56/HDA/EC OF 2026 2027(2nd call)

Rumble Strips Provision of 3 No.s rumble strips covered with premix bituminous carpet, 15-20 mm high at center, 250 mm wide placed at 1 m center to center at approved locations to control speed, marked with white strips of road marking paint. Tack coat Providing and applying tack coat with paving bitumen of VG-10 grade conforming to IS:73 using emulsion pressure distributor on the prepared bituminous/granular /cement concrete pavement surface cleaned with mechanical broom and high pressure air jet (Reference to MORT&H's specification clause 503) i)On bituminous surface @ 0.20kg 0.3kg /sqm. Ref: Page-111, Sl no.2, B, i -HN sch 2019-2020.

Bituminous Macadam. Providing and laying bituminous macadam with 100-120 TPH hot mix plant using crushed aggregates of specified grading premixed with approved bituminous [email protected]% (min) forGrading-and 3.4% (min) for Grading-2 by weight of total mix, transported to site, laid over a previously prepared base with paver finisher to the required grade, level and alignment and rolled as per clauses 501.6 and 501.7 to achieve the desired compaction (Reference to MORT&H's specification clause 504). ii) for Grading II (19mmnominal maximum aggregate size) Layer Thickness 50-75mm Ref: Page-112, Sl no.3, ii-HN sch 2019-2020. Ref: Derived rate

Open - Graded Premix Surfacing Providing, laying and rolling of open-gradedp remix surfacing of 20mm thickness composed of 13.2 mm to 5.6mm aggregates either using viscosity grade bitumen of approved grade to required line, gradeand level toserveaswearing course on a previously prepared base, including mixing in a suitable plant, laying and rolling with a smooth wheeled tandemor other approved type roller 8-10 tonne capacity, finished to requiredlevel andgrades (ReferencetoMORT&H's specification clause 510). Mechanical method using approved grade Bitumen and HMP of appropriate capacity not less than 75 tonnes/hour. Ref: Page-119, Sl no.10(i) -HN sch 2019-2020.

Providing and laying seal coat sealing the voids in a bituminous surface laid to the specified levels, grade and cross fall using. Type B seal coats (Reference to MORT&H's specification clause 511) Providing and laying of premix sand seal coat with HMP using approved crushed stone chipping and viscosity grade paving bitumen of suitable approved grade. Ref: Page-121, Sl no.12,ii -HN sch 2019-2020.

Road Marking with Hot Applied Thermoplastic Compound with Reflectorising Glass Beads on Bituminous Surface. Providing and laying of hot applied thermoplastic compound 2.5 mm thick including reflectorising glass beads @ 250 gms per sqm area, thickness of 2.5 mm is exclusive of surface applied glass beads as per IRC:35. The finished surface to be level, uniform and free from streaks and holes complete as per Clause 803 of Specifications for Road & Bridge Works of MoRT&H (5th Revision). Page : 146 Item No: 13 PWD NH SOR

18% GST