SPL REPAIR TO BLDG NO P-20 (QTR GUARD) OF 131 SATA REGT UNDER GE NASIRABAD

Dismantling old AC sheet (corrugated or semi corrugated etc) including AC ridges in large patches as in roof covering complete all as specified and directed.

S&F Pre- painted galvaiume aluminum zinc coating GI based corrugated steel sheet 0.5 mm thick of an colour having tensile strength of 550 Mpa as in roof covering/cladding to wall, fixed with self tapping crews as specified complete all as specified and directed

S&F rolled section as in main and cross beams, hip and jack rafters, purlin where connected to common rafters and running rails and guisides for sliding doors, fixed with angle cleats or other connecting plates confirming to Fe 410-0 or Fe310-0 including dismantling of old steel work complete all as specified and directed.

M&L applying two coats of synthetic enamel paints on new steel surfaces over a coat of red oxide primer including surface preparation complete all as specified and directed.

Dismantling wall and ceiling boards (fiber, pulp, insulation etc.) any thickness, including cover fillets, Suply & Fixing false ceiling with Everest Fibre Cement Designer tile Ivory painted (High Pressure Steam Cured) of 4mm thickness (as per IS:14862) of size 595x595 mm and any one of the design (oceanic, lake & hill, cascade or electra) in true horizontal level, suspended on inter locking metal grid of hot dipped galvanized steel sections (galvanized @ 120 gms, both side inclusive) consisting of main "T" runner with suitably spaced joints to get required length and 15x32 mm made from 0.30 mm thick sheet, spaced at 1200 mm c/c and cross "T" of size 15x32 mm made of 0.30 mm sheet, 1200mm long spaced between main "T" at 600 mm c/c to form a grid of 1200x600 mm and secondary cross "T" of length 600 mm and size15x32 mm made of 0.30 mm thick sheet to be interlocked at middle of the 1200x600 mm panel to form grids of 600x600 mm and wall angle of size 15x20 mm made of 0.30 mm thick sheet and laying false ceiling tiles in the grid including , required cutting/making, opening for services like diffusers, grills, light fittings, fixtures, smoke detectors etc. Main "T" runners to be suspended from ceiling using GI soffit cleats fixed to existing RCC lintel with dash fasteners, GI adjustable rods of 3mm dia with galvanised Butterfly level clips, spaced at 1200 mm c/c along main T, bottom exposed width of 15mm of all T -sections shall be centra black pre-painted with polyester paint, and having a load bearing capacity of 12 kg/sqm,complete all as specified and as directed.

M&L for 15 mm rendering in CM 1:4 on fair face of wall or on stone masonary surfaces finished even with water proofing compound (WPC) (2% of cement bag) and smooth without using extra cement complete all as specified.(WPC Measured and paid seprately) and including necessary formwork for rendering. complete all as specified and directed.

Supply only liquid water proofing compound ( For external plaster surfaces) complete all as specified and directed

M& L for rendering in cement mortar (1:6), 15mm thick on stone masonary surfaces finished even and smooth ,without using extra cement, over and including dubbing coat (if required) complete all as specified and directed.

M&L for rendering in cement mortar (1:4) 5mm thick as in ceiling surfaces finished even and smooth without using extra cement, complete all as specified and directed.

M & L for rough cast plaster mix with crusted stone (6-10 mm), sand and cement in the ratio 1:1:1 , over 15mm thick rendering in CM 1:4 as in under coat including dubbing coat (if required) complete all as specified and directed.