RFQ 11382 for Construction of Toilet at KCM area behind Mines Manager office

Earth work in excavation by mechanical means (Hydraulic excavator) / manual means in foundation trenches or drains (not exceeding 1.5 m in width or 10 sqm on plan) including dressing of sides and ramming of bottoms, lift upto 1.5 m, including getting out the excavated soil and disposal of surplus excavated soil as directed, within a lead of 50 m All kinds of soil.

Half brick masonry with F.P.S. bricks of class designation 75 in superstructure above plinth level up to floor V level. Cement mortar 1:4 (1 cement :4 coarse sand)

Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - All work up to plinth level: 1:3:6 (1 Cement : 3 coarse sand : 6 graded stone aggregate 20 mm nominal size).

Brick work with F.P.S. bricks of class designation 75 in superstructure above plinth level up to floor V level in all shapes and sizes in: Cement mortar 1:4 (1 cement: 4 coarse sand)

Random rubble masonry with hard stone in foundation and plinth including levelling up with cement concrete 1:6:12 (1 cement : 6 coarse sand : 12 graded stone aggregate 20mm nominal size) at plinth level with :Cement mortar 1:6 (1

RANDOM RUBBLE MASONRY WITH HARD STONE IN SUPERSTRUCTURE INCLUDING LEVELLING UP WITH CEMENT CONCRETE 1:6:12 ( 1 CEMENT : 6 COARSE SAND :12 GRADED STONE AGGREGATE 20 MM NOMINAL SIZE ) WITH CEMENT MORTAR 1:6 (1 CEMENT : 6 COARS SAND)

15 mm cement plaster on the rough side of single or half brick wall of mix :1:4 (1 cement: 4 fine sand)

20 mm cement plaster of mix :1:6 (1 cement: 6 fine sand)

STONE SOLING UNDER FLOOR INCLUDING FILLING VOIDS WITH STONE CHIPS AND SAND, RAMMING, WATERING AND CONSOLIDATING ETC. COMPLETE

REINFORCED CEMENT CONCRETE WORK IN RAFTS, FOOTING, BASES OF COLOUMNS ETC AND MASS CONCRETE EXCLUDING COST OF CENTERING, SHUTTERING AND REINFORCEMENT ALL WORK UPTO PLINTH LEVEL 1:2:4 ( 1 CEMENT :2 COARSE SAND :4 GRADED STONE AGGREGATE 20 MM NOMINAL SIZE. (CEMENT TO BE ISSUED FREE OF COST BY COMPANY).

Reinforcement for R.C.C. work including straightening, cutting, bending, placing in position and binding all complete. Cold twisted bars

Centering and shuttering including strutting, propping etc. and removal of form for: Suspended floors, roofs, landings, balconies and access platform.

6 mm cement plaster of mix :1:3 (1 cement: 3 fine sand)

Providing and fixing factory made P.V.C. door frame of size 50x47 mm with a wall thickness of 5 mm, made out of extruded 5mm rigid PVC foam sheet, and as per direction of Engineer- in-Charge.

PROVIDING & FIXING OF M.S.BATHROOM LOCKING BOLT OF SIZE 65 M.MX 50 M.M.(WEIGHING NOT LESS THAN 120 GRAMME EACH ) WITH NECESSARY SCREWS.

PROVIDING & FIXING OF OXIDISED M.S. TOWER BOLT BARREL TYPE OF SIZE 100M.M. X 10 M.M.

PROVIDING & FIXING OF OXIDISED M.S.HANDLE OF SIZE 100 M.M.

PROVIDING & FIXING OF S.S.HEAVY WEIGHT BUT HINGES( SIZE 100X75X3 M.M. ) WITH NECESSARY SCREWS .

Providing and fixing factory made panel PVC door shutter consisting of frame made out of M.S. tubes of 19 gauge thickness and size of 19 mm x 19 mm for styles

Providing and fixing G.I. pipes complete with G.I. fittings including trenching and refilling etc. External work15 mm dia. nominal bore

Providing and fixing G.I. pipes complete with G.I. fittings including trenching and refilling etc. External work20 mm dia. nominal bore

Providing and fixing P.V.C. low level flushing cistern with manually controlled device (handle lever) conforming to IS : 7231, with all fittings and fixtures complete.10 litre capacity - White

Providing and fixing white vitreous china water closet squatting pan (Indian type)Orissa pattern W.C. pan of size 580x440 mm

Providing and fixing C. I. P- Trap 100 mm diameter for W.C.

Providing and fixing unplasticised PVC connection pipe with brass unions :45 cm length15 mm nominal bore

White washing with lime to give an even shade: New work (three or more coats)

Finishing walls with water proofing cement paint of required shade :New work (Two or more coats applied @ 3.84 kg/10 sqm).

Providing and fixing white vitreous china wash basin including making all connections but excluding the cost of fittings :Flat back wash basin of size 550x400mm.

Providing and fixing P.V.C. waste pipe for sink or wash basin including P.V.C. waste fittings complete. Semi rigid pipe32 mm dia

Providing and fixing PTMT bib cock of approved quality and colour.15mm nominal bore, 86 mm long, weighing not less than 88 gms

Providing and fixing PTMT pillar cock of approved quality and colour.15 mm nominal bore, 107 mm long, weighing not less than 110 gms

Providing and fixing brass stop cock of approved quality :15 mm nominal bore

Providing and fixing trap of self cleansing design with screwed down or hinged grating with or without vent arm complete, including cost of cutting and making good the walls and floors :100 mm inlet and 100 mm outlet Sand Cast Iron S&S as per IS: 1729.

PROVIDING AND FIXING FOUR LAYER 1000 LITRES CAPACITY PVC WATER TANK WITH TANK NIPPLE AND BRASS FLOAT VALVE COMPLETE

Providing and fixing white vitreous china flat back or wall corner type lipped front urinal basin of 430x260x350mm and 340x410x265mm sizes respectively with automatic flushing cistern with standard flush pipe and C.P. brass spreaders with brass unions and G.I clamps complete, including painting of fittings and brackets, cutting and making good the walls and floors wherever required :Range of two urinal basins with 5 liter white P.V.C. automatic flushing cistern.

Providing and fixing PTMT grating of approved quality and colour. Circular type 100 mm nominal dia

P/F Holdfasts of flat size 35mmx3mm & 150 mm Length for PVC Door frames frames including cutting holes in RRM/Brick walls of size 150x100x100 MM and filling C.C. 1:2:4 in the hole complete.

Providing and fixing trap of self cleansing design with screwed down or hinged grating with or without vent arm complete, including cost of cutting and making good the walls and floors :100 mm inlet and 75 mm outlet Sand Cast Iron S & amp;S as per IS- 1729.

Structural steel work riveted, bolted or welded in built up sections, trusses and framed work, including cutting, hoisting, fixing in position and applying a priming coat of approved steel primer all complete:

Providing and laying vitrified floor tiles in different sizes (thickness to be specified by the manufacturer) with water absorption's less than 0.08% and conforming to IS : 15622 of approved make in all colors and shades, laid on 20mm thick cement mortar 1:4 (1 cement : 4 coarse sand) including grouting the joints with white cement and matching pigments etc., complete. Size of Tile 50x50 cm

PROVIDING AND LAYING CERAMIC GLAZED FLOOR TILES 300X300 MM (THICKNESS TO BE SPECIFIED BY THE MANUFACTURER) OF 1ST QUALITY CONFORMING TO IS : 15622 OF APPROVED MAKE IN COLOURS SUCH AS WHITE, IVORY, GREY, FUME RED BROWN, LAID ON 20 MM THICK CEMENT MORTAR 1:4 (1 CEMENT : 4 COARSE SAND) INCLUDING POINTING THE JOINTS WITH WHITE CEMENT AND MATCHING PIGMENT ETC., COMPLETE.

Providing and fixing G.I. inlet connection for flush pipe connecting with W.C. pan.

Constructing masonry Chamber 60x60x75 cm, inside with 75 class designation brick work in cement mortar 1:4 (1 cement : 4 coarse sand) for sluice valve, with C.I. surface box 100mm. top diameter, 160 mm bottom diameter and 180 mm deep ( inside) with chained lid and RCC top slab 1:2:4 mix (1 cement :2 coarse sand : 4 graded stone aggregate 20mm nominal size ) necessary excavation foundation concrete 1:5:10 (1 cement : 5 fine sand : 10 graded stone aggregate 40 mm nominal size) and inside plastering with cement mortar 1:3 (1 cement : 3 coarse sand) 12 mm thick finished with a floating coat of neat cement complete as per standard design :With F.P.S. bricks

Providing and fixing soil, waste and vent pipes : 100 mm dia. Sand cast iron S&S pipe as per IS: 1729.

Providing and fixing bend of required degree with access door, insertion rubber washer 3 mm thick, bolts and nuts complete.100 mm Sand cast iron S&S as per IS - 1729

Providing and fixing brass stop cock of approved quality :20 mm nominal bore

Providing, laying and jointing glazed stoneware pipes grade ‘A’ with stiff mixture of cement mortar in the proportion of 1:1 (1 cement : 1 fine sand) complete 150 mm diameter