Supply and fixing Shed for Segregation of recyclable Waste in GLR Sy. No. 64.

Amount

Supply and Fixing Shed for Segregation of recyclable waste management in GLR SY No 64

Excavating in trenches In Hard Soil, n exc 1.5 m wide and n exc 1.5 m in depth; for foundation, etc. or for shafts, wells, cesspits, manholes, pier holes, etc. n exc 10 sq m on plan and n exc 1.5 m in depth and getting out

M&L Hardcore of guage exc 63mm but n exc. 100 mm, deposited, spread and levelled in layers n exc. 15 cm thick, watered and rolled/rammed to a true surface

M&L Cement concrete in foundations, filling and mass concrete Type D2 1:4:8 (40mm gradede aggregate )

Mild stee TMTl bars 10mm dia and over, cut to length, bent to shape required, including cranking, bending spirally for hooping for columns, hooking ends and binding with and including mild steel wire (annealed) not less than 0.9mm dia or securing with clips

Mild stee TMTl bars 6mm to 8mm dia and over, cut to length, bent to shape required, including cranking, bending spirally for hooping for columns, hooking ends and binding with and including mild steel wire (annealed) not less than 0.9mm dia or securing with clips

M&L For Reinforced cement concrete 1:1.5:3(M20) (20mm aggregate) Foundations, including rafts, footings, foundation beams; plinth beams; bases for columns, etc.; basement slabs, under-reamed piles and mass concrete

M&L Reinforced cement concrete (design mix) M20 (20mm graded) Columns, pillars, piers, posts and struts

Formwork to sides of concrete foundations, footings, bases of columns, raft and raft beams, sides and soffits (if any) of foundation and plinth beams; and similar work; vertical or to batter

M&L Formwork to sides of pillars, posts, struts, piers, columns and stanchions

Precast cement concrete hollow block( 1:3:6 20mm graded agg ) masonry exc. 10 cm in width and setting in Cement mortar 1:6 complete

Rendering 12 mm thick on fair faces of brick work or concrete surfaces in CM 1:4

Surface excavation in Soft/loose soil n.exc (not exceeding) 30 cm deep and averaging 15cm deep and getting out

Moorum/red bajri filling in floors or pavings, laid in layers n exc. 15 cm thick, spread, levelled and rammed including watering

Providing and laying 60mm thick factory made chamfered edge cement concrete paver block of M-35 grade with approved colour, design & pattern as in footparth, parks, lawns, drive ways or light traffic parking etc., of required strength, thickness & size/ shape, made by table vibratory method using PU mould, laid in required colour & pattern over and including 50mm thick compacted bed of fine sand, compacting and proper embedding/ laying of inter locking paver blocks into the sand bedding layer through vibratory compaction by using plate vibrator, filling the joints with sand and cutting of paver blocks as per required size and pattern, finishing and sweeping extra sand;

Supply and fixing of Mild steel 20 mm rag or lewis bolts, screwed one end, with hexagonal or square nuts and washers, the other end enlarged and jagged or lewised, n exc 30cm long

S&F of 10mm Plates (plain or chequered) channels, square cut or notched (ordinary and counter sunk) forming holes, without any attachmen FE 410 (Grade E250quality A

S&FPlate girder or single stanchions, built up of one beam or channel section with flange plates, caps, bases. splices, angle brackets, cleats and other connections Fe 410 -W (Gde E-250quality -A)

S & F Roof trusses (framed), trussed, purlins, crane gantries, rails and fastenings and heavy bracket framing (Beam, tee, angle, channel or flat sections) including distance pieces, cleats etc. Fe 410 -W (Gde E-250quality -A)

S&F Steel work in tubular trusses including special shaped washer etc. complete using ERW or induction butt welded tubes conforming to I. S.1161- 1979 grade St.-24 Fe 410 -W (Gde E-250quality -A)

S&F Pre- painted galvatume aluminum zinc coating GI based corrugated steel sheet 0.50mm thick of an colour having tensile strength of 550 Mpa as in roof covering/cladding to wall, fixed with self tapping screws as specified

Painting Steel and Iron Surfaces Surfaces of any description, over 10cm in width or girth,not otherwise described, Preparation of New surfaces , Priming with red Oxide, Synthetic enamel two coats to steel iron surfaces

PRASANNAKUMAR D LATTHE

M/S JAYDEEP CONSTRUCTION