Construction of RCC culvert at Gubinjan to Tamarchuk Bridge to Major Chapori Road under SOPD-G for the year 2025-26.

Amount

Construction of embankment with approved material obtained from borrow pits with a lift upto 1.5 m, transporting to site, spreading, grading to required slope and compacting to meet requirement of Tables 300.1 and 300.2 with a lead upto 1000 m as per Technical Specification Clause 301.5 (i) Private Land

Construction of subgrade and earthen shoulders with approved material obtained from borrow pits with all lifts and leads, transporting to site, spreading, grading to required slope and compacted to meet requirement of Table 300.2 with lead upto 1000 m as per Technical Specification Clause 303.1. (i) Private Land

Construction of granular sub-base by providing well graded material, spreading in uniform layers with motor grader on prepared surface, mixing by mix in place method with rotavator at OMC, and compacting with smooth wheel roller to achieve the desired density, complete as per Technical Specification Clause 401. (ii) For Grading II Material

Earthwork in excavation for structures as per drawing and technical specifications Clause 305.1 including setting out,construction of shoring and bracing ,construction of shoring and bracing removal of stumps and other deleterious material and disposal upto a lead of 50 m ,dressing of sides and bottom and backfilling in trenches with excavated suitable material

Providing concrete for plain /reinforced concrete in open foundations complete as per drawingsand technical specifications Clause 802,803,1202 &1203

Providing concrete for plain /reinforced concrete in open foundations complete as per drawingsand technical specifications Clause 802,803,1202 &1203

Plain / reinforced cement concrete in substructure complete as per drawings and technical specification Clauses 802,804 ,805 ,806,807,1202 and 1204

Supplying, fitting and placing TMT (Fe-500 D) reinforcement bar (From Primary Producer: TATA/SAIL/Esser Steel/ Jindal steel/Shyam steel/RINL) in substructrue complete as per drawings and technical specification Clauses 1002, 1005, 1010 & 1202

Providing and laying cement concrete wearing course M 30 grade including reinforcement complete as per drawing and technical specifications Clauses 800 and 1206 .3

Drainage spouts complete as per drawing and technical specifications Clause 1209

Backfilling behind abutment ,wing wall and return wall complete as per drawings & technical specification Clause 1204 .3.8

Providing weepholes in brick masonry / stone masonry ,plain / reinforced concrete abutment wing wall ,return wall with 100 mm dia AC pipe extending through the full width of the structures with slope of 1 ( V ) :20 ( H ) towards drawing face complete as per drawing and technical specification Clauses 614 ,709 ,1204 .3.7

Providing and laying filter media with granular crushed aggregates as per specification to a thickness of not less than 600 mm with smaller size towards the soil and bigger size towards the wall and providing over the entire surface behind abutment ,wing wall ,return wall to the full height ,compacted to firm condition complete as per drawing and technical specification Clause 1204 .3.8

Construction of R.C.C. railing of M 25 grade in cast-in-situ with 20 mm nominal size aggregate, true to line and grade, tolerance of vertical railing post not to exceed 1 in 500, centre-to-centre spacing between vertical posts not to exceed 2000 mm as per drawing and technical specifications Clauses 800, 900 and 1208.3

Providing and fixing 20 mm thick compressible fibre board in expansion joint complete as per drawing and technical specifications

Providing and fixing of typical informatory sign board with Logo as per MORD specifications and drawing. Three MS Plates of 1.6 mm thick, top and middle plate duly welded with MS flat iron 25mm x 5m size on back on edges. The lower plate will be welded with MS angle iron frame of 25mm x 25mm x 5mm. The angle iron frame of the lower most plate and flat iron frame of middle plate will be welded to 2 nos. 75mm x 75 mm of 12 SWG sheet tubes posts duly embedded in cement concrete M-15 grade blocks of 450mm x 450mm x 600mm, 600mm below ground level. The top most diamond plate will be welded to middle plate by 47mm x 47mm of 12 SWG steel plate tube. All M.S. will be stove enameled on both sides. Lettering and printing arrows, border etc. will be painted with ready mixed synthetic enamel paint of superior quality in required shade and colour. All sections of framed posts and steel tube will be painted with primer and two coats of epoxy paint as per drawing Clause 1701 and Annexure 1700.1

Arun Kumar Pegu (BID ID -288572)