Renewal work on Tundla Etah Road to Bakalpur Via Tatarpur Road ODR in KM 1 to 15, 16(300) by BC in the FY 2025-26

Wet Mix Macadam (Plant Mix Method)Providing, laying, spreading and compacting graded stone aggregate to wet mix macadam specification including premixing the Material with water at OMC in mechanical mix plant carriage of mixed Material by tipper to site, laying in uniform layers with grader in sub- base / base course on well prepared surface and compacting with vibratory roller to achieve the desired density. But Excluding GST

Tack Coat Bituminous surfaces Tack Coat on Bituminous surfaces (Providing and applying tack coat with bitumen emulsion using emulsion pressure distributor at the rate of 0.20 kg per sqm on the prepared bituminous surface cleaned with mechanical broom.) But Excluding GST

Bituminous Concrete Providing and laying bituminous Concrete with 60-90 TPH batch type HMP producing an average output of 75 tonnes per hour using crushed aggregrates of specified grading premixed with bituminous binder, @ 5.4 % of mix and filler, transporting the hot mix to work site, laying with a hydrostatic paver finisher with sensor control to the required grade. level and alignment and rolling with smooth wheeled vibatory and tandem rollers to achive the desired compaction as per MOTRH specification Clause 509 complete in all respect But Excluding GST

Construction of Subgrade and Earthen Shoulders Construction of sub-grade and earthen shoulders with approved material obtained from borrow pits with all lifts & leads, transporting to site, spreading, grading to required slope and compacted to meet requirement of table No. 300-2 But Excluding GST

Road Marking with Hot Applied Thermoplastic Compound with Reflectorising Glass Beads on Bituminous Surface Providing and laying of hot applied thermoplastic compound 2.5 mm thick including reflectorising glass beads @ 250 gms per sqm area, thickness of 2.5 mm is exclusive of surface applied glass beads as per IRC:35 .The finished surface to be level, uniform and free from streaks and holes. composition of thermo plastic material shall be as per level 800-3 of Clause 803 of MoRTH including cost of all material, labour, T&P etc. Required for proper completion of work as per direction by E-in-C in Edge Line, Centre Line & Zebra Crossing etc.Morth 803(8.13) base But Excluding GST

Please Enable Macros to View BoQ information