SPECIAL REPAIR TO DRAIN WITH COVER FROM SPORTS COMPLEX TO COBRA GROUND AND SPL REPAIR TO ROAD IN PUMP HOUSE AT MALL ROAD (NEIL ROAD) OF HQ MB AREA AND CERTAIN REV WORK IN THE AREA OF AGE B/R-I UNDER GE (WEST) JABALPUR

Amount

Demolition of brick work or stone/boulder masonry built inb cement mortar including all quoins, arches, pillars etc excluding ashlar facings and precast concrete articles complete all as specified and as directed..

M&L for Brick work using fly ash old size bricks straight or curved on plan exc 6m mean radius built in cement mortar in 1:4 complete all as specified and as directed.

Ditto all as per Srl item No 2 above but except brick complete all as specified and as directed.

Demolition of cement concrete (unreinforced) in ground floors and paving n exc 15 cm thickness incl part chipping (below or above ground level) complete all as specified and as directed.

M&L for PCC (1:4:8) type D-2 using 40mm graded stone aggregate as in foundation filling and mass concrete complete all as specified and as directed.

M&L for RCC M 25 design mix (using 20 MM graded stone aggregate) as in walls, retaining walls, basement walls, ballast walls and the like; any thickness; above top of footings; including attached pilasters and buttresses etc complete all as specified and as directed.

M&L for RCC M-25 design mix (using 20 MM graded stone aggregate) as in foundations , including rafts etc complete all as specified and as directed.

M & L for Use and waste form work for faces of walls, retaining walls etc. for rough finished surface complete all as specified and as directed.

M & L for Use and waste of formwork to sides of concrete foundations, footings, bases of columns, raft and raft beams, sides and soffits (if any) of foundation and plinth beams; and similar work; vertical or to batter complete all as specified and as directed.

M&L for Precast cement concrete 1:2:4 type B1 using 20 mm graded stone aggregate as in cover slab and similar work including necessary form work and set in CM 1:6 complete all as specified and as directed. .

M&L for TMT bars 10mm over dia including cutting bending binding cranking placing & binding with MS wire (annealed) not less than 0.90mm dia as in main/distribution reinforcement complete all as specified and as directed.

M&L for TMT bars 6 to 8 mm dia including all cutting bending binding cranking placing & binding with MS wire (annealed) not less than 0.90mm dia as in main/distribution reinforcement complete all as specified and as directed.

Taking down cement plaster on brick/stone walls etc including raking out joints, hacking for key, scrubbing down with water complete all as specified and as directed.

S&F for Reinforced concrete pipes 600mm bore class NP-3 Laid and jointed with collars complete all as specified and as directed.

M&L for Plain cement concrete (1:2:4) type B-1using 20 mm garded stone aggregates as in coping, bed plate, and the like including weathering, slightly rounded or chamferred angles and throating as directed including provision of necessary form work and finishing exposed surface even and smooth without using extra cement, complete all as specified and as directed.

EXTRA for forming fair finish to drain or channel 30 cm inner girt in cement concrete using extra cement incluiding formings moulds mitred stopped ends etc complete all as specified and as directed.

M&L for 10mm thick rendering on fair faces of brick work or concrete surface of wall in CM 1:4 and to be finished even and smooth without using extra cement complete all as specified and as directed

M&L for PCC 1:2:4 type B-2 using 40mm graded stone aggregate as in surface channels and drains complete all as specified and as directed.

S&F, for PVC (SWR) pipes 110mm bore single socketed, in any length with rubber ring joints, laid in trenches or in walls complete all as specified and as directed.

M&L for Framed work such as grills,gratings, etc.. with ends of bars shouldered and/or riveted, or forged into spikes; framed guard bars; barred iron doors; ladders; framed balusters; walk ways; railings; framework of water tanks and similar work con- forming to Fe.290.Gde-E-165 complete all as specified and as directed.

Demolition of reinforcement cement concrete including post,cover slab facia, parapets etc required to facilitate demolition complete all as specified and directed.

M&L for applying two coats of synthetic enamel paint over a coat of red oxide zinc chrome primer on new steel surface of exceeding 10cm width or girth including preparation complete all as specified and as directed.

Excavating in post holes (or similar holes) each n.exc 0.5 cu.m getting out, returning filling in and ramming earth around, in layers not exceeding 25 cm, watering, and removing surplus soil to a distance n.exc 50 m and making good surface in soft and loose soil complete all as specified and as directed.

M&L for cement concrete type C-2 1:3:6 (using 40 mm graded stone aggregate) as in foundations, filling and mass concrete complete all as specified and as directed.

M&L for hardcore of gauge 63 to 100 mm ,deposited spread and levelled in layer n exc 100 mm thick , watered ,rolled to true surface complete all as specified and as directed.

M&L, for Rolled sections as in main and cross beams, hip and jack rafters; post, rafter purlins where connected to common rafters and running rails fixed with angle cleats or other connecting plates complete all as specified and as directed.

S&F, for Pre-painted galvalume aluminium zinc coating GI based corrugated steel sheet 0.50mm of an colour having tensile strength of 550 Mpa as in roof covering/cladding to wall, fixed with self tapping screws/J or L hook complete all as specified and as directed.

Surface excavation n. exc 30cm deep and averaging 15cm deep and getting out in any type of soil complete all as specified and as directed.

M&L for 100 mm thick Cement concrete 1:4:8 type D-2 using 40 mm graded stone aggregate as in sub base complete all as specified and as directed.

Machine pressed precast concrete inter locking paver block of any shape and size made of M-35 grade concrete (with grey cement and no pigment) of 60mm thickness with 6mm top layer of anti abrasive material laid over and inclufding 25mm thick (compacted) fine sieved sand complete all as specified and as directed.

M&L for MS work as in wind ties for roof including securing bolts, drilling holes, notching for wire etc complete all as specified and as directed.

M & L for Precast RCC grade M-30 sitting bench of 100 mm thickness with back length 1500mm, front height 450 mm ,bottom width 620-650 mm reinforced with 4 Nos 10 mm dia TMT bar per leg and 4 mm dia mild steel strip , concrete plank 1500x100x50mm and 1500x500x50 mm of desired colour including anti corrosive and waterproof coating and parts should be jointed with galvanised nut and bolt as specified by Engr in charge Including fixing at site complete all as specified and as directed

Removing excavated material nexc 50 M and depositing where directed at a level nexc 1.5 M above the starting point complete all as specified and as directed.

M & L for 50 mm thick sand filling under floors or in foundations including ramming, watering and consolidation complete all as specified and as directed.

M & L for moorum/ red bajri filling under floors laid in layers not exceeding 15 cm thick, spread levelled and rammed / rolled including watering to required level and gradient complete all as specified and as directed.

Taking down old deterioted pipes of any size or pattern and any description including all fittings etc complete all as specified and as directed.

Dismantling Floor, Hearth or Wall Tiling including cement mortar bedding [but not backing] and removing serviceable tiles to the stores and removing rubbish / debris of the premises complete all as specified and as directed.

M&L for Factory made precast PCC blocks (1:2:4) type B-1, (using 20mm graded stone agg) as in kertb stone including rounding/chamfering and finished exposed surface even and smooth and set in CM 1:4 complete all as specified and as directed.

M & L for brick work with sub class "B" bricks, old size, straight or curved on plan exceeding 6 m mean radius built in Cement Mortar 1:6 complete all as specified and as directed.

M&L for 15mm thick rendering in cement mortar 1:4 on fair faces brick work or concrete surfaces finished even and smooth without using extra cement complete all as specified and as directed.

M&L for applying two coats of Cement Base Paint over a coat of alkali resistance primer on Newly Plastered Surfaces of external Walls including preparation complete all as as specified and as directed.

ANAMIKA CONSTRUCTION (BID ID -3334301)

ISHWAR CONSTRUCTION COMPANY (BID ID -3341659)

chandra builders (BID ID -3330019)

MAA SHARDA CONSTRUCTION (BID ID -3342017)

G.S.CONSTRUCTIONS (BID ID -3342138)