construction of Sump Well at Village Banwasa on school side, On Chhapra side, On stadium side, Village Kohla, Gharwal on Banwasa minor in Water Service mech. Division,Rohtak

Amount

Earth work in excavation by mechanical means (hydraulic excavator) / manual over areas (exceeeding 30 cm in depth. 1,.5 mtr. in width as weel as 10 sqm in plan) including getting out and disposal of excavated earth lead of 50 mtr. And lift upto 1.5 mtr. As per HSR item no. 4.12 @ 87 / cum

Centering and shuttering of concrete including strutting, prppping etc. and removal of form work for foundation, footing, bases fro columns as per HSR Item No 6.29.1 @ Rs 174 per sqm

Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - All work below plinth level and up to Floor IV level:1 :2 :4 ( 1 Cement : 2 coarse sand (zone-Ill) : 4 graded cum stone aggregate 40 mm nominal size) as per HSR No. 6.1.3 @3836

Providing and laying in position machine batched and machine mixed design mix M-25 grade cement concrete for reinforced cement concrete work, using cement content as per approved design mix, including pumping of concrete to site of laying but excluding the cost of centering, shuttering, finishing and reinforcement, including admixtures in recommended proportions as per IS: 9103 to accelerate, retard setting of concrete, improve workability without impairing strength and durability as per direction of Engineer-in-charge. (Note :- Cement content considered in this item is @ 330 kg/cum. Less cement used as per design mix is recoverable. However no extra payment shall be made if excess cement is used as per design mix).All works above plinth level up to floor IV level as per HSR No. 6.25.2

Centering and shuttering of concrete including strutting, prppping etc. and removal of form work for colums, piers, abutmemnts, pillars, posts and struts as per HSR Item No 6.30.3

Centering and shuttering of concrete for suspanded floors, roofs, landing as per HSR item no. 6.30.20 @ Rs. 489 / sqm

Supply of cold twisted deformed (ribbed/tor steel) bars for RCC works where not included in the complete rate of RCC i/c bending, binding and placing in position complete (HSR item No. 6.33.3) @ Rs 68 per kg

Providing and fixing in position caution iron board 4'x3', 500' U/s & D/s 500' from diversion of channel (NS item )

Supply of MS plates,angles,channel etc. i/c febrication as per HSR BO979 chapter 2