Road Work

Water Bound Macadam Providing, laying, spreading and compacting stone aggregates of specific sizes to water bound macadam specification including spreading in uniformthickness, hand packing, rollingwith3wheeledsteel/ vibratory roller 8-10 tonnes in stages to proper grade and camber, applying and brooming requisite type of screening/bindingMaterials tofillup the interstices of coarse aggregate, watering and compacting to the required density (Reference to MoRT&H's specification 404). Grading-2 (Table 400-9) (ii) Using Screening (Table 400-10) (ii)(b)Type-B (11.2 mm aggregate), Using N.B variety stone materials.

Prime Coat Providing and applying primer coat with cationic bitumen emulsion SS1 grade conforming to IS:8887 on prepared porous granular surface including clearing of road surface and spraying primer using mechanical means (Reference to MORT&H's specification clause 502). On WMM/WBM surface @ 0.70-1.0kg/sqm.

Repairing Pot-holes with Bituminous Macadam (Grading - II, for compacted thickness of upto 75mm) cum 1111.12 Filling Pot Holes with Bituminous Macadam using Mobile Hot Mix plant (6-10 TPH) with approved crushed aggregates of specified grading premixed with bituminous binder @3.4% by wt. of the total mix, transported to site and laid in the pot hole prepared before hand by cutting the edges to get a firm vertical face and by removing all the failed and loose materials including dust and applying tack coat evenly on the sides and on the surface as per specification, rolling the filled depressionwith 8-10 tonne smooth wheeled roller to achieve the desired compaction, including the cost and carriage of stone aggregates and bitumen, hire charges of machinery and equipment, cost of fuel and lubricants and wages of all operational staff, quality control except the cost of tack coat complete as per direction of Engineer-in-charge. Payment to be made on the basis of the loose net volume of the stone aggregates used in the work.

Open - Graded Premix Surfacing Providing, laying and rolling of open-gradedpremix surfacing of 20mm thickness composed of 13.2 mmto 5.6mmaggregates either using viscosity grade bitumen of approved grade to required line, gradeandlevel toserveaswearing course on a previously prepared base, includingmixing in a suitable plant, laying and rolling with a smoothwheeled tandemor other approved type roller 8-10 tonne capacity, finished to required level andgrades (ReferencetoMORT&H's specification clause 510). Case-I:Mechanical method using approved grade Bitumen and HMP of appropriate capacity not less than 75 tonnes/hour.

Seal Coat Providing and laying seal coat sealing the voids in a bituminous surface laid to the specified levels, grade and cross fall using. Type A and B seal coats (Reference to MORT&H's specification clause 511) Case - II: Type B Providing and laying of premix sand sealcoat with HMP using approved crushed stone chipping and viscosity grade paving bitumen of suitable approved grade

Tack Coat: Providing and applying tack coat with Cationic bitumen emulsion (RS1) complying with IS:8887 using emulsion pressure distributor on the prepared bituminous/granular /cement concrete pavement surface cleaned with mechanical broom and high pressure air jet (Reference to MORT&H's specification clause 503). i)On bituminous surface @ 0.250kg- 0.3kg/sqm.

Tack Coat Providing and applying tack coat with Cationic bitumen emulsion (RS1) complying with IS:8887 using emulsion pressure distributor on the prepared bituminous/granular /cement concrete pavement surface cleaned with mechanical broom and high pressure air jet (Reference to MORT&H's specification clause 503). ii) On Granular surface treated with primer @ 0.275/sqm. Using Cationic RS

Add 18% GST