MID/J/118

Foundation and fencing of electric sub-station along with repair of 40 HP starter and other allied electro-mechanical works at LIS Pindi Sarochana New.

Fencing around the electric substation at LIS Pindi Sarochana New of size 10 ft x 12 ft by way of fabrication of angle iron frames with 45 x 45 x 5 mm angle iron and providing, welding and fixing of chain link/ wire mesh fence with gap of 2.5 inch between the frames. These fabricated frames should be fitted and grouted in base. The height of frame should be 5 ft. Fabrication and fixing of entry gate for inspection of transformer with angle iron frame of 45 x 45 x 5 mm MS angle. The door should be of 2 ft width with 5 ft height. Job includes painting of angle iron frame with red oxide primer and black paint. The side of fencing must be removable for lifting of transformer. Clearing of area around the transformer from bushes and debris. Leveling of area around the transformer and compacting the earth with laying of layer of stones. Laying of concrete mixture in ratio of 1:3:6 on 10 ft x 12 ft area around the transformer as per site conditions. Providing and fitting of knife edge link sets of 50/5 size on the HT side over the poles, the job includes providing and fitting of MS angle with clamps as per size of poles for fitting of link sets. The clamps should be fastened with nuts and bolts of required size. Fabrication of new open fuse assembly by means of fabrication of frame for housing new open fuse assembly using MS angle of 45 x 45 x 5 mm. Fabrication and welding the angle for making the frame and then applying one coat of primer for anti-rust and two coats of black paint and then fixing the frame in the earth by means of earth excavation and then filling the earth with cement concrete mix in 1:3:6 ratio. Job also includes providing and installation of new open fuse assembly by means of fixing of L-shaped aluminum bars in frames using ceramic insulators for installation of Al. wire fuse on the input side of the electrical supply on open fuse assembly and then connecting the cable to the one end of the open fuse assembly by way of providing and fixing of Al. thimbles using crimping tool and then making connections using nuts and bolts of appropriate size. Providing and fitting of 300 sq mm single core aluminum cables from LT side of transformer to LT fuse sets. Total length of cables required is 24 meters. The cable is to be divided in 4 parts and each part should be thimbles properly at each end. Connecting of cables to the LT bush rods of the transformer and LT fuse sets. Providing and fitting of 300 mm sq. single core aluminum cable from LT fuse sets to voltage stabilizer inside the pump room. The total length of cable required is 60 meters. Thimbling of both ends of cable and connecting to LT fuse sets and voltage stabilizer inside pump room Repair to 40 HP starter oil immersed, double contact of pumping unit no II at LIS pindi sarochana new by way of extracting the damaged contact points of copper both moving and fixed thimbles, no volt coil, tripping system , overload relay and replacing the same with new ones. Providing /filling of new T-oil 10 liters. The job includes cost of material, labour charges, installation and testing charges at site. Complete job includes cost of material, labour charges, cost of oil, welding charges. Note:- The Tenderers are requested to visit the site and quote the rate as per site conditions. The firm should offer rebate on old material.

Rebate on Old Parts

Shivam enterprises (BID ID -2652767)

M.S J K HYDRAULIC ENGGG AND FABRICATOR WORKS (BID ID -2652757)

M.S J K HYDRAULIC ENGGG AND FABRICATOR WORKS