PROVN OF CHAIN LINK FENCING AROUND TMQ WITH GATE AT AF STN BKT

Amount

Surface excavation in soft/loose soil n.exc (not exceeding) 30 cm deep and averaging 15cm deep and getting out complete all as specified and directed.

M & L for hardcore of broken stone of gauge n exc. 63 mm, deposited, spread and levelled in layers n exc. 15 cm thick, watered and rammed to a true surface complete all as specified and directed.

M&L for 75mm thick PCC 1:4:8 type D-2 (using 40 mm graded stone aggregate) as in sub base of floor for laying of interlocking paver block complete all as specified and directed.

Providing and laying 80 mm thick factory made chamfered edge cement concrete paver block of M-35 grade with approved colour, design & pattern as in footpath, parks, lawns, drive ways or light traffic parking etc., of required strength, thickness & size/ shape, made by table vibratory method using PU mould, laid in required colour & pattern over and including 50mm thick compacted bed of fine sand, compacting and proper embedding/ laying of inter locking paver blocks into the sand bedding layer through vibratory compaction by using plate vibrator, filling the joints with sand and cutting of paver blocks as per required size and pattern, finishing and sweeping extra sand complete all as specified and directed.

Excavating in post holes (or similar holes) in soft/loose soil, each n exc 0.5 cum getting out, returning filling in and ramming earth or broken rubble mixed with earth around, in layers not exc 25cm, watering, and removing surplus soil to a distance n exc 50m and making good surface complete all as specifed and directed

Removing excavated material n exc 50m & depositing where directed at a level n exc 1.5m above the starting point complete all as specified and directed

Providing and laying at or near ground level factory made kerb stone of M-25 grade cement concrete in position to the required line, level and curvature, jointed with cement mortar 1:3 (1 cement: 3 coarse sand), including making joints with or without grooves (thickness of joints except at sharp curve shall not to more than 5 mm), including making drainage opening wherever required complete all as specified and directed.

M&L PCC 1:3:6 type C-2 (40mm graded stone aggreage) as in foundation filling and mass concrete etc complete all as specified and directed.

S & F MS framed work as in doors or gates of angle or other section with gusset plates, rails, braces, etc., complete, drilled for fixing of steel sheeting or other covering. Doors, etc. to be prepared for hanging or sliding with and including either hooks and hinges or steel hanging door fittings (exclusive of steel sheeting or other covering, running rails and guides) and hanging; also fastening and fixing with mild steel conform to Fe 410 -W (Gde- E- 250) quality- A complete all as specified and directed.

S & F MS work for hand rails, half round grill or other steel section or core for wooden hand-rail straight portion, drilled and untersunk for balusters running bars, for doors, balusters, nosing to steps including embeding in concrete and screwing etc. wind ties for roof including securing boltsposts and struts in fencing including cutting tops to Flat iron iron hapeirected, drilling holes,notching for wire, etc.; flat ironfillets (for securing wire meshetc.) including all necessarydrilling, bolting or riveting, etc.,and similar work conforming toFe-290 Gde E-165 complete all as specified and directed.

S & F Mild steel bars 10mm dia round bars and over, cut to length, bent to shape required, including cranking, bending spirally for hooping for columns, hooking ends and binding with and including mild steel wire (annealed) not less than 0.9mm dia or securing with clips complete all as specified and directed.

Preparing new steel surfaces of any description over 10cm width or girth and applying two coats of synthetic enamel paint over a coat of red oxide primer complete all as specified and directed

Preparing new steel surfaces of any description n exc 10cm width or girth and applying two coats of synthetic enamel paint over a coat of red oxide primer complete all as specified and directed

Supply only Chain link MS galvanisd fencing of any size or type complete all as specified and directed

Fixing only chain link fencing including line wires, any mesh, size and type to any type of standards, rails, straining bolts, etc. including provision of binding wire complete all as specified and directed

Excavating in trenches, n exc 1.5 m wide and n exc 1.5 m in depth; for foundation, etc. and getting out in soft/loose soil complete all as specified and directed

M&L for cement concrete 1:2:4 type B2( 40 mm graded stone aggregate) as in surface channel and drain complete all as specified and directed

M&L for Brickwork with sub- class ‘B’ bricks built in cement mortar 1: 6 straight or curved on plan exc 6 m mean radius complete all as specified and directed

M&L Rendering15 mm thick in cement mortar 1:6 on fair faces of brick work or concrete sufaces finished the surfaces even smooth using extra cement complete all as specified and directed.

M&L for providing cement concrete 1:2:4 type B0 (12.5mm graded stone aggregate) as in kerbs,copings, kneelers, apex stones, bed plates, channel , water troughs and the like including weathering, slightly rounded or chamfered angles and throating, complete all as specified and directed

M/S PRATAP BUILDERS

M/s R K Associates

H C CONSTRUCTION

M/s A S Associates