SPECIAL REPAIR TO ROAD PATH ROAD FURNITURE AT CERTAIN PLACES NEAR OFFRS MD ACCN AT VIKRAM PATH AND SHIVAJI MARG UNDER GE MCTE MHOW

Amount

Dismantling of Stone slabs and tiles, interlocking tiles of any description or thickness in floors, aprons etc complete all as directed.

Demolition Concrete in ground floors and pavings n exc 15 cm thickness (below or above ground level) etc complete all as directed.

Excavation in trenches, n exc 1.5 m wide and not exc 1.50m in depth and getting out in any type of soil complete all as specified and directed.

Removing excavated material exc. 50m and and n.exc 100m, depositing where directed at a level n exc. 1.5 m above the starting point complete

M&L for PCC 1:2:4 type B-1 using 20 mm graded crushed stone aggregate in roof kerbs or mud stops, coping, rounded or chamfered on edges of interlocking tiles etc all as directed.

M&L for Sand filling under floors or in foundations including watering and consolidation complete all as directed.

M&L for PCC (1:4:8), 150mm thick, type D-2 using 40 mm graded stone aggregate in sub base for receiving interlocking tiles, chequerred cement tiles etc complete all as specified and directed.

M&L for PCC (1:4:8), 100mm thick, type D-2 using 40 mm graded stone aggregate in sub base for receiving interlocking tiles, chequerred cement tiles etc complete all as specified and directed.

M&L for Machine pressed precast concrete interlocking paver block any shape and size confirming to IS 15658-2006 of 80 mm thickness M-40 Grade, with using grey cement and not pigment complete all as specified

M&L for Machine pressed precast concrete interlocking paver block any shape and size confirming to IS 15658-2006 of 60 mm thickness M-35 Grade, with using grey cement and not pigment complete all as specified

M&L for 150mm thick Soling (or sub base) with broken boulders or quarried stone, inter stices filled, surface formed and rolled and consolidated to required gradient and camber complete all as specified and directed.

Preparing the black top surfaces of roads by brushing with wire brushes for removing caked mud etc and sweeping with brooms and finally fanning to clear the surface with gunny bags to remove all loose dirt etc and applying evenly a priming/ tack coat with paving bituminous primer VG- 30 at the rate of 5 kg per 10 sqm of road surface by using paving bitumen binder over black top surfaces and applying premixed hot mix Asphaltic Semi Dence Concrete using 5.5% binder content (VG-30 Grade paving bitumen) by weight of total mix and with thickness of 25 mm (consolidated Thickness) including rolling with 8 to 10 tonne power road roller to uniform and smooth surface and consolidation to required gradient and camber all as specified and directed. (Note: - (i) Laying shall be done by means of self-propelled mechanical paver, finishing with electronic sensor and hydraulic controls with suitable speed and capable of laying, spreading, tamping and finishing. (ii) Mix shall be obtained from hot mix plant and spreading shell be done by using mechanical paver only)complete all as specified and directed

M&L for preparation of concrete or plastered surfaces of any description over 10cm girth or width, not otherwise described and applying two coats of plastic emulsion paint over a coat of concrete primer complete all as specified and directed.

M&L for preparation of road surfaces and applying road marking paint in marking of minimum 2.5mm thick single coat as in centre line and edge line road marking in white/yellow (approved colour) colour & shade of 150/100mm width using 'HOT MARK' thermoplastic modern propelled road marking machine all specified & directed.

M & L for pre-cast cement concrete masonry block, type B0 1:2:4 (unsing 12.5mm graaded stone aggt) of size 30cm(length) x 30 (height) x 80 mm thick all surfaces finished even and smooth without using extra cement incl jointing in cement mortar 1:4 complete all as specified and directed Note : One edge of PCC block should be (i.e. 30cm long side) slightly rounded/chamfered shaped and no additional cost to be paid for the same) .

S & F in repair Cat eyes of approved quality aluminium dye ast body fixed on roads including drilling for fixing with cement mortar or with adhesive complete all as specified and directed by Enge-in-Charge. (Make - 3M/Sun Eyes/Dark Eye)

S & F in repair Solar road stud two way reflective 125mm x 125mm x 25 mm, aluminium alloy with 6 Nos LED Light complete. (Make - 3M/Sun Eyes/Dark Eye)

S & F in repair delinator 50mm dia pipe, 750mm long with black painted in top cover with 50mm wide reflective tape in three colours including all necessary earth work, PCC 1:2:4 type B1 of size 150x150mm x200mm, complete all as specified and directed by Engr-in-Charge. (Make - Dark Eye or equivalent of 3M/Alcolite/solar/SUNEYES)

Bharadwaj Builders

KAILASH CHANDRA KHANDELWAL

J B CONSTRUCTION AND DEVLOPERS