylic primer as required. The rate includes cost of material, labour, scaffolding and all incidental charges but excluding the cost of primer. In Ground Floor (Two Coat) a) Normal Acrylic Emulsion
Wood work in door and window frame fitted and fixed in position complete including a protective coat of painting at the contact surface of the frame exluding cost of concrete, Iron Butt Hinges and M.S clamps. (The quantum should be correted upto three decimals). Sishu, Gamar, Champ, Badam, Bhola, Mogra, Hallak.
Panel shutters of door and window, as per design (each panel consisting of single plank without joint), including fitting and fixing the same in position but excluding the cost of hinge and other fittings. In ground floor. (iv) 25mm thick shutters with 12mm thick panel of size 30 to 45 cm (b) Sishu, Gamar, Champ,Badam,Bhola, Mogra, Hallak
Priming one coat on timber or plastered surface with synthetic oil bound primer of approved quality including smoothening surfaces by sand papering etc.
Painting with best quality synthetic enamel paint of approved make and brand including smoothening surface by sand papering etc. including using of approved putty etc. on the surface, if necessary : (a) On timber or plastered surface : With other than hi-gloss of approved quality- (iv) Two coats (with any shade except white)
Painting with best quality synthetic enamel paint of approved make and brand including smoothening surface by sand papering etc. including using of approved putty etc. on the surface, if necessary : (b) On steel or other metal surface : With other than hi-gloss of approved quality- (iv) Two coats (with any shade except white)
Renewing M.S. clamps for door and window frame made of flat bent bar 40mm X 6mm, 200mm Length etc.
Iron parliamentary hinges conforming to IS 362-1982 fitted and fixed complete with steel screws. (a) 50mm. X 100mm. X 20mm. X 2.24mm.
Iron hasp bolt of approved quality fitted and fixed complete (oxidised) with 16mm dia rod with centre bplt and round fitting 250mm long etc.
Iron door handle of approved quality fitted and fixed complete: 150mm x 5.5 mm.
Iron socket bolt of approved quality fitted and fixed complete (c) 150mm long x 10mm dia bolt
Add GST @18 %
Add Labour Welfare Cess @1%
Please Enable Macros to View BoQ information
stage.html
html • 0.04 MB
tech_eval.pdf
boq_comp_chart.xlsx
xlsx
fin_eval.pdf
aoc.pdf
Tap a document below to read it instantly. You can also download everything as a ZIP if you prefer.
details.html
html • 0.03 MB
Tendernotice_1.pdf
PDF • 0.45 MB
Form2911.pdf
Tender Documents • 0.29 MB
BOQ_2402028.xls
BOQ • 0.36 MB
Download all tender documents and submit your bid