REPAIR TO CHEQUERED TILES, PROTECTIVE WORK, AREA DRAINAGE MISC WORKS IN BG AND MENDHAR IN THE AOR OF AGE B/R-I UNDER GE 881 EWS

Amount

Demolition of cement concrete (un-reinforced) in ground floors and paving not exceeding 15cm thickness (below or above ground level), complete all as specified and directed.

M&L for PCC 1:5:10 type E-2 (using 40mm graded crushed stone aggregate) as in foundation filling and mass concrete, complete all as specified and directed.

M&L for supply, laying, spreading and leveling of sand as in cushion, not exc 25 cm thickness under precast concrete interlocking paver block, complete all as specified and directed.

M&L for machine pressed precast concrete interlocking paver block any shape and size confirming to IS-15658-2006 of 80mm thickness M-40 Grade,laid jointed pointed with grey cement and no pigments, complete all as specified and directed by Engr-in-Charge. Note: The sample shall be got approved by GE before bulk procurement & lot shall be got tested independently by the GE.

M&L for machine pressed precast concrete interlocking paver block any shape and size confirming to IS-15658-2006 of 60mm thickness M-35 Grade,laid jointed pointed with grey cement and no pigments, complete all as specified and directed by Engr-in-Charge. Note: The sample shall be got approved by GE before bulk procurement & lot shall be got tested independently by the GE.

M&L for providing and laying at or near ground level factory made kerb stone of M-25 grade cement concrete in position to the required line, level and curvature, jointed with cement mortar 1:3 (1 cement: 3 coarse sand), including making joints with or without grooves (thickness of joints except at sharp curve shall not to more than 5 mm), including making drainage opening wherever required, complete all as specified and directed by Engineer-in-Charge.

M&L for preparation of concrete or new plastered surfaces of any description over 10cm girth or width, not otherwise described and applying two coats of plastic emulsion paint over and including a coat of primer, complete all as specified and directed.

M&L for providing PCC 1:2:4, type B1 (using 20 mm graded stone aggregate) as in copings, kneelers, apex stones, bed plates, kerbs, water troughs and the like including weathering, slightly rounded or chamfered angles and throating, as directed. complete all as specified and directed by Engineer-in-Charge.

M&L for PCC 1:4:8 type D-2 (using 40mm graded crushed stone aggregate) as in foundation filling and mass concrete, complete all as specified and directed.

M&L for chequered cement concrete tiles with chemical resistant coating of size 300x300x 25mm thick, set & jointed in neat cement slurry in floors and pointed with grey cement mixed with pigments, laid over and including 20mm thick screed bed in CM 1:4, complete all as specified and directed.

M&L for 100mm thick PCC 1:2:4 Type B-2 (using 40mm graded crushed stone aggregates) laid in alternate bays (not exceeding 2 sqm each) as in plinth protection, finished the surfaces even & fair without using extra cement and providing joints throughout the thickness of plinth protection, filled with mastic filling comprising one part of bitumen 85/25 grade and three parts of sand by weight complete all as specified and directed.

Extra for forming fair finished drain or channel 30 cm inner grith in cement concrete, using extra cement including forms, moulds mitred/stopped ends etc, complete all as specified and directed.

Demolition of cement concrete (reinforced) of any description and in any position not otherwise specifically described (reinforement cut as required to facilitate demolition), complete all as specified and directed by Engineer-in-Charge.

Form work to soffits of suspended slab such as roof slabs, floor slabs, landings and similar work not exceeding 200mm thick for rough finished surfaces of concrete, complete all as specified and directed.

M&L for RCC nominal mix 1:2:4, type, B-1 (using 20mm graded crushed stone aggregate), as in slab supported on walls, beams, column, landing etc, complete all as specified and directed.

S&F mild steel TMT bars 10mm dia and over, cut to length, bent to shape required, including cranking, bending spirally for hooping for columns, hooking ends and binding with and including mild steel wire (annealed) not less than 0.9mm dia or securing with clips complete all as specified and directed.

Demolition of brick or stone masonry, built in cement mortar including all quoins, arches, pillars etc but excluding ashlars facings, dressed stone work, complete all as specified and directed.

M&L for Walling of random rubble stone masonry brought upto course, well bonded, bedded and solidly hearted, built in cement mortar (1:6), complete all as specified and directed.

All as per Srl item No. 18 above, but except stone complete all as specified and directed.

M&L for providing precast cement concrete 1:3:6, type C-1 (using 20 mm graded crushed stone agg) as in PCC bonders set in CM 1:6 complete all as specified and directed.

M&L for Hard drawn steel wire fabric of weight not exc 4 kg/sqm cut to lengths, bent to shape required and tying with and including mild steel wire (annealed) not less than 0.9mm in dia supplied and fixed in reinforcemnt, complete all as specified and directed.

M&L for brick work with sub class ‘B’ bricks straight or curved on plan exc 6m mean radius, built in cement mortar (1:6), complete all as specified and directed.

Extra over stone walling for hammer dressing with maximum depression on face from straight edge held against the dressed surface not exceeding 40mm to face stones (lime and sand stone) and dressing of face beds and joints, complete all as specified and directed.

M& L for raised pointing in cement mortar (1:4) brought upto courses built in CM complete all as specified and directed.

M&L for boulder filling hand packed tightly (any thickness) at back of walls over arches etc, and raising (or lowering) to the required level compete all as specified and directed.

S&F PVC (SWR) pipes 110mm dia any length single socketed with rubber ring joint as in weep holes material packing at the back shall be provided at suitable horizontal intervals with slope as soil pipe(vent pipe), complete all as specified and directed.

Taking down cement plaster of any description on stone or brick walls etc including racking out joints, hacking for key scrubbing down with water etc. complete all as specified and directed.

M&L for 15 mm thick rendering in CM 1:4 (incl a coat of cement slurry @ 500 gms per sqm) on stone masonry surfaces or other than fair faces of brick work or one side of lathing, finished even & smooth without using extra cement, complete all as specified and directed.

M&L for applying two coats of cement base paint on walls including preparation of new plastered or un-plastered surfaces of wall complete all as specified and directed.

M&L for preparation of old wall surfaces incl brooming down or steel wire brushing, scrapping down moulds, mass and effloresvcent salts and greasy spots and applying one coat of cement base paint, complete all as specified and directed.

M/S KHAN ENTERPRISES (BID ID -3295166)

M/S BHAGWATI ENTERPRISES (BID ID -3295451)

M/S SHAH ENTERPRISES (BID ID -3292712)

MEELU ENTERPRISES (BID ID -3292624)

SUNIL KUMAR SANGEET KUMAR AND SONS (BID ID -3290030)