8491 PROVISION OF RCC FOUNDATION WITH PLATEFORM AND SECURING ARRANGEMENTS FOR INSTALLATION OF HIGH MAST FLAG POLE AT ND MBI PROVISION OF 80 KVA UPS FOR COMMUNICATION NETWORK CENTRE AT INS ANGRE UNDER GE NW KUNJALI PROVISION OF 03 Nos SPLIT AC IN NATA

Amount

Demolition of brick work or stone/boulder masonry, built in cement mortar including all quoins, arches, pillars etc but excluding ashlar facings, dressed stone work and precast concrete articles and disposing off complete all as specified and as directed

Demolition of reinforced cement concrete in ground floor and paving n exc 15 cm thickness (below or above GL).

Excavating in trenches, n exc 1.5m wide and n exc 1.5 m depth; for foundation, etc. or for shafts, wells, cesspits, manholes,pier holes, etc. n exc 10 sq m on plan and n exc 1.5m in depth and getting out asdisintigrated rock.

Excavating in trenches, n exc 1.5m wide and exc 1.5 m depth; but nexc 3 M for foundation, etc. or for shafts, wells, cesspits, manholes,pier holes, etc. n exc 10 sq m on plan and n exc 3m in depth and getting out as in disintigrated rock.

M&L for Hardcore of gauge n exc. 63 mm, deposited, spread and levelled in layers n exc. 15 cm thick, watered and rammed to a true surface. All as specified and directed.

M&L for PCC 1:4:8 type D 2 using 20mm graded stone agreegate as in foundation, filling or mass concrete.

Dismantling floor hearth or wall tiling including cement mortar bedding (but not backing ) and rabbish of the premises.

M&L for RCC M-40 using 20mm graded agg in foundation, incl rafts, footing, foundation beams, plinth beams, bases for column etc.

M&L for RCC M-40 using 20mm graded agg in columns, piers, pillars, posts and struts.

Form work to sides of concrete fdn, footingm bases of coln, raft and raft beams, sides and soffits (if any) of fdn and plinth beams and similar works, vertical or to better rough finished flat surfaces of concrete.

M & L for TMT bars of 10mm dia and over, cut to length bent to shape reqd incl cranking bending spirally for hooping for coln, hooking ends and binding with MS wite (annealed) not less than 0.9mm dia or securing with clips quality confirming to.

All as per item No 11 above but 6mm to 8mm dia bar

Returning filling of earth in trenches including spreading, levelling, watering and well ramming in layers n exc 25 cm thick

M & L for Sand filling under floors or in foundations including watering and consolidation complete all as psecified.

M & L for Cement concrete type B-1, 1:2:4 (20mm graded aggregate) 100mm thick

M&L for rendering 15 mm thick in CM 1:6 on fair faces of brick work or concrete surfaces finishing the surface even and smooth with and including 1 mm thick sagol finish complete allcomplete all as specified and directed.

M&L for plastering in CM 1:4, 20 mm thick in two coats (15 mm under coat plus 5mm finishing coat) with water proofing compound at the rate of 2% by weight of cement and finishing the surface seven and fair complete all as specified and as directed.(WPC will be measured and paid seperately).

Supply only integral water proofing compound

S&F in repairs stainless steel railing complete all as specified and as directed.

M & L for preparation of new steel surfaces exc 10 cm width or girth and applying two coats of synthetic enamel paint over a coat of red oxide primer.

M&L for PCC 1:2:4 type B2 using 40 mm graded stone agreegate as in surface channels and drains.

M&L for PCC 1:2:4 type B0 using 12.5 mm graded stone agreegate as in coping.

S&F 150 mm bore Reinforced concrete pipes, class NP2, laid and jointed complete with collars

Removing excavated material and debris exc. 1.50 Km but n exc. 15 Km and depositing where directed, in soil.

M&L brick work with sub class B bricks straight or curved on plan to any radius built in CM 1:6 all as specified.

M&L for 20 mm thick Granite (of any type) tiles 20mm thick machine cut, bedded and jointed with grey cement slurry and pointed with white cement with admixture of pigment to match the shade of granite stone including grinding and polishing complete and 20 mm thick screed bed in cement mortar 1:4 complete all as specified and directed. (colour of granite will be decided by the GE/Engr-in-Charge).

Supply, install, Testing and commissioning BE promt Online Double conversion IGBT 80 KVA UPS with inbuilt isolation transformer, 3 phasse input output 3 phase including rack & links, Connection of cable etc complete as directed. Make Unitech/Addon/Numberic (Note : UPS Warranty should be of 12 Months)

Supply, install, Test and commissioning 1 Hrs backup 12V/200Ah x40 Nos SMF batteries including connected all accessories etc complete all as specified and directed by EIC. Make : Exide/Amron (Note : Battery Warranty should be of 24 Months)

Supply & Fixing MS Powder coating Battery Stand (02 Nos ) and also with interlink wires , Battery fuse ups to Battery Terminal Lead wires Set of copper 16 sqmm & 35 Sqmm all as specified and directed by EIC.

M&L for sub-main wiring with 2 runs of 4.0sqmm copper conductor cable (FRLS grade), 1100 volts grade PVC insulated and unsheathed multi-stranded, drawn in and including heavy grade PVC casing caping not less than 25mm dia (internal width) with all accessories like tees, elbows, junction boxs, reducer etc as required, including one run of 4.0sqmm dia PVC insulated unsheathed copper conductor cable as earth dolly/mains, with all accessories like PVC elbow, PVC tee, etc including taking up/down old unserviceable sub main wiring and making good the disturbed surfaces/location complete all as specified and directed. Note: (a) Colour coding shall be followed as (i) Phase- Red/Yellow/Blue (ii) Neutral - Black (iii) Earth - green (b) Make of wire : Polycab/ Havells/ Finolex/Gloster (c) Make of PVC casing capping/Conduit :- Precision/ pesto plast / National/Plaza

M&L for sub-main wiring with 2 runs of 6.0sqmm copper conductor cable (FRLS grade), 1100 volts grade PVC insulated and unsheathed multi-stranded, drawn in and including heavy grade PVC casing caping not less than 25mm dia (internal width) with all accessories like tees, elbows, junction boxs, reducer etc as required, including one run of 4.0sqmm dia PVC insulated unsheathed copper conductor cable as earth dolly/mains, with all accessories like PVC elbow, PVC tee, etc including taking up/down old unserviceable sub main wiring and making good the disturbed surfaces/location complete all as specified and directed. Note: (a) Colour coding shall be followed as (i) Phase- Red/Yellow/Blue (ii) Neutral - Black (iii) Earth - green (b) Make of wire : Polycab/ Havells/ Finolex/Gloster (c) Make of PVC casing capping/Conduit :- Precision/ pesto plast / National/Plaza

M&L for sub-main wiring with 2 runs of 10.0sqmm copper conductor cable (FRLS grade), 1100 volts grade PVC insulated and unsheathed multi-stranded, drawn in and including heavy grade PVC casing caping not less than 25mm dia (internal width) with all accessories like tees, elbows, junction boxs, reducer etc as required, including one run of 4.0sqmm dia PVC insulated unsheathed copper conductor cable as earth dolly/mains, with all accessories like PVC elbow, PVC tee, etc including taking up/down old unserveceable sub main wiring and making good the disturbed surfaces/location complete all as specified and directed. Note: (a) Colour coding shall be followed as (i) Phase- Red/Yellow/Blue (ii) Neutral - Black (iii) Earth - green (b) Make of wire : Polycab/ Havells/ Finolex/Gloster (c) Make of PVC casing capping/Conduit :- Precision/ pesto plast / National/Plaza

S&F in repair sheet metal enclosure TPN DB VTPN 8 Way,415V with 250A copper busbar, double door type IP-54, IK-09 protection suitable for housing MCCB 100Amp 4 pole all as specified and directed by EIC. Make: Siemens/Scinder/C&S Note : DBs shall be conceeled in wall where ever posible including making good the surface to match with surrounding. Make: Legrand/ Seimens/GE

Supply and fix Single pole and neutral enclosure with a two pin and earth plug and socket complete with one single pole MCB 20 Amps 240V all as directed. Make - Legrand cat part no- 507811

S & F MCCB FP 160 Amps,16KA, complete all as specified and directed. Make: C&S/ Legrand/Havells

S & F MCB SP 6-32 Amps,10KA, 'C' curve, Make: C&S/ Legrand/Havells

S & F MCB SPN 40 Amps,10KA , 'C' curve Make: Make: C&S/ Legrand/Havells

Supply, fabrication, installation, testing & commissioning of LT Panel board / Feeder piller box, in door type, dust and vermin proof, made out of 2mm thick CRCA sheet, front & back openable doors having vertical Alum bus bar of capacity 1000 amps for phases and for neutral including powder coated painting, internal wiring with suitable size of stranded copper conductor cable, PCC foundation, supporting channels,cable termination,cable gland etc complete at MWC including taking down old panel all as directed and suitable to accommodate the following switch gears and meters :- INCOMER i) MCCB 200 Amps 4 pole,36 KA,Thermal magnetic - 2 Nos (Incomer) ii) Manual Change over 160 amps 4 pole OUTGOING i) MCCB, 4 pole 160 Amps,25KA,Thermal magnetic - 3 Nos (Out going) ii) MCB 32 Amps 3 TP, 10 KA ,Thermal magnetic - 2 Nos (Out going) iii) VAF meter class 1with CT's - 1 No iv) indication lamps (R,Y,B) LED type - 1 set MAKE of MCCB : Schinder/ Legrand/Seimens/L & T

Supply, fabrication, installation, testing & commissioning of LT Panel board / Feeder piller box, in door type, dust and vermin proof, made out of 2mm thick CRCA sheet, front & back openable doors having vertical Copper bus bar of capacity 1000 amps for phases and for neutral including powder coated painting, internal wiring with suitable size of stranded copper conductor cable, PCC foundation, supporting channels,cable termination,cable gland etc complete at MWC including taking down old panel all as directed and suitable to accommodate the following switch gears and meters :- INCOMER i) MCCB 160 Amps 4 25 KA,Thermal magnetic - 2 Nos (Incomer) ii) Automatic Transfer Switch (ATS) 160 amps 4 pole - 01 Nos OUTGOING i) MCCB, 4 pole 160 Amps,25KA,Thermal magnetic - 1 Nos (Out going) ii) VAF meter class 1with CT's - 1 No iii) indication lamps (R,Y,B) LED type - 1 set MAKE of MCCB : Schinder/ Legrand/Seimens/L & T

Supply, install, Testing and commissioning wall mounted Split type AC 1.5 TR capacity units indoor/outdoor complete with cordless remote control unit, 220-240 volt, 50Hz, single phase fitted with high quality rotary compressor and with in built air ioniser and Plasma filter for better indoor air quality with minimum 3 star rating and EER 3.2 star rating complete as directed. Note : (a) Rate of supporting brackets for outdoor unit is deemed to be included in rate quoted.Make : Daikin/Hitachi/LG/ Blue star

Supply, install, Testing and commissioning wall mounted Split type AC 2.0 TR capacity units indoor/outdoor complete with cordless remote control unit, 220-240 volt, 50Hz, single phase fitted with high quality rotary compressor and with in built air ioniser and Plasma filter for better indoor air quality with minimum 3 star rating and EER 3.2 star rating complete as directed. Note : (a) Rate of supporting brackets for outdoor unit is deemed to be included in rate quoted.Make : Daikin/Hitachi/LG/ Blue star

Supply, fixing and clamping , jointing copper tubing for suction line and for liquid discharge line insulated with suitable insulation material including making hole in wall for passing through and making good disturbed surface complete.

S & F PVC non metallic conduit 20mm dia with complete tees, bends, elbows, reducers, mouth ends fixing accessories such as saddles, full threaded screws etc on walls/ roofs all as specified and directed.

shubham construction