SPECIAL REPAIR TO VEH GARAGE IN BLDG. NO P-133 AND P-140 UNDER AGE B/R-III OF GE (NORTH) BATHINDA AT BATHINDA MIL STN

Supply and fixing for steel rolling shutters, 1.25 mm thick, gear-operated type, complete with bevel gear box, crank handle with ball bearings, side guide channels, top cover, anchoring rods, hasp and staple, complete top box and all necessary accessories and fittings, including one shop coat of primer; properly erected, fixed and commissioned in position as indicated, complete in all respects as specified and directed by the Engineer-in-Charge. Note: Rolling shutter size shall be exceeding 25 sq.m but not exceeding 35 sq.m per shutter, with height up to 7.0 m. The rate shall include the complete rolling shutter assembly, including top box, side guide channels, gear box, anchoring rods, crank handle, bearings and all necessary fittings, fixtures and accessories, complete in all respects as specified and directed.

Material and labour for preparation of new or previously untreated steel surfaces of any description, not otherwise specified, over 10 cm in width or girth, including application of one coat of red oxide primer followed by two coats of synthetic enamel paint, complete in all respects as specified and directed.

Taking down and removing existing rolling shutters, excluding those exceeding 20 sq.m but not exceeding 35 sq.m in each case, including dismantling, handling, stacking and disposal of debris as directed, complete in all respects as specified and directed by the Engineer-in-Charge.

Taking down existing cement plaster from brick or concrete surfaces, including raking out joints, hacking the surface to provide adequate key, scrubbing and cleaning down with water, and removing the debris to the designated place, complete in all respects as specified and directed by the Engineer-in-Charge.

Material and labour for providing and applying 15 mm thick ready-mix cement plaster on internal/external surfaces of brick walls, chajjas, fins and concrete surfaces, including preparation and cleaning of background, wetting, mixing and application of ready-mix material, levelling, finishing to an even and fair surface, curing and all necessary labour, materials, tools and plant, complete all as specified and as directed by the Engineer-in-Charge.

Material and labour for providing and applying 12 mm thick ready-mix cement plaster on internal/external surfaces of brick walls, chajjas, fins and concrete surfaces, including preparation and cleaning of background, wetting, mixing and application of ready-mix material, levelling, finishing to an even and fair surface, curing and all necessary labour, materials, tools and plant, complete all as specified and as directed by the Engineer-in-Charge.

Material and labour for providing and applying 5 mm thick ready-mix plaster to concrete surfaces, including ceilings, chajjas and similar surfaces, finished even and smooth without the use of additional cement, complete in all respects as specified and directed by the Engineer-in-Charge.

Dismantling of brick work or stone / boulder masonry, built in cement mortar or cement lime mortar including all quoins, arches, pillars, etc, in any description, stacking serviceable brick for re use if directed and balance removing rubbish from the site complete all as specified and as directed.

Material and labour for brickwork with approved fly ash bricks, conforming to the relevant applicable IS specification, in straight or curved work on plan having mean radius exceeding 6 m, built in cement mortar 1:6, including setting out, soaking/pre-wetting of bricks as recommended, laying of bricks, proper bonding, filling and finishing of joints, scaffolding, curing and all necessary materials, labour, tools, plant and incidental operations, complete as specified and as directed by the Engineer-in-Charge.

Material and labour for complete removal of existing treatment of any type/description (any layer) from external/internal wall/ceiling surfaces, soffits/chajja/roof projection surfaces etc., by scraping steel patti or Mechanical sander/grinder machine having suction vaccum Bag (Smart periodical methodology), complete all as specified and as directed.