ADDN ALTN TO EXISTING SHED AND PROVN OF JAFFRI WALL INCLUDING ALLIED WORKS NEAR T 79 AND PROVN OF WINDOW PANES AT VARIOUS TRAINEE BILLETS AT ATS BELAGAVI

Amount

Surface Excavation not exceeding 30 cm deep and averaging 15 cm deep and getting out in Soft/ Loose soil complete all as specified and directed

M & L Moorum/red bajri filling in floors or pavings, laid in layers not exceeding 15 cm thick, spread, levelled and rammed including watering all as specified and directed

Removing excavated material (soil) to a distance n. exc. 50 m and depositing where directed at a level n. exc.1.50 m from starting point all as specified and directed

Excavation in trenches not exceeding 1.50 mtr deep and not exceeding 1.50 m wide and getting out in hard/dense soil all as specified and directed

M & L Plain cement concrete 1:4:8 type D-2 using 40 mm graded stone aggregate as in foundation filling and mass concrete all as specified and directed

M & L Pre-cast cement concrete block masonry 1:3:6 type C-1 using 20mm graded stone aggregate exceeding 10cm in width set in cement mortar 1:4 complete all as specified & directed

M & L Cement concrete 1:2:4 using 20mm graded crushed stone aggregate type B1, as in coping including necessary form work complete all as specified & directed

M & L Reinforced cement concrete 1:2:4 type B1, using 20 mm graded crushed stone aggregate, nominal mix, as in beams, cantilevers, bressumers, lintels over 1.5 m span complete all as specified & directed

M & L Precast cement concrete 1:2:4 using 12.5mm graded stone aggregates, type B-0 as in louvers and jallies 50mm thick (Measured solid), including all mouldings set in CM 1:4 complete all as specified & directed

M & L form work to soffits of floor or roof beams, bressumers, lintels and simlar works including supports, overhangs for flat fair finished surfaces complete all as specified and as directed.

M & L TMT steel bar 10 mm dia cut to length, bent to shape required, including cranking bending, hooking for ends and binding with mild steel wire annealed not less than 0.9mm dia, etc all as specified.

S & F TMT steel bar 5 mm dia over upto including 10 mm dia cut to length, bent to shape required, including cranking bending, hooking for ends and binding with mild steel wire annealed not less than 0.9mm dia, etc all as specified as in stirrups,spacers,binders etc all as specified.

M & L rendering 15 mm thick in cement mortar 1:4 on fair surfaces of block masonry/concrete surfaces finished even and smooth without using extra cement all as specified and directed

M & L Finishing walls with Acrylic Smooth exterior paint of required shade : New work (Two or more coat applied @ 1.67 ltr/10 Square Meter over and including priming coat of exterior primerapplied @ 2.20 Kilo Gram/10 Square Meter) all as specified and directed

Returning, filling in layers n. exc. 25 cm including spreading, levelling, watering and well ramming in hard/dense soil all as specified and directed

M & L Plain cement concrete 1:4:8 type D-2 using 40 mm graded stone aggregate as in 75 mm thick sub base to flooring all as specified and directed

M & L Plain cement concrete 1:2:4 type B-1 using 20 mm graded stone aggregate as in 100 mm thick flooring with spike rolling to surfaces or making impressions of expanded metal, whilst the concrete is green all as specified and directed

M & L forming of constrution joint 30 mm deep x 10 mm wide filled with sealing compound grade 'B'all as specified and directed

M & L Preparation of old treated concrete surfaces and applying two coats synthetic enamel paint of any description over 10cm girth or width, not otherwise described all as specified and directed

Dismantling structural steel work including doors, gates but excluding framed truss etc.all as specified and directed

M & L steel work in tubular Post including special shaped washer etc complete using ERW or induction butt welded tubes conforming to IS 1161-1979 grade St 240 all as specified and directed

Fixing only Roof trusses (framed)/ trussed/ purlins, crane gantries, rails and fastenings and heavy bracket framing (Beam, tee, angle, channel or flat sections) including distance pieces, cleats etc all as specified and directed

Excavating in post holes (or similar holes) in Hard/dense soil each n exc 0.5 Cubic Meter getting out ,returning filling in and ramming earth or broken rubble mixed with earth around ,in layers not exceeding 25 cm, watering,and removing surplus soil to a distance n exc 50 m and making good surface all as specified and directed

M & L Plain Cement Concrete 1:2:4 type B1 using 20mm stone aggregates for embedding MS pipes all as specified and directed

S & F Roof trusses (framed or un framed), trussed, purlins, crane gantries, rails and fastenings and heavy bracakets framing (Beem, Tee, angle, channel, Hollow/flat sections) including distance pieces, cleats etc grade Fe 410-W(Gde-E- 250)quality- A all as specified and directed.

S & F Plates (plain or chequered) channels, square cut or notched (ordinary and counter sunk) forming holes, with attachment Fe-410-W(Gde- E-250) quality-B all as specified and directed.

M & L Preparation of new or previously untreated steel surfaces of any description over 10cm width or girth, applying two coats of synthetic enamel paint over one coat of red oxide primer all as specified and directed.

Dismantling and refixing existing sheeting of pre painted galvatume alluminium zinc coating GI based corrugated steel sheet 0.50 mm thick of any colour having tensile strength of 550 Mpa as in roof covering /cladding to wall fixed with self tapping screws all as specified & directed

M & L pre painted galvatume aluminium zinc coating GI based corrugated steel sheet 0.50 mm thick of any colour having tensile strength of 550 Mpa asin roof covering /cladding to wall fixed with self tapping screws all as specified & directed

Demolition of cement concrete ( un reinforced ) in ground floors and pavings n exc 15 cm thickness (below or above ground level) all as specified & directed

Hacking out old broken glass (any thickness, size, quality or description) from wooden/steel frames , glazed with putty or fixed with beads all as directed up to 4 storey bldgs all as specified & directed

M & L trasculent acrylic sheet 4 mm thick fixed to steel/wooden shutters upto G+1 storey building height with suitable adhesive or screws or by other means all as specified & directed

M & L trasculent acrylic sheet 4 mm thick fixed to steel/wooden shutters, exceeding G+1 and upto G+3 storey building heigh,t with suitable adhesive or screws or by other means all as specified & directed

M & L replacing any unservicable hinges 100mm M S medium weight by welding fixed in existing window/door frame/ chowkhats for proper operation of window/ door shutter all as specified and directed.

ASHIRWAD ELECTRICALS

M/S ADITYA CONSTRUCTIONS

RAHUL SAYAJIRAO DESAI