59/W/EDC II/SRE/2024-25

Amount

Detail of Work

Safely carriage of PCC/ST poles up to 11 Mtr. Long from ESC, SRE to site of work including loading & unloading at both ends..

Safely carriage of other complete line material (Except PCC/ST Poles) from ESC, SRE to site of work including loading, unloading at both ends.

Safely carriage of 11 KV XLPE cable size 3x120 sq mm from ESC, SRE to site of work including loading & unloading at both ends..

Erection of single support on PCC/ST poles up to 11 Mtr. Long) with complete fitting of all accessories of 11 KV /LT line/33 KV line. complete.

Providing of Nut and bolts OFF size.

Providing & Fixing Stone pad 300x300x75 mm

Providing of Red oxide Paints (British/Asian/enamel paint)

Providing of Alluminium Paint (British/Asian/enamel paint)

Providing and fixing of Number plate with clamp on the each pole.

Providing and Fixing 11 KV Danger board with clamp nuts & bolts. for PCC Poles made of 3mm thick foam sheet (8" X 6") with

Providing and Fixing 33 KV Danger board with clamp nuts & bolts. for ST Poles made of 3mm thick foam sheet (8" X 6") with

Providing of all type clamps with nuts and bolts made by MS flat size 50x6.

Earthing of poles by earthing rod of 20x2500 mm with G.I wire etc.

Concreting of PCC/ST pole with cement concreting in block of 600x600x1500 mm in ratio 1:4:8 with cement, sand and brick ballast size 1x1.5”

Grouting of 33 KV stay rods by digging of pits in block of 600X600X300 mm. and nozzling of stay wire 7/10 SWG and fitting the same on the pole

Painting of ST poles 11 Mtr, SP-55 with 2 coats of synthetic enamel paint after one coat of ready mix primer as well as rubbing/cleaning of surface as required for proper completion of work. and remaining by Aluminium paint including all

Laying, lifting, stringing, sagging jumpering & binding of ACSR Rabbit/Dog Conductor for 11KV/LT Line/33 KV line as per RESPO specification

Removal of old & used scrap XLPE cable from the existing 11 KV line with making roll of XLPE cable and safely carrige from site to ESC, SRE including loading and unloading at both ends.

Fixing & Making of 11 KV Cable box.

Removal of old & used conductor from the existing 11 KV/33 KV line with making roll of conductor and safely carrige from site to ESC, SRE including loading and unloading at both ends.

Fabrication charges of Angle & Channal

Laying of 11 KV XLPE cable size 3x120 sq.mm. in the trench after spreading the sand in the bottom of the trench and the laying Ist class bricks on the sand in the trench and putting the cable on the bricks and covering the cable with Ist class bricks from all three sides of cable and then filling the soil and ramming.

M/s Manoj Enterprises (BID ID -4713850)

M/s Abinav Enterprises (BID ID -4713794)