Construction of 33 KV undercground cableLine

Amount

Part -A – Supply of Materials

3x300 mm² ‘XLPE’ cable 33 KV

ST Pole 11 M Long

ACSR Dog conductor

3x300 mm² ‘XLPE’ C/J Kit Outdoor 33 KV

3x300 mm² ‘XLPE’ C/J Kit Straight through 33 KV

Top channel with clamp and nut bolt for ST Pole 11 mtr

M.S. Angle Iron 65x65x6mm bracing (01 No for Shahpur S/S)

33 KV Angle with clamp for cable hanging with complete work at Shahpur S/S

Extra support angle for cable support

Clamp for extra angle

Aluminium Paint

Red oxide Paint

Bolts, Nuts, & Washers

Stay Clamp for ST Pole 11mtr. with Nut and Bolt by 50x8 mm MS Flat Iron make.

stay Rod 20x1800 mm

stay wire 7/8 SWG

P.G. Clamp for Dog

PG clamp for Panther to Dog Conductor

33 KV Polymer Disc Insulator 70 KN

33 KV Polymer Disc Fitting for Dog conductor

33 KV M.S. bracing Angle clamp with nut bolt (Top side) for ST Pole 11 mtr with nut bolt by 50x8 mm MS flat Iron make

33 KV M.S. bracing Angle clamp with nut bolt (Bottom side) for ST Pole 11 mtr with nut bolt by 50x8 mm MS flat Iron make

Special GI Pipe for cable earthing

PART - B- ERECTION OF WORK

Laying of 33 KV 3x300 mm² ‘XLPE’ cable (D/C) by digging pit & making trench in Proper size (1M depth x1M wide) below ground level by fixing bricks(4½˝) on both side of trench wall and 9˝ brick work at the centre of the trench along the cable. Fixing brick slab on top after filling sand around both the cable including cost of bricks and sand/as per site requirement HDD method can be use. It is necessary to use HDPE Pipe and also related materials is provided by contractor. (With GST)

Hanging of 3x300 mm² ‘XLPE’ Cable 33 KV on existing F/P with clamp (with GST)

Rising of 33KV ‘XLPE’ cable in air after providing 6” dia. M.S pipe 3 m long (Complete work with materials).

Special GI Pipe Earthing Complete for 33 KV ‘XLPE’ C/J Kit safety.

Erection of Double pole structure on 11 mtr ST Pole including all works of evocation of pit, pole erection, making plinth for poles 30 cm above, grouting in the ratio 1:4:8 (cement, sand, 40 mm brick ballast), back filling of earth, proper ramming & fitting of all accessories (M.S. angle iron 65 x 65 x 6 mm bracing with clamps, top channel 125 x 65 x 3200 mm with clamps, extra cable support angle, Aluminium paint, red oxide paint etc. complete).

Jointing charges of 33 KV ‘XLPE’ C/J Kit 3x300mm² Outdoor/Straight Through

Grouting of stay rods (20 x 1800) mm including all work of excavation, cement concrete in size (0.60 x 0.60 x 0.30) m in ratio 1:4:8 cement, sand, 40mm brick ballast) as per drg including back filling, proper ramming etc. Fixing tightening & nozzling of stay wire with stay rod with the poles of required tension as per drawing.

Laying, spreading, lifting and final sagging of 3 phases of ACSR Dog conductor in accordance with profile and sag chart including binding, Jumpering and fixing of P.G. Clamp as per requirement in 03 Nos. conductor in parallel.

Digging of existing cable with loop and rising with ne D/P, Disconnection and re-connection of jumper, tree branches cutting for erection of D/P and etc. work for 33/11 KV S/S Raptinagar

disconnection and re-connection of jumper and etc. work at 33/11 KV S/S Shahpur

V.K. TRADERS

M/s Anil kumar singh

M/s S.B.S. Traders