SPL REPAIRS TO FOOTPATH IN CIRCLE AREA IMPROVEMENT TO ROAD FURNITURE FROM CANARA BANK TO FOUR ARM JN AREA AND PROVN OF WATER TANK STAGING IN GH 1 2 STEEL LADDER ACCESS TO RCC TANK GH 20 TO 22 29 TO 32 38 40 41 AND 42 AT DSSC WELLINGTON

Amount

Excavation over areas, not exceeding 1.5m deep and getting out in hard / dense soil all as specified and directed.

Hardcore of broken stone or boulders of gauge not exceeding 63 mm, deposited, spread and levelled in layers not exceeding 15 cm thick, watered and rammed to a true surface all as specified and directed.

Plain cement concrete 1:4:8 type D-2 using 40mm graded stone aggregate as in sub base to floor 75 mm thick all as specified and directed.

Plain cement concrete type B1, 1:2:4 (using 20mm graded stone aggregate) in coping including necessary formwork all as specified and directed.

Demolition of cement concrete in ground floors and paving not exc. 15 cm thick all as spd

Removal of excavated material exc 1.5 KM and n.exc 5.0 KM and deposited where directed at a level n.exc 1.5M above from starting point.

M&L for precast reinforced cement concrete 1:2:4, type B1, using 20mm graded stone aggregates as in cover slabs for manhole, set in CM 1:4

TMT mild steel bars 10mm dia and over, cut to length, bent to shape required including cranking, bending spirally or hooping for cloumns, hooking ends and binding with and including mild steel wire (annealed) not less than 0.9mm dia or securing with clips complete all as specified.

Sand filling under floor laid in layers n.exc 15 cm thick spread ,levelled and rammed , watering and compacted complete.

M&L for Machine pressed precast conctete interlocking paver block with grey cement and pigmentany shape and size confirming to IS 15658-2006 of 80 mm thickness, M-40 Grade

M&L Chequered cement concrete coloured tiles having hard rubber finish top with polymer admixtures in any pattern or design of min size 30cm x 30 cm x 25 mm thick, set jointed and poited in neat cement slurry in floors over 20 mm thick screed bed in CM mortar 1: 6 all as specified and directed

M&LPrecast cement concrete block Type C1(1:3:6)(using 20 mm graded aggregate) masonry with solid solid blocks exc 10cm width and setting in mortar(1:6) complete.

M&L for rendering 15mm thick in CM 1:4 on fair faces of brick work or concrete surfaces finished even and smooth without using extra cement

Excavating in post holes (or similar holes) each n exc 0.5 cu. m, in hard dense soil, getting out, returning, filling in and ramming earth or broken rubble mixed with earth around, in layers not exceeding 25 cm,

M&L plain cement concrete 1:4:8 type D2 (40 mm graded aggregate) as in foundation filling and mass concrete all as specified and as directed.

S/F Joist, channel, angle ot tee sections, post fixed independently, without connecting plates, etc(cut to ordinary lengths i.e within 20mm of the length indicated quality conforming to Fe 410-W(gde-E-250)quality-A complete all as specified and as directed.

S&F for MS flat iron fillets in posts and struts in fencing ,drilling holes (for securing wire mesh etc),including necessary drilling ,bolting or riveting etc confirming to Fe 410-0or fe 310-0 complete all as specified and as directed.

Supply only Chain link MS galvanised fencing, any size (or) type of 3mm to 4mm dia wire complete all as specified and as directed.

Fixing only chain link fencing including line wires, any mesh, size and type toany type of standards, rails, straning bolts, etc. including provision of binding wire complete all as specified and as directed.

S & F 5 to 10mm mild steel in flat, round (or) square bars, in available length FE 410 W (GDE- E- 250) quality A complete all as specified and as directed.

Refixing of old chain link fencing including line wires, any mesh, size and type toany type of standards, rails, straning bolts, etc. including provision of binding wire

M &L for Welding in repairs n. exc 2.5cm in length N exc 6mm all as specified and directed by Engr-in-Charge

S&F mild stell screw bolts of 11 to 15 mm diameter of shank (machine made ) with hexagonal or squre heads at one end and screwed the other ,each screwed end to to be fitted with washers and one hexagonal or squre nut , exceeding 5 cm and not exceeding 10 cm long complete all as specified and as directed.

M&L for preparing new steel surfaces and applying two coat of synthetic enamel paint over a coat of red oxide primer on steel surfaces of any description over 10 cm width or girth incluidng necessary preparation of surface all as specified and directed.

Dismantling fencing wire mesh any type complete all as specified and as directed.

Dismantling of structural steel work including door gates, grill, framed truss etc.

S & F rolled mild steel section conforming to grade E-165 (Fe-290) framed work as in door or gates of angle or other section with gusset plates rails , braces, etc complete drilled for fixing of steel sheeting or other covering doors, etc to be prepared for hanging or sliding with and including either hooks and hinges or steel hanging door fittings and hanging, fastening, etc complete all as directed by Engr-in-Charge.

Dismantling of Wrought iron (or) mild steel work ,of any descriptionn not otherwise prasided complete all as specified and as directed.

M&L for signage board made of 3mm thick ACP with EGP reflector sheet with printing on HP 365 Traffic edition laminated with 1170 C clear ECF sheet of 900 mm triangular shape complete all as specifed and as directed.

Material and labour for plain cement concrete 1:2:4 type B2, using 40mm graded stone aggregate as in foundation, filling and mass concrete all as specified and as directed.

Excavating in post holes each n.exc 0.50 cum getting out hard dence soil including returning filling in and ramming earth or broken rubble mixed with earth around ,in layers n.exc 25 cm ,watering and removing surplus soil to a distance n.exc 50 mtr and making good surface complete all as specified and as directed.

S/F Joist, channel, angle or tee sections, post fixed independently, without connecting plates, etc(cut to ordinary lengths i.e within 20mm of the length indicated quality conforming to Fe 410-W(gde-E-250)quality-A complete all as specified and directed.

Dismantling of structural steel work ,of any description complete all as specified and as directed.

M&L for preparing new steel surfaces and applying two coat of synthetic enamel paint over a coat of red oxide primer on steel surfaces of any description over 10 cm width or girth incluidng necessary preparation of surface all as specified and directed.

S&F Due directional CAT Eyes (Road Studs) of size 90x110x17mm made up of weather resistant high impact polymer conforming to ASTM D4280 & having electronically welded micro prismatic lens with abrasion resistant coating & fixed with 2 Nos of polymer shanks of suitable dis & suitable adhesive conforming to IS as per procedure recommended by manufacturer and complete all as specified and as direted.

Taking down of old cat eyes complete all as specified and as directed.

Roughening surfaces of old concrete floor by picking, sweeping clean and washing down with water to remove dust, etc. incl Brushing neat cement slurry with 3.0kg of cement per sq. metre

M&LPrecast cement concrete block Type C1(1:3:6)(using 20 mm graded aggregate) masonry with solid solid blocks exc 10cm width and setting in mortar(1:6) complete.

M&L for Plain cement concerte 1:2:4 type B1 using 20 mm graded stone aggregate asas in coping/Pedestal including necessary form work

Rendering 10mm thick cement screed in cement mortar 1:3 mixed with liquid water proofing compound FOSROC's complast 421 IC @ 130ml per bag of cement including a bonding coat of FOSROC's Nito bond AR cement slurry (or) Equivalent as per manufactures instruction on roofcslab/ floor complete all as specified (liquid water proofing compound are measure seperately)

M&L for cleaning the top surface of roof with wire brush and washing with hydrochloric acid to remove dust,dirt,oil,grease loose particles etc and laying 3mm thick APP modified water proofing membrane weighing not less than 3.6 Kg/Sqm, reinforced with non woven polyster matt black finished weighing not less than 100 gm/Sqm having softening point not less than 140 degree celsius longitudinal tensile strength not less than 300 N/Sqm, side lap & end lap 15cm over a coat of bitumen primer @ 0.20 Kg/Sqm and finished with aluminum paint @ 0.10 Ltr/Sqm all as per manufactures instruction and as directed by Engr-in charge. Note : The work shall be carried out by authorised applicators of manufactures.

Taking down steel tubing and connections of 20 mm bore including cleaning for refixing or removal to store complete all as specified and as directed.

Taking down steel tubing and connections of 25 mm bore including cleaning for refixing or removal to store complete all as specified and as directed.

Refixing of old GI steel tubes and connections after cleaning of 20 mm bore in new or old position, any grade, to walls, ceiling, floors, etc complete all as specified and as directed.

Refixing of old GI steel tubes and connections after cleaning of 25 mm bore in new or old position, any grade, to walls, ceiling, floors, etc complete all as specified and as directed.

S&F 20 mm bore Galvanised iron tubing, medium grade, with all fittings laid in trenches, floors or fixed to walls etc complete all as specified and as directed.

S&F 25 mm bore Galvanised iron tubing, medium grade, with all fittings laid in trenches, floors or fixed to walls etc complete all as specified and as directed.

Disconnecting existing tanks exc. 250 lit & n. exc. 500 litres, setting aside (orlowering if required) forrepairs, cleaning, etc. and hoisting if required reconnecting and re-fixing in position and Cleaning and removing all scale and dirt, etc, from tanks and from mouths of circulating pipes, etc

Disconnecting existing tanks500 lit & n. exc. 1000 litressetting aside (orlowering if required) forrepairs, cleaning, etc. and hoisting if required reconnecting and re-fixing in position and Cleaning and removing all scale and dirt, etc, from tanks and from mouths of circulating pipes, etc

M&L for framed work such as grills, gratings, etc.. with ends of bars shouldered and/or riveted, or forged into spikes; framed guard bars; barred iron doors; ladders; framed balusters; walk ways; railings; frame work of water tanks and similar work con- forming to Fe.290.Gde-E-165

M&L for preparing new steel surfaces and applying two coat of synthetic enamel paint over a coat of red oxide primer on steel surfaces of any description over 10 cm width or girth incluidng necessary preparation of surface all as specified and directed.

sree devi construction (BID ID -3232841)

P JAYAPATHY & C0 (BID ID -3233180)

KGP BUILDERS (BID ID -3233507)

ACE PROMOTERS (BID ID -3233173)

P K ENTERPRISES (BID ID -3235974)

VVM CONSTRUCTIONS (BID ID -3233554)