LOT1

Providing laying granular Sub base(GSB) well graded material, spread in uniform layer with motor grader on prepare surface, mixing by mixture in place method with rotavator at OMC and compacting with smooth wheel roller to achieve the desire density as per MORD specification 401.

Providing, laying, spreading and compacting stone aggregates of specification sizes to water bound macadam specification including spreading in uniform thickness, hand packing rollding with three wheel 80-100kN static roller in stages to proper grade and camber MORD specification 405.2 (WBM-2)

Providing laying spreading and compacting stone agregates of specification sizes to water bound macadam specification including spreading in uniform thickness, hand packing rollding with three wheel 80-100 kN static roller in stages to proper grade and camber MORD specification 405.3 (WBM-3)

Brick Edging on both side of the road of M-150 bricks 7 cm wide 11 cm deep, laid with mud mortar including labour & supply of bricks finished to the required] template and in proper alignment and also including dressing and ramming the excavated earth as directed by the Engineer in charge

Providing laying Prime coat With Bitumen emulsion (SS-A) on prepared surface of granular base inculding cleaning of road surfafe and spraying prime coat of 0.60 kg/sqm using mechnical means as technical Specification Clause 502

Providing and applying tack coat with bitumen VG-10 grade using bitumen pressure distributer at the rate of 0.30 kg. per sqm on the prepared granular surface treated with primer & cleaned with hydraulic broom as per technical specification clause 503.

Providing, laying and rolling of open - graded premix surfacing by paver machine of 20 mm thickness composed of 13.2 mm to 5.6 mm aggregates either using penetration grade bitumen VG-10 to required line, grade and level to serve as wearing course on a previously prepared base, including mixing in a suitable plant, laying and rolling with a three wheele 80-100KN static roller capacity, finished to required level and grades complete all specified in Manual MORD technical specification clause 508 and as directed by the Engineer in charge.

Providing and applying seal coat by manual means with 80/100 grade bitumen sealing the voids in bitumens surface laid to the specified levels grade and cross fall using type C as per technical Specification Clause 510.

Painting marking edge line on bituminous surface including cost of all material , labour ,T&P and prepare surface etc. all Complete.

Note : The Quantities written above may increase or decrease as per requirement & site condition

Please Enable Macros to View BoQ information