Parking or vehicle shed at Chhinda-New Sethia OCM Phase I and II) under Rawanwara Sub Area.

Amount

Earth work in excavation by mechanical means (Hydraulic excavator) / manual means in foundation trenches or drains (not exceeding 1.5 m in width or 10 sqm on plan), including dressing of sides and ramming of bottoms, lift upto 1.5 m, including getting out the excavated soil and disposal of surplus excavated soil as directed, within a lead of 50 m.

Providing and laying in position cement concrete 1:2:4 (1 cement : 2 coarse sand (zone-III) includingmanufactured sand derived from Recycled concrete aggregate (RCA) upto 25% : 4 graded stone aggregate 20mm nominal size including Recycled concrete aggregate (RCA) upto 25%).

Providing and laying in position cement concrete ofspecified grade excluding the cost of centering and shuttering - All work up to plinth level :1:4:8 (1 Cement : 4 manufactured sand derived from Recycled concrete aggregate (RCA) : 8 graded stoneaggregate 40 mm nominal size Recycled aggregate (RA)

Brick work with common burnt clay modular bricks of class designation 7.5 in foundation and plinth in: Cement Mortar 1:6 (1 cement : 6 coarse sand).

40 mm thick flooring with 20 mm nominal size stone aggregate, Cement concrete flooring 1:2:4 (1 cement : 2 coarse sand: 4 graded stone aggregate) finished with a floating coatof neat cement, including cement slurry, but excluding the cost of nosing of steps etc. complete.

Providing and laying 60mm thick factory made cementconcrete paver block of approved shape and colour of M -30 grade made of C&D waste by block making machinewith vibratory compaction laid in required pattern and including over 50mm thick compacted bed of coarse sand,filling the joints with fine sand etc. all complete as per the direction of Engineer-in-charge.

Providing and fixing precoated galvanised iron profile sheets (size, shape and pitch of corrugation as approved by Engineer-in-charge) 0.50 mm (+ 0.05 %) total coated thickness with zinc coating 120 grams per sqm as per IS: 277, in 240 mpa steel grade, 5-7 microns epoxy primer on both side of the sheet and polyester top coat 15-18 microns. Sheet should have protective guard film of 25 microns minimum to avoid scratches during transportation and should be supplied in single length upto 12 metre or as desired by Engineer-in-charge. The sheet shall be fixed using self drilling /self tapping screws of size (5.5x 55 mm) with EPDM seal, complete upto any pitch in horizontal/ vertical or curved surfaces, excluding the cost of purlins, rafters and trusses and including cutting to size and shape wherever required

Providing and fixing precoated galvanised steel sheet roofing Ridges plain (500 - 600mm) accessories 0.50 mm (+0.05 %) total coated thickness, Zinc coating 120 grams per sqm as per IS: 277, in 240 mpa steel grade, 5-7 microns epoxy primer on both side of the sheet and polyester top coat 15-18 microns

Structural steel work riveted, bolted or welded in built up sections, trusses and framed work, including cutting, hoisting, fixing in position and applying a priming coat of approved steel primer all complete.

Painting Steel work with Deluxe Multi Surface Paint to givean even shade. Two or more coat applied @ 0.90 ltr/10sqm over an under coat of primer applied @ 0.80 ltr/10sqm of approved brand and manufacture

Total impact of GST for the purpose of CTC

MOHAN BATRI

SHANKAR RAO MANKAR