Loading…
Loading…
| # | Company | Amount | Rank | Status |
|---|---|---|---|---|
| 1 | L1₹6.3 CrAccepted-AOC | ₹6.3 Cr Quoted ₹6.4 Cr | L1 | Accepted-AOC Lowest |
| 2 | L2₹6.8 Cr+₹41.4 L (6.47%)Rejected-AOC HSVP PANCHKULA | PANCHKULA | HARYANA | 133301 | ₹6.8 Cr+₹41.4 L (6.47%) | L2 | Rejected-AOC Higher side |
| 3 | L3₹7.3 Cr+₹86.8 L (13.6%)Rejected-Finance | ₹7.3 Cr+₹86.8 L (13.6%) | L3 | Rejected-Finance Higher Side |
| 4 | L4₹7.7 Cr+₹1.3 Cr (19.8%)Rejected-Finance | ₹7.7 Cr+₹1.3 Cr (19.8%) | L4 | Rejected-Finance Higher Side |
Tender Value
₹5.6 Cr
EMD Value
₹11.3 L
Closing Date
7 Feb 2020, 4:00 pmClosed
Rohit Kumar
O/o PHED HANSI PIN-125033
Laying of sewer line, construction of main hole, repair and raising of manhole construction of IPS etc. and all other works contingent thereto
2019_HRY_113805_2
EIC Memo No.124378 dated 19.12.2019 PHE Hansi
Open Tender
Civil Works
Works
540 days
PHED Hansi
Please refer Tender documents.
6 documents required · 6 mandatory
₹20,000
EE PHED Hansi
₹11.3 L
12 May 2020
29 Jan 2020
7 Feb 2020
29 Jan 2020
7 Feb 2020
29 Jan 2020
Amount
Providing at installion of 2 No Non clog sewerage submersible pumping set of follwing duties complete with suitable BHP motor with a accessricies described in schedule No.III complete in all respect 2550 LPM x 18mtr. Head
Supply and Fixing following CI D/F pipe and Bell Mouth including cost of joining materials, laying, jointing, refilling inckuding making adequate support of masonry/ concrete for delivery and suction pipe from bell mouth in the collecting tank upto the rising main laid by the Department as per plan shown from the foundation wall of pump chamber for all the raw water and clear water puping sets at water works in position, as per specification given in schedule No. II. A) CI D/F pipes i) 200 mm i/d
Supply, erection, testing and commissioning of wall mounted electrical panel board, fabricated from 16 SWG CRCA sheet duly stouted with suitable angle iron frame work and completely powder coated of approximate size 500X1200mm and 400mm deep having following accessories:- 1. Incomer switch 100 Amp. 2. Copper bus bar chamber of 100 Amp. Capacity 3. Volt meter 100X100mm range 0 to 500 V (AE/KAPPA/L & T ) 4. Indicating lamp-one set 2 No Non clog sewerage submersible pumping set 20.00 BHP, 20mtr. Head . (a) Main switch 100 Amp. 2 Nos.. (L & T Siemens, ABB, Havels, Standard, HPL) (b) Volt meter 100X100 mm range 0 to 500 volt 1 No. (AE/KAPPA/L&T) (c) Amp. meter 100X100 mm range 0 to 100 Amp. 2 Nos. (AE/KAPPA/ L&T) (d) CT 100/3 Nos. (AE/KAPPA/ L&T) (e) VSS & ASS 2 No. each of approved make (f) SPP 2 No. of approved make (g) Motor starter, star delta 2 Nos. for 2550LPM x 18M Head Motor (L&T Simens, AAB) (h) Capacity KVAR as per site requirement (i) Indicating Lamp-2 Set ( j) Change over switch 100 Amp. = 2 No.
Supply, errection, testing & commissioning of standard make 63 KVA 11/0.433 KVA 3 phase 50 cycle copper wound outdoor type transformer with annual tape charge and termination complete in all respect (Kirloskar /ABB/GE make)
Supply, erection, testing and commissioning of 25 KVA/ 14.92 KW diesel generating set, noise control acoustic enclosure radiator cooled, 3 phase, 4 wire, 50 cycles 415 +(-) volts AC alternator coupled directly through a set of flexible coupling on a common MS fabricated base frame with diesel engine. The rating should be at 1500 RPM (a) Diesel Engine (b) Alternator (c) Base Plate (d) Battery 24 V (e) 1x120 sq.mm 3.0 core XLPE Aluminum= 20 mtrs. (f ) Tools AMF Panel (a) Motorized change over switch 100Amp. 4 P with fuse base and HRC links 100 Amp. (b) Under voltage/over voltage relay= 2 No. 415 VAC (c) Engine start relay 24 VDC 1 No. (d) Electronic Timer 24 VDC 1 No. (e) Electronic Timer 24 VAC 2 No. (f) Auxiliary relay 220 VAC 2 No. (g) Auxiliary relay 220 VAC 3 No. (h) Metering set 415 VAC, 1 set (Amp. Meter, volt meter, ASS, VSS, Phase indicators, control fuse, frequency meter, CT’s). (i) Metering set 24 VDC (Amp. Meter, volt meter). (j) Over load protection for DC 1 No. (k) Battery charger 24 VDC (Blueron Make) (l) Copper bus bar of suitable size (m) KWH meter 96 square mm size (n) Starting fuse button and key switch (on/off) (o) Engine protection unit with audio visual alarm and shut down for low lubricating oil pressure and high coolant temperature. (p) Indicating lamp for low lubricating oil pressure high coolant temperature, set running, load on, DC control on. Note: Control panel shall have the provision to provide auto manual failure panel (AMFP)
Supply, erection, testing of standard make wiring of 2 nos. motors with underground system in PVC and flexible pipes copper wire size 10 Sq mm complete in all respects with accessories like thimble etc. complete in respects.
Supply, erection, testing of ISI marked copper wire for 2 Nos. panel boards from main switch to panel and wiring of panel with size 25 Sq. mm copper wire ISI marked complete in all respect with accessories like thimble etc. complete in respects.
Supply, erection, testing of light fittings including wire in the Pump Chamber with material up to 5 points including switch, button, plug, PVC conduct pipe and Copper wire etc. as per approved specifications complete in respects
Providing and fixing exhaust fans 18" i/d (450mm) complete with suitable GI sheet of approved make complete in respects.
Supply, erection, testing of reputed make CFL vapour light 100 watts with fitting and accessories complete in respects.
Bidder Name
Amount
M/S SAT NARAIN GUPTA CONTRACTOR
VINAY KUMAR CONTRACTOR
BHARAT SINHMAR
ROHTASH KUMAR CONTRACTOR
VINAY KUMAR CONTRACTOR
ROHTASH KUMAR CONTRACTOR
BHARAT SINHMAR
ROHTASH KUMAR CONTRACTOR
VINAY KUMAR CONTRACTOR
BHARAT SINHMAR
stage.html
html • 0.05 MB
tech_bid_open.pdf
tech_eval.pdf
fin_bid_open.pdf
boq_comp_chart.xlsx
xlsx
fin_eval.pdf
aoc.pdf
Tap a document below to read it instantly. You can also download everything as a ZIP if you prefer.
details.html
html • 0.03 MB
Download all tender documents and submit your bid
Disclaimer: TenderKart has made every reasonable effort to ensure that the information on this page is accurate and authentic, however it cannot be held liable for any third-party claims or losses or any damages. TenderKart makes no warranty, expressed or implied, as to the results obtained from the use of this information. If you notice any error or omission, please let us know at .