Construction of Boiler Room for Central Heating of Accident and Emergency Block SNM Hospital Leh.

Amount

Earth work in bulk excavation by mechanical means (hydraulic excavator) over areas (exceeding 30 cm in depth, 1.5 m in width as well as 10 m2 on plan) including disposal of excavated earth lead upto 50 meters and lift upto 1.5 m, as directed by Engineer-in-Charge. All kinds of soil :

Providing and laying in position cement concrete of specified grade including curing but excluding the cost of centring and shuttering. All work upto plinth level with: 1:4:8 (1 cement : 4 coarse sand : 8 graded stone aggregate 40 mm nominal size

Dumping of stone including cost of stone including cost of stone (on horizontal)

Random Rubble masonry with hard stone in foundation and plinth including leveling up with cement concrete 1:6:12 (1 Cement : 6 coarse sand : 12 graded stone aggregate 20mm nominal size) upto plinth level and curing complete with: Cement mortar 1:6 (1 Cement : 6 coarse sand

Providing & fixing upto floor five level precast cement concrete solid blocks including hoisting and setting in position in cement mortar 1:3 (1cement:3 coarse sand), cost of required centring, shuttering and curing complete 1:3:6 (1 cement : 3 coarse sand : 6 graded crushed stone aggregate 20 mm nominal

Reinforced cement concrete work in walls (any thickness) including attached pilasters, buttresses, plinth and string courses, fillets, columns, pillars, piers, abutments, posts and struts upto floor five level including curing but excluding cost of centering shuttering, finishing and reinforcement. 1:1½:3 (1 cement : 1½ coarse sand : 3 graded stone aggregate 20 mm nominal size)

Steel reinforcement for R.C.C. work including straightening, cutting, bending, placing in position and binding all complete upto plinth level Thermo-Mechanically Treated bars of grade Fe-500D or more

Cement concrete flooring 1:2:4 (1cement: 2 coarse sand: 4 graded stone aggregate) finished with a floating coat of neat cement including cement slurry and curing complete, but excluding the cost of nosing of steps etc. complete. 50 mm thick with 20mm nominal size stone aggregate.

15 mm cement plaster on the side of single or half brick wall finished with a floating coat of neat cement of mix : 1:4 (1cement : 4 fine sand )

Centering and shuttering including strutting, propping etc. and removal of form work for: a)Foundations, footings, bases for columns

b) Lintel, beams, plinth beams, girders, bressumers and cantilevers.

c)Columns, pillars, piers, abutments, posts and struts

d) Suspended floors, roofs, landings, balconies and access platform

Providing wood work in frames of doors, windows, clerestory windows and other frames, wrought framed and fixed in position with hold fast lugs or with dash fasteners of required dia and length (hold fast lugs or with dash fasteners shall be paid for separately Second class kail wood

Providing and fixing panelled or panelled and glazed shutters for doors,windows and clerestory windows (Area of opening for panel inserts excluding portion inside grooves or rebates to be measured ) .Panelling for panelled or panelled and glazed shutters 25 mm to 40 mm thick . Second kail wood

Providing and fixing glazed shutters for doors, windows and clerestory windows using 4mm thick float glass panes including ISI marked M.S. pressed butt hinges bright finished of required size with necessary screws 35 mm Second class Kail wood

12 mm thick pre- laminated particle board ( decorative lamination on one side and other side balancing lamination ) grade -I, medium density flat pressed three layer particle board FPT-I or graded wood particle board FPT-I, IS : 3087 marked, bonded with BWP type synthetic resin adhesive as per IS : 848 and pre laminated conforming to IS : 12832, Grade -I , type -II marked

Providing and applying white cement based putty of specified thickness, of approved brand and manufacturer, over the plastered wall surface to prepare the surface even and smooth complete 1 mm

Distempering with oil bound washable distemper of approved brand and manufacture to give an even shade on New work (two or more coats) over and including priming coat with water thinnable cement primer

Rough cast plaster upto 10 m height above ground level with a mixture of sand and gravel or crushed stone from 6 mm to 10 mm nominal size, dashed over and including the fresh plaster in two layers, under layer 12 mm cement plaster 1:4 (1 cement: 4 coarse sand) and top layer 10 mm cement plaster 1:3 (1 cement: 3 fine sand) mixed with 10% finely grounded hydrated lime by volume of cement. Ordinary cement finish using ordinary cement

Finishing wall with water proffing cement paint of required shade on new work (two or more coat applied 3.84 kg/10 sqm)

6 mm cement plaster to ceiling of mix 1:3 (1 cement , 3 fine sand)

Providing and fixing bright finished brass tower bolts (barrel type ) with necessary screws etc complete a)250x10mm

Providing and fixing ISI marked oxidised M.sS handles conforming to IS : 4992 with necessary screws etc complete: a)125mm

Providing and fixing ceramic glazed floor tiles 300x300 mm thickness to be specified by manufacture of 1st quality conforming to IS : 13755 of NITCO , ORIENT ,SOMANY ,KAJARIA make in colour such as white , ivory ,grey, fume , red , brown laid on 20mm thick bed of cement mortar 1:4

Providing and fixing 1st quality ceramic glazed floor tiles conforming toIS : 15622 (thickness to be specified by the manufacturer ) of approved make in all colours, shades except burgundy, bottle green, black of any size as approved by Engineer-in-Charge in skirting, risers of steps and dados over 12 mm thick bed of cement Mortar 1:3 (1 cement: 3 coarse sand) and jointing with grey cement slurry @ 3.3kg per sqm including pointing in white cement mixed with pigment of matching shade complete.

Providing and fixing precoated galvanized iron profile sheets (size, shape and pitch of corrugation as approved by Engineer-in-charge) 0.50 mm (+ 0.05 %) total coated thickness with zinc coating 120 grams per sqm as per IS: 277, in 240 mpa steel grade, 5-7 microns epoxy primer on both side of the sheet and polyester top coat 15-18 microns. Sheet should have protective guard film of 25 microns minimum to avoid scratches during transportation and should be supplied in single length upto 12 metre or as desired by Engineer-in-charge. The sheet shall be fixed using self drilling /self tapping screws of size (5.5x 55 mm) with EPDM seal, complete upto any pitch in horizontal/ vertical or curved surfaces, excluding the cost of purlins, rafters and trusses and including cutting to size and shape wherever required

Structural steel work in built up sections, trusses and framed work, including cutting, hoisting, fixing in position and applying a priming coat of approved steel primer all complete welded

Providing and fixing water closet squatting pan (Indian type W.C.pan ) with 100 mm sand cast iron Por S trap, 10 litre low level white P.V.C flushing cistern , including flush pipe,with manually controlled device (handle lever ) conforming to IS: 7231, with all fittings and fixtures complete including cutting and making good the walls and floors wherever required . Orissa pattern W.C pan of size 580x440 mm with integral type foot rest

Providing and fixing wash basin with C.I /M.S brackets 15 mm C.P brass pillar taps , kingstone / Gem / technology / Parko /Jaguar / Escko , 32 mm C.P brass waste of standard pattern including painting of fittings and brackets, cutting and making good the walls White Vitreous China wash basin size 630x450 mm with a pair of 15 mm C.P brass pillar tap

Providing and fixing white vitreous China pedestal for wash basincompletely recessed at the back for the reception of pipesand fittings

Providing and fixing white vitreous China flat back half stall urinal basin basin of 580x380x350 mm with Flat white P.V.C automatic flushing cistern ,of approved make with fittings , C .I/ M.S brackets , standard size of C.P brass flush pipe,spreaders with unions and clamps complete , (all in C.P brass ) with waste fitting as per IS : 2556, C.I trap with outlet grating and other couplings in C.P brass including painting of fittings and brackets, cutting and making good the walls and floors wherever required : one urinal basin with 5 litre P.V.C white automatic flushing cistern of approved quality.

Providing and fixing 600x450 mm bevelled edge mirror of superior glass (of approved quality ) complete with 6 mm thick hard board ground fixed to wooden cleats with C.P brass screws and washers complete.

Providing and fixing PTMT waste couping for wash basin and sink of approved quality and colour .Waste coupling 38 mm of 38 mm length not less than 60 gms

Providing and fixing PVC, waste pipe for sink or basin including P.V.C waste fittings complete .Semi rigid pipe 32 mm dia

Providing and fixing CP brass towel rail complete with brackets fixed to wooden cleats with CP brass screws with concealed fitting arangement of approved quality colour and make (Prayag or equivalent) 600 mm long towel rail with total length of 645 width, 78 mm wide and effective high of 88 mm , weighing notless than 190 gms

Providing and fixing CP brass toilet paper holder C.P brass

Providing and fixing soap dish of C.P brass and 112 mm distance from wall of standard shape with bracket of the same materials with snap fittings of approved quality colour and make, weight not less than 105gms (Prayag or equivalent)

Providing and fixing soil, waste and vent pipes PVC 100 mm @6 kg/rm

PVC 75 mm @6 kg/rm

Providing and fixing 100 mm sand cast iron grating for gully, floor or Nahani trap.

Providing and fixing P.trap for English type w.c washer and m.s claps complete job.

Providing and fixing double equal plain junction of required degree 75x75x75 pvc as per

100x100x100 pvc as per

Providing and fixing 3 layer PP-R (Ploy propylene Random copolymer ) pipes SOR 7.4 UV stablized and anti microbial fusion welded , having thermal stability for hot and cold water supply including all PP-R plain and brass threaded Polyproplene random fittings 1/C fixing the pipe with clamps at 1.00 m spacing .This includes cost of cutting chases and making good the same including testing of joints complete as per direction of engineer-in -charge.(concealed work including cutting chases and making good the walls etc) 16 mm OD nominal bore

32 mm dia nominal bore

40 mm dia nominal bore

Providing and fixing C.P brass bib cock of approved quality conforming to IS: 8931 15 mm nominal bore

Providing and fixing uplasticised PVC connection pipe with brass unions 30 mm length 15 mm nominal bore

Providing and fixing C.P brass angle valve for basin mixerand gyser points of approved make conforming to IS: 8931 15 mm nominal bore

Providing and fixing C.P brass close hole basin mixer pillar tap of approved quality and make , weighing not less than 1.970 kg 15 mm nominal bore of standard back type

Providing and placing on terrace (at all floor levels) polyethylene water storage tank ISI: 12701 marked indicating the BIS License No with civer and suitable locking arrangemnets and making necessary holes for inlet , outlet and overflow pipes but without fittings an dthe base support for tank (Sintex ,Electroplast ,Star, Lotus or equivalent having valid ISI license

Making connection of PPR distribution branch with G.I main of following sizes by providing and fixing tee, including cutting an dthreading the pipe etc.complete 20 to 32 mm nominal bore

Providing and fixing pvc gate valve with complete job 32 mm dia pipe

Providing and fixing of puff insulation including covering with wire meshing and aluminium sheet of 0.6 mm thick complete job 32-40mm dia

Providing and fixing heat tape 30watts of multi layer including wiring over pipe line in spring shape all complete job

Providing and fixing thermocold flex over pipe line for insulation all complete job

M/S MOHAMMAD IBRAHIM