Repairing of Truck Engine and body DG set and water Treatment unit and allied works for MTU_2 located at Hooghly District under Electrical Division PHE Dte

Amount

Repairing, overhauling & servicing of Truck Engine & Body :-

Supply & delivery of following spares as per existing sample for repairing of Truck & Truck Engine (Make- Ashok Leyland) :-

Cloth

Cleaning Fluid

Fuel Strainer

Fuel Filter cum water seperator

Spain on oil filter 80K

Gulf Superfleet LE Dura Max 15W-40

Gulf Gear XP Dura Max 80W-90

Gulf Gear DB Dura Max 85W-140

Standard split pin in dia

Split Pin

Gasket Rear Hub 0.5 thik

Blue Max 25GM

Emery Paper

Clamp Hose

Hub oil Seal Rear inner

CB Kit SPL 100/PS1550 ID45

Gulf Crown Dura Max Grease NLGI 3

CL DISC Ceramic 35.56 CM 1.5 SPL 1.4CM

Auto Slack Adj -FR/RR

Thread Lock LIQ

Clutch Release BRG ASSY RDC

Track Rod/Drag Link Major Rep Kit

King Pin Kit- STD 38.25- FA 90- TP

SHIM 0.0127CM King Pin

Proxmity Sensor IMM Length 2.50CM

Ball BRG FLY Wheel H-Series -(6203)

BR LNG Kit (Half) HLP-WOR-6-STD-Truck

Rivets Kit

Plain Washer M6

Spring Washer

Wheel Bolt & Nut Kit Front

Hub Oil Seal Front FA90/FA99

BR LNG Kit (Half) NHLP-WOR 7-STD -Truck

Control Cable

Thermostat 82 Degree H4/H6

Spring

Steering Filter Plastic

Gulf Power Steering Fluid Dura Max

Horn 24V

Nipple Grease

Skilled technician & labour charges for repairing, servicing & overhouling of Truck & Truck Engine (Make- Ashok Leyland) with fitting fixing of above supply items (sl no-1) on existing position of Mobile Water Treatment Unit -2 located at Hooghly District with testing & commissioning all complete as per direction of EIC:- (N.B: Truck Repairing work should be done by Authorised Delear of Ashok Leyland)

R and R Wheel Bearing & Greasing (2)

R and R Clutch Assy and O/H

Drain and Refill Engine oil and Filter

R and R Fuel Filter / Pre Filter

R and R Fuel line hose (2)

R and R Fuel tank clening

Drain and Refill oil in Rear Axle

Drain and Refill oil in Gearbox

Stoper Cable Change

R and R Brake Pedal

R and R Thermostat & check Opening Temp

Drain and Refill Steering

Replace King Pin and bushes

R and R and O/H track rod/drag link ball

R and R brake lining (4)

R and R Slack Adjuster (Manual / Auto)

R and R Torque plate Assy (2)

R and R one centre joint rubber Assy

Nipple Greasing

Check Wheel Alignment (Electronic)- Five

R and R accelerator cable

Patch work repairing of floor & side wall of the body of Truck (Mobile Water Treatment Unit -2) by cutting, welding and finishing including supply of raw materials (i.e corrugated sheet, M.S angle, plate etc.) including painting complete as per direction of EIC

Repairing, overhauling & servicing of 25 KVA D.G Engine :-

Supply & delivery of following spares as per existing sample for repairing of 25 KVA D.G. set (Make- Ashok Leyland) :-

Main Bearing Kit

Thrust Washer Kit

C/Shaft Rear Oil Seal - AL - 485G1

Oil Seal - AL - 485G1

Fan Belt - 485

Air Filter

Anabond (Big)

O- Ring (Cylinder head rubber O- Ring)

Leypower XLL Engine Oil (10LT Pack)008

Leypower Coolnat (1 LT Pack)004

Fuel Filter

Oil Filter

Banjo Washer

Hose Clamp

Diesel Pipe (with lock cap)

Hose (Turbo Charge Silicon Hose)

Valve Seal

Cylinder Head Cover Gasket

Fuel Strainer

OHG Kit AL485

Cylinder Liner - AL - 485G1

Pistone Set - AL485TG2/ TG3 (Per Bore)

Ring Set (Piston)

Connecting Rod Bearing

Exhaust Valve

Intake Valve

Rubber Hose

Terminal (Load terminal)

Valve Keys (8 Off) - AL-485G1

Thermostat - AL - 485G1

Stop Solenoied 12V

Skilled technician & labour charges for repairing, servicing & overhouling of 25 KVA D.G. set (Make- Ashok Leyland) with fitting fixing of above supply items (sl no-4) on existing position of Mobile Water Treatment Unit -2 located at Hooghly District with testing & commissioning all complete as per direction of EIC:- (N.B: D.G. Repairing work should be done by Authorised Delear of Ashok Leyland)

Service charge foe major overhauling

Turbo Charger Repairing

FIP & Injector Calibreation & Repairing charge

Loading & unloading charges

Supply & deliveryy of following spare for MTU as per departmental sample:

100 Micron Cartridge Filter/Busket strainer for UF unit-100 micron, S.S, 20" long (Jumbo Type) ID - 50mm OD - 100mm Length - 500mm Flow Capacity - 6 m3/hr construction, core not required. Clean DP - 100 mbar Maximum Operating Temperature - 200 deg C Make :- Parker /Gopani / any approved.

5 Micron jumbo wound type prefilter Cartridge of R.O Filter assembly with below mention specification. a) ID:- 4.5" b) O.D :- 6" c) Length :- 20" d) Flow capacity :- 5m³/hr e) Care Cover Material:- Poly Propylenem f) Care :- Poly Propylenem g) Clean Ps 10 Psid h) Maximum Operating Temperature :- 120°F (49°C) Make :- Parker /Gopani / any approved.

Membrane element for RO unit, Capacity 2000 lit/hr. Suitable for installation in RO vessel diameter 8 " & length 40". as per following specification:- a)Permeate Flow: - Minimum 10000 gpd (3.75 m³ /d) b) salt Rejection :- (99.5% minimum) c) Configuration : - Spiral wound d) Membrane polymer:- Composite Polyamide e) Nominal membrane Area:- Minimum 365ft² (33.9m²) f) Maximum applied pressure:- above 450 psi g) Maximum operation temperature :- Not above 122°F (50°C) h) pH range, continuous (Cleaning) :- 2-11 (1-13)* i) Maximum Feed water Turbidity :- Upto 1.0 NTU j) Maximum Feed water SDI (15 mins) :- Upto 5.0 k) Maximum Feed Flow:- 75 GPM (17.0 m³ /h ) l) Minimum Ratio of Concentrate to permeate Flow any Element:- 5.1 m) Maximum pressure drop for Each Element:-10 psi (Make- Hydranautics/ Dow/ Toray/ GE/ Suez/ any appd. )

UF unit for removing all undisclosed impurities including suspended solids, colidall impurities having Feed Pressure-5 Bar, Operating Tran membrane Pressure -2 psig, Maximum Backwash- 20 psig as per following specification -

a) Filtrate flow: 12.1-29.5 gpm 2.7-6.7 m3/hr

b) Filtrate Turbidity: > 00.7 NTU

c) Virus removal: > 4 log

d) Bacteria removal: > 4 log

e) Configuration: Capillary Ultrarafiltration Module

f) Membrane Polymar: Hydrophilic Poly thersulfone

g) Nominal Membrane area: 500 ft2 (46 m2) or above

h) Fiber Dimension: ID 0.031" (0.8mm) OD 0.055" (1.4mm)

i) Pore size: 0.02 micron or less

j) Typical filtrage Flux Range: 35-85 gfd (59-145l/m2/h)

k) Maximum Applied Feed Pressure: 73 psig (5 bar)

l) Maximum Transmenibrane Pressure: 20 psig (1.4 bar)

m) Maximum backwash transtnembrance Pressure: 20 usig (1.4 bar)

n) Instanteneous Chlorine Tolerance: 100 ppm

o) Instanteneous Hydrogen Peroxide Tolerance: 200 ppm**

p) Maximum chlorine expossure: 200.000 ppm-hrs

q) Maximum Instanteneous feed turbidity: 100 NTU

r) Maximum operating temperature: 104° F

s) pH operating range: 4.0 - 10.0

t) Chlorine pH range: 1.5-13.0

u) Operating Mode: Inside to outside Filtration Direct flow of crossflow

v) Backwash flux: 100-150 gfd (170-255 I/m2/hr)

w) Backwash duration: 30-60 seconds

x) Backwash frequency: 20-60 minutes

y) Chemical enhanced backwash frequency: 0-4 ties per day

z) Chemical enhanced backwash duration: 1-30 minutes

z1) Disinfection chemicals: Na0CL, H2O2, CLO2 or NH2CL

z2) Cleaning chemicals: NaOH, HCL H2SO4 or Citric Acid

(Make- Hydranautics/ Dow/ Toray/ IMT/ Suez/ any appd. )

Installation and commissioning of UF unit (item no.-9) for removing all undissolved impurities including suspended solids, colidall, impurities having Feed Pressure-5 Bar

Supply & deliveryy of following spare for Pouch Packing Machine as per departmental sample:

Vertical Transformer

Horizontal Transformer

Control Transformer

Vertical Electrode, L =190 mm

Horizontal Electrode, L =190 mm

Heat Tape

Add: 18% GST

Add: 1% CESS

JDJ ENTERPRISE. A UNIT OF JDJ TRADERS PRIVATE LIMITED

WEST BENGAL ENGINEERING CO.