Vidhayak Niwas-4, Royal Hotel sthit Awas Sankhya-1-2 ke pravesh par bane jeenon par patthar lagane, chaar jaali ke darwaze va teen shatigrast lage darwazon ko badalne ka karya evam anya aavashyak marammati karya.

Dismantling doors, windows and clerestory windows (steel or wood) shutter including chowkhats, architrave, holdfasts etc. complete and stacking with in 50 metres lead : Of area beyond 3 sq. metres DAR NO-15.12.2

Taking out doors, windows and clerestory window shutters (steel or wood) including stacking within 50 metres lead : Of area 3 sq. metres and below DAR NO-15.13.1

Providing wood work in frame of door , window , clerestory windows and other frames , wrought framed and fixed in position with hold fast lugs or with dash fastener of requried dia & length (hold fast lugs or dash shalle be paid for separately).second class teak wood (dar-9.1.1)

Provding and fixing ISI marked flush door shutters conforming to IS : 2202 (part-1) non- decorative type, core of block board contruction with frame of 1st class hard wood and well matched commercial 3 ply veneers on both faces of shutter :30mm thick including isi marked stainless steelbutt hinges with necessary --9.21.2 DSR

Providing and fixing wire gauge shutters using galvanized M.S. wire gauge of average width of aperture 1.4 mm in both directions with wire of dia 0.63 mm, for doors, windows and clerestory windows with hinges and necessary screws 35 mm thick shutter with ISI marked stainless steel butt hinges of required size second class teak wood 9.27.1.2.1

Marble stone flooring with 18 mm thick marble stone, as per sample of marble approved by Engineer-in-charge, over 20 mm (average) thick base of cement mortar 1:4 (1 cement: 4 coarse sand) laid and jointed with grey cement slurry, including rubbing and polishing complete with Raj nagar plain DAR NO-11.23.2

Proding and fixing aluminium work for doors windows, ventilators and partitions with extruded built up standard tublar section/ appropriate Z section and other sections of approved make conferming to IS:733 and IS 1285 , fixing with dash fasteners of requried dia and size , including necessary filling up the gaps at at junction I.S at top bottom and sides with required EPDM rubber/ neoprene gasket etc alumimium section shall be smooth , rust free straight , mitred and joints machanically where requried including clear angle , aluminum snap beading for glazing / paneling C.P Brass/ stainless steel screws all complete as per architectural drawing and the direction of Engineer-in - charge (glazing, paneling , and dash fasteners to be paid for separately)::for fixed portion:: Anodised aluminium ( anodised transparent or dyed to requried shade according to IS:1868 , minimum anodic coating of grade AC-15(dar -21.1.1)