TIRUPPUR CORPORATION_MLA FUND_Construction ICDS Center at Karattagadu Extension in Ward no 50

Amount

Earthwork excavation for foundation in all soils and sub soils except in hard rock requiring blasting and depositing on bank with initial lead of 10m and initial lift of 2m inclusive of shoring, shuttering, bailing out water wherever necessary, refilling the foundation with excavated earth other than sandy soil in layers of not more than 150mm thick layers well rammed and depositing the surplus earth within the compound in place shown by the departmental officers and clearing and levelling the site etc,. complete.

Random rubble masonry in CM 1:5 [one cement and five M-sand] for foundation and basement using best new rough and bond stones including simultaneous pointing above ground level with the same mortar etc., complete complying with standard specification.

Supplying and filling in foundation and basement with filling M-Sand in layers of not more than 15cm thick well rammed, watered and compacted etc., complete complying with standard specification.

Plain Cement concrete in 1:5:10 [one cement, five M-sand and ten course aggregate] using 40mm size Hard Broken/Machine crushed Granite Stone Jelly including dewatering if found necessary and laid in layers of not more than 15cm thick and compacted etc., complete complying with standard specification.

Filling in foundation and basement with excavated earth (or) soil in layers of not more than 15cm thick well rammed, watered and compacted etc., complete complying with standard specification.

Supplying and filling of Quarry Rubbish laid in layers of not more than 15cm thick well rammed, watered and compacted etc., complete complying with standard specification.

Providing and laying in position standardised concrete mix M-20 Grade in accordance with IS 456-2000 using 20mm and down graded hard broken jelly for all RCC items of works with minimum cement content of 3250kg/10cum and maximum water cement ratio of 0.50 including admixture (Plasticiser / super plasticiser) in recommended proportions as per IS 9103 to accelerate, related setting of concrete, improve workability without impairing strength and durability with about (5.0cum) 7730kg of 20mm machine crushed stone jelly and with about (3.30cm) 5156kg of 10-12mm machine crushed stone jelly and with about (4.79cum) 7760kg of M-Sand, but excluding cost of reinforcement grill and fabricating charges, centering and shuttering but including laying, vibrating with mechanical vibrators, finishing, curing etc and providing fixtures like fan clamps in the RCC floor / Roof slabs wherever necessary without claiming extra cost etc., complete complying with standard specification and directed by the departmental officers. The Coarse and fine aggregates to be used should comply with the requirements of IS standards.

Below Ground Level

Above Ground Level

Supplying and erecting centering for soffits of plane surfaces like RCC Slabs, Lintels, Sunshades, Square Columns, Staircase waists, Beams etc., including strutting 3m high using mild steel sheets of size 90cm x 60cm and BG 10 stiffened with M.S angles of size 25mm x 25mm x 3mm laid over silver Oak (C.W) joists of size 10cm x 6.5cm (spaced at about 90cm c/c) and supported by casurina props of 10cm to 13cm dia (spaced of 75cm c/c) etc., complete complying with standard specification.

Supplying and erecting centering including necessary supports for the plane surfaces such as RCC Column Footing, Plinth Beam, & Sill Beam etc., using mild steel sheets of size 90cm x 60cm and BG 10 stiffened with welded mild steel angles of size 25mm x 25mm x 3mm for boarding supported by casurina props of 10cm to 13cm dia spaced at suitable intervals etc., complete complying with standard specification.

Supplying and erecting centering for soffits of Square / Rectangular Columns including strutting 3m high using mild steel sheets of size 90cm x 60cm and BG 10 stiffened with M.S angles of size 25mm x 25mm x 3mm laid over silver Oak (C.W) joists of size 10cm x 6.5cm (spaced at about 90cm c/c) and supported by casurina props of 10cm to 13cm dia (spaced of 75cm c/c) etc., complete complying with standard specification.

Supplying, fabricating and placing in position of Steel Reinforcement using Mild Steel or Ribbed Tor steel bars for reinforcement to all RCC works as per the design given including cost of steel and binding wire also in all floors etc., complete complying with standard specification.

Fly Ash Brick work In CM 1:5 mix using best Fly Ash Bricks of size 230 x 110 x 70mm including finishing, curing etc., complete complying with standard specification.

Above Plinth beam

Super Structure

Supply and fixing in position of 50mm thick RCC Jolly made in RCC 1:2:4 mix using 20mm size Hard Broken/Machine crushed Granite Stone Jelly including cost of moulding and excluding cost of steel reinforcement etc., complete as per standard specification.

Ceiling Plastering with cement mortar 1:3 mix (one cement three P-sand), 10mm thick in all floors for RCC slabs, Beams, Sunshades including packing, providing cement mortar beading for sunshades, staircase steps, landing slabs etc., as directed by the departmental officers etc., complete complying with standard specifications.

Plastering with cement mortar 1:5 mix (one cement five P-sand), 12mm thick in all floors using clean screened M-Sand and including cost of curing for fifteen days from the completion of the work and surface should free from undulations and including the cost of preparing the surface for plastering and protecting from other damages till setting of mortar etc., complete complying with standard specification.

Painting two coats with ready mixed Plastic Emulsion paint (weather proof) of approved quality and colour over a priming coat, including thorough scraping, clean removal of dirt and including necessary plaster of paris, putty wherever required etc., complete as per standard specifications.

Painting two coats for New iron work surface using best quality synthetic enamel paint etc., complete complying with standard specification.

Fabricating supplying & fixing of M.S Doors with single / two leaves with outer frame 40x40x6mm Angle, shutter frame 35x35x6mm Angle, MS sheet 20 gauge intermediate stiffener 'T' section 25x25x6mm, panel should be covered with 20 gauge M.S sheet with necessary Tower Bolt 30cm length, butt hinges, hold fast, aldrop and handle on both sides etc., complete with one coat of red oxide primer.

Supply and fixing of M.S Grills with Doors, Windows, Ventilators and Gates of required size suitable to site condition with one coat of red oxide with primer including all costs such as welding, grinding and fabrication charges, cost and conveyance of all materials to site etc., complete as per standard specification.

Finishing the top of flooring with a layer of cement concrete 1:3 [one cement and three stone jelly] ELLIS PATTERN 25mm thick using 10mm thick and below gauge HBG stone (No sand to be added) and the surfaces rubbed smooth with current etc., complete complying with standard specification.

Paving the floor with 10mm thick Double Charged Vitrified Tiles in all floors over a base layer of cement mortar 1:3 [one cement and three M-sand] 20mm thick of walls and floors and pointed with the same colour cement neatly, including polishing with electric polishers to a high degree so as to make it perfectly smooth and showing etc., complete complying with standard specification.

Dadooing the walls with Colour Designed glazed tiles of size 300mm x 200mm x 6mm of approved make and quality in cement mortar 1:2 mix [one cement and two M-sand] over 10mm base layer plastering and pointing with white cement neatly etc., complete as per standard specification.

Providing and fixing of PVC Rain water downfall pipe of 110mm dia 4kg/sq.cm with necessary teak wood clamps etc., complete complying with standard specification.

Wiring with 2x1.5sq.mm. PVC insulated SC unsheathed FRLS copper conductor of 1100V grade insuitable PVC rigid pipe concealed in walland ceiling with PVC accessories inflush with wall with 3mm thick hylum sheet cover with TW switch box and 5AFT switch with continuous earth wire connection of 1.5sq.mm copper wire form aking good of the concealed portion with suitable colour for PVC concealed light point / fan point (for electronic regulator)

Wiring with 2x1.5sq.mm .PVC insulated SC unsheathed FRLS copper conductor of 1100V grade insuitable PVC rigid pipe concealed in wall and ceiling with PVC accessories inflush with wall with 150mmx100mmx113mm TW switch box with 3mm thick hylem sheet cover for 5A3 pin non inter locking wall socket with 5A flush types witch with continuous earth wire connection of 1.5sq.mm copper wire and making good of the concealed portion with suitable colour for concealed PVC plug point

Supply and fixing of single box type 4'36W fluore scentfitting complete with electronic ballast withTW round block son wall or ceiling with flu tube with PVC unsheathed FRLS Copper leads from terminals to the fitting

Supply and fixing of 1200mm (48") AC ceiling fan complete with stepped electronic 300W regulator with 1meter down rod on the existing clamp

Supplying and fixing in position White glazed earthenware Oriya type INDIAN WATER CLOSET of size 580mm x 440mm of approved quality with 'P' (or) 'S' trap confirming to IS:2556 - Part XII with sand cushion and forming flooring around the closet using 40mm broken brick jelly in lime concrete 1:2:5 mix (one lime, two M-sand and five brick jelly) 100m thick and finishing the top to the required slope and including giving necessary connection to the cast iron soil pipes / PVC pipes by dismantling the brick masonry, reinforced concrete roof / floor slab and making good the disturbed portion to original condition without any leakage etc., complete complying with standard specification.

Add G.S.T. @ 18%

A Rajesh Kumar (BID ID -1407787)