Re-Tender of Construction of 33 KV Line

Amount

PART-A Following materials provided by the contractor

33 KV ‘XLPE’ C/J Kit 3x300mm² Outdoor

Number Plate

Danger Board with Clamp

Barbed wire

Bolts, Nuts, & Washers

Top channel clamp with nut bolt for ST Pole 11 mtr with nut bolt by 50x8 mm MS flat Iron make

Stay Clamp for ST Pole 11mtr. with Nut and Bolt by 50x8 mm MS Flat Iron make.

stay Rod 20x1800 mm

stay wire 7/8 SWG

MS Earthing Rod 20x2500 mm

33 KV Polymer Disc Insulator 70 KN B&S Type

Disc fitting 70 KN B&S Type for DOG

P.G. Clamp for DOG

M.S. Angle Iron 65x65x6mm bracing

33 KV M.S. bracing Angle clamp with nut bolt (Top side) for ST Pole 11 mtr with nut bolt by 50x8 mm MS flat Iron make

33 KV M.S. bracing Angle clamp with nut bolt (Bottom side) for ST Pole 11 mtr with nut bolt by 50x8 mm MS flat Iron make

33 KV. Top channel (125x65mmX3200 mm (10.7 Kg/m)

GI Wire 5 mm

Special GI Pipe for cable earthing

PART - B- WORK

Laying of 33 KV 3x300 mm² ‘XLPE’ cable(D/C) of Double cable by digging pit & making trench in Proper size (1.2M depth x1.2M wide) below ground level by fixing bricks(4½˝) on both side of trench wall and 9˝ brick work at the centre of the trench along the cable. Fixing brick slab on top after filling sand around both the cable including cost of bricks.

Rising of 33KV ‘XLPE’ cable in air after providing 6” dia. M.S pipe 3 m long Complete work.

Special GI Pipe Earthing Complete for 33 KV ‘XLPE’ C/J Kit.

Erection of Single pole structure for converting S/P to D/P on 11 mtr ST Pole including all works of evocation of pit, pole erection, making plinth for poles 30 cm above, grouting in the ratio 1:4:8 (cement, sand, 40 mm brick ballast), back filling of earth, proper ramming & fitting of all accessories (M.S. angle iron 65 x 65 x 6 mm bracing with clamps, top channel 125 x 65 x 3200 mm with clamps, danger board with clamp, Aluminium paint, red oxide paint, barbed wire earthing, etc. complete) .

Jointing charges of 33 KV ‘XLPE’ C/J Kit 3x300mm² Outdoor

Grouting of stay rods (20 x 1800) mm including all work of excavation, cement concrete in size (0.60 x 0.60 x 0.30) m in ratio 1:4:8 cement, sand, 40mm brick ballast) as per drg including back filling, proper ramming etc. Fixing tightening & nozzling of stay wire with stay rod with the poles of required tension as per drawing.

M/S OM SAI TRADERS

m/s tripathi brothers