Providing and fixing of cautionary sign boards, painting speed breakers, zebra crossing with Thermoplastic paint at the various roads in the jurisdiction of B and R (North) Division, Puducherry.

Amount

Providing and laying of hot applied thermoplastic compound 2.5mm thick including reflectorising glass beads @ 250 gms per sqm area, thickness of 2.5mm is exclusive of surface applied glass beads as per IRC:35. The finished surface to be level, uniform and free from streaks and holes.

Providing and fixing of retro - reflectorised cautionary, mandatory & informatory sign as per IRC:67 made of aluminium sheet encapsulated lens with high intensity grade sheeting vide Clause 801.3, fixed over aluminium sheeting, 1.5 mm thick supported on a mild steel angle iron post 75 mm X 75 mm X 6 mm ( 3.5 mtrs height - 6.8kg/mtr = 23.8kg , with board support angle 35x35x6mm-2.30 mtrs - 3kg/mtr = 6.9kg and anchor flat - 0.5kg)firmly fixed to the ground by means of properly designed foundation with M15 Grade cement concrete 45 cm X 45 cm X 60 cm , 60cm below ground level as per approved drawing. - 60 cm equilateral triangle . (including cost of angle iron towards cost of drilling holes nuts , bolts etc.,)

Providing and fixing 3m make reflective road studs of category 'A' raised pavement markers made out of poly carbonate/ABS moulded body and reflective panels with micro prismatic lens capable of providing total internal reflection of the light entering the lens face with retro reflectance and chromaticity values conforming to ASTM D4280. The reflective raised pavement makers shall also confirm the length, height and width of the body shall be less than 100mm, 15mm and 90mm and base of marker shall be flat within 1.3mm (3m equivalent). The marker shall support a load of 13635Kg tested in accordance with ASTM D4280. Lenses shall be moulded of polycarbonate or methyl methecrylate conforming ASTM D788. The area of each retro reflectory surface shall not be less than 13.0 sq.cm. The slope or retro reflectory surface shall be 35+5 degree to base. Each reflector shall have a CIL not less values specified in table 1 of said MORTH circular and two cylindrical polymer shanks not less than 20mm diameter and not less than 30mm length shall be provided for better anchorage with bituminous grout or epoxy mortar.

Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - all work upto plith level - 1:1.5:3 (1 cement : 1.5 coarse sand : 3 graded stone aggregate 20mm nominal size)

Bagyalashmi Constructions

m/s egaa construction

R RAJA