SPL REPAIR TO SHED NO 19 INSIDE COD KANPUR

Amount

BnR Schedule

Demolition of brick work built in cement mortar including all quoins, arches, pillars etc. but excluding ashlar facing etc including stacking the serviceable materials and disposal of unserviceable material, debris and disposal of rubbish outside MD land .complete all as specified and directed.

M & L brickwork with flyash bricks, straight or curved on plan exc 6m mean radius built in cement mortar 1 : 6 complete all as specified and directed.

All as per item no. 03 here in before but except bricks.

Taking down cement plaster on bricks or concrete surfaces including raking out joints for key, scrubbing down with water etc complete all as specified and directed.

M&L for rendering 15 mm thick in cement mortar 1 : 6 on fair faces of brick or concrete surfaces finished even and smooth without using extra cement complete all as specified and directed.

M&L for rendering 15 mm thick in cement mortar 1 : 4 on other than fair faces of brick or concrete surfaces including using water proofing compund as per manufacturers instructions finished even and fair without using extra cement complete all as specified and directed. Note: WPC shall be paid separately)

M&L Applying two coats of cement base paint over a coat of cement primer including preparation of newly plastered untreated surface of wall complete all as specified and directed.

M&L for preparation of newly plastered surfaces of wall and applying three coat of white wash complete all as specified and directed.

Supply only integral water proofing compound (ISI marked)

Demolition of cement oncrete in ground floor and pavings not exc 20cm thickness below or above ground level and disposal of unserviceable material, debris and disposal of rubbish outside MD land .complete all as specified and directed.

M & L 100 mm thick PCC type B-1, 1:2:4 (20mm graded stone aggregate) for flooring surface finished even and smooth without using extra cement laid as in alternate bay complete all as specified and directed.

M & L 100 mm thick PCC type D-2, 1:4:8 (40mm graded stone aggregate) as in sub base finished even and rough to receive floor topping complete all as specified and directed.

M & L 75 mm thick PCC type C-1, 1:3:6 (20mm graded stone aggregate) for plinth protection surface finished even and smooth without using extra cement complete and joints filled with hot bitumen 85/25 grade and sand in 1:3 complete all as specified and directed.

Dismantiling of AC sheet (corrugated, semicorrugated, etc.) sheets in roof coverings complete all as specified and directed.

S & F of regular modified Polyester colour coated galvanized steel rib profile sheet(TCT) 0.50mm thick E42(inclusive of protective coating ) overall width 1060mm and total mass coating of 120 gms/sqm on both sides as per IS-14246:95(JIS:3312 polyester coating 30-40 micron) as in roof etc fixed etc fixed to iron /wooden members with self drilling zinkallum coated metal screws having cap with rubber washers more than 3.00sqm patches as required in shapes complete all as specified and directed. Make: (a) Lloyd Insulation (b) Tata bluescope steel building solutions Ltd.(c) Prestar Infrastructure Project Ltd (d) Colour Roof India Ltd.(CRIL) (e) M/s Matco Roof PvtLltd. (f) Ispat Industries Ltd (JSW) (g) Everest Industries

S & F regular modified Polyester colour coated galvanized steel plain profile sheet(TCT) 0.50mm thick E42 (inclusive of protective coating ) as in ridge , valley, gutter and total mass coating of 150 gms/sqm on both sides as per IS-14246:95(JIS:3312 polyester coating 30-40 micron) as in roof etc fixed etc fixed to iron /wooden members with self drilling zinkallum coated metal screws having cap with rubber washers complete all as specified and directed. Make: (a) Lloyd Insulation (b) Tata bluescope steel building solutions Ltd.(c) Prestar Infrastructure Project Ltd (d) Colour Roof India Ltd.(CRIL) (e) M/s Matco Roof PvtLltd. (f) Ispat Industries Ltd (JSW) (g) Everest Industries

Dismantiling of CGI/PGI sheets any thickness as in roof coverings complete all as specified and directed.

S & F 0.63 mm thick galvanised, corrugated mild steel sheeting with zinc coating 120 gram/sqm two corrugations side lap & 150 mm end lap ,fixed with 'L' type or 'J'type or crancked hook bolt and washers or with self drilling zinc aluminium coated metal screws of suitable size having cap with rubber washers as in roof covering/vertical surfaces complete all as specified and directed.(Make - SAIL/TISCO/RINL/JSW Steel Ltd)

Taking down chowkhats or frames (without taking off shutters from the frame) exc 1.5 sq. m but n exc 4 sq. m each complete all asspecified and directed.

S & F mild steel rolled section of angle, tee or other section Fe-290 Gde E-165) as in framing for cladding, glazing, ventilator and the like fixed with angle cleats and connecting plates etc complete all as specified and directed .

S&F Steel wire fabric not exc 4 Kg/Sqm in wood or steel members etc fixing through welded etc complete all as specified and directed

S & F rolled mild steel as in roof trusses (framed), trussed, purlins, crane gantries, and watch tower structure rails fastenings and heavy bracket frames beam, tee, channel or flat sections including distance pieces, cleats etc. and similar work confirming to Fe-410 Gde E-250 quality A complete all as specified and directed at site.

Dismantling timber scantlings 40 sq. cm and over in section, in any position in framed work complete all as specified and dorected.

S & F mild steel Hand rails, half round or other stock section or core for wooden hand-rail straight portion, drilled and countersunk for balusters running bars, for doors, balusters, nosing to steps including embeding in concrete and screwing etc. wind ties for roof including securing bolts; posts and struts in fencing including cutting tops to shape as directed, drilling holes, notching for wire, etc.; flat iron fillets (for securing wire mesh etc.) including all necessary drilling, bolting or riveting, etc., and similar work conforming to Fe-290 Gde E-165 complete all as specified and directed.

S&F mild steel framed work as in doors or gates of angle or other section with gusset plates,rail,braces etc complete drilled for fixing of steel sheeting or other covering. Doors etc to be prepared for hanging or sliding with and including either hooks and hinges or steel hanging door fittings and hanging also fastening and fixing including all necessary drillings, bolting or riveting, etc. and similar confirming to Fe 290 Gde E-165 complete all as specified and directed.

Dismantling of wrought iron or mild steel work of any description not otherwise provided complete all as specified and directed .

Note: No electricity will be provided by the department and contractor will make his own arrangement of Generator set for truss work and other works for which electrcity be required such as welding , notching, cutting, grinding etc.

M & L for preparation of new steel surfaces of any description over 10 cm width or girth and applying two coat of synthetic enamel paint over a coat of red oxide zinc chrome primer complete all as specified and directed.

M & L for preparation of old steel surfaces of any description over 10 cm width or girth and applying two coat of synthetic enamel paint complete all as specified and directed.

M & L for preparation of new steel surfaces of any description not exc 10 cm in width or girth when unconnected with other painting or when painted in different tint and applying two coat of synthetic enamel paint over a coat of red oxide zinc chrome primer complete all as specified and directed.

Demolition of reinforced cement concrete of any description and in any position not otherwise specifically provided complete all as specified and directed.

S & F cement concrete (1:2:4) type B-1 using 20mm graded stone aggregate and set in cement mortar (1:4) in window or door cills, lintels, bressumers, steps, quoin blocks (for use with masonry), string courses, copings. kneelers, apex stones, pier caps, columns, posts, boundary pillars, bed plates, pintle blocks, ancho-rage blocks, bonders(for stone walling).corbels, brackets, etc. (of any section indicated), with plain fair faces, including chamfers,weatherings, throat- ing etc. and setting in mortar complete with joints to match complete all as specified and directed . Note: Reinforcement shall be measured and paid separately.

M&L for TMT 10mm dia & over, cut to length bent to shape required including binding with MS wire (annealed) not less than 0.9mm dia complete all as specified and directed .

M&L Mild steel bars 6 to 8 mm dia, cut to length, bent to shape required incl cranking, bending spirally for hooping for coloumns, hooking ends and binding with & incl mild steel wire (annealed) n.less than 0.9mm dia or securing with clips complete all as specified and directed..

M & L use and waste of Formwork to sides and soffits of floor or roof beams, beam haunchings, girders, bressum-mers, lintels, cantilevers, shelves including supports, overhangs, etc. also splays between floors and beams, etc rough finished surfaces of conrete flat complete all as specified and directed.

S & F 3.00 mm thick figured glass, pin head type and glazing with oil putty in squares n exc 0.5 sq. m in each pane including hacking out old one complete all as specified and directed.

M&L for forming 12mm thick expansion joint filled with preformed bituminous filler and top 30mm primed and sealed with sealing compound grade 'A' complete all as specified and directed.

M&L for forming contraction (Dummy) joints 5mm deepx10mm wide filled with sealing compound grade 'A' complete all as specified and directed.

M&L for Hardcore of broken stone or boulders of gauge n exc. 63 mm, deposited, spread and levelled in layers n exc. 150 mm thick, watered and rammed to a true surface complete all as specified and directed..

Removing building materials (Other than sopil payable under 03028 to 03031 in section -3 Earth work) to a distance of exceeding 200m but not exceeding 300m beyond the lead including in the rates including loading unloading and stacking at the destination complete

Note for all items of BOQ: Entire work listed in BOQ shall be executed in Restricted area.

M/s S K ARORA

ARORA BROTHERS

M/S GR construction compony