Reconstruction work on the Atta Chindauli road from Rasulpur village

Providing laying and Spreadind Material on a prepared sub Grade adding cement @2% by weight to the spreade materials manually mixing in place with rotavatorand compecting with the road Roller @ OMC to Achivethe Desired Unconfined Compressive Strength and to form a layer of Sub Base

Providing laying and Spreadind Material on a prepared sub base adding cement @4% by weight to the spreade materials manually mixing in place with rotavatorand compecting with the road Roller @ OMC to achivethe Desired Unconfined Compressive Strength and to form a layer of base

WBM Grading-3 Providing, laying, spreading and compacting stone aggregates of specific sizes to water bound macadam specification including spreading in uniform thickness, hand packing, rolling with smooth wheel roller 80-100 kN in stages to proper grade and camber, applying and brooming, stone screening to fill-up the interstices of coarse aggregate, watering and compacting to the required density Grading 3 as per Technical Specification Clause

Brick lining on both side of the road of M-150 Bricks 7cm wide 11cm deep laid with mud mortar including labour & supply of Brics finished to the required templet and in proper alignment and also including Drassing and ramming the Excavated earth by the Engineer- Incharge

Providing and applying primer coat with bitumen emulsion SS-2 on prepared surface of granular Base including cleaning of road surface and spraying primer at the rate of 0.70 kg/sqm using mechanical means. Including supply of all Material, Labour, T&P etc also including labour cess, royalty and all other applicable Taxes (But excluding GST) required for proper completion of work as per direction of Engineer-in-charge. Technical Specificaton Clasue 502.

Providing and applying tack coat with bitumen VG-10 grade using pressure distributor at the rate of 0.25 kg per sqm on the prepared bituminous/granular surface cleaned with mechanical broom. required for proper completion of work as per direction of Engineer-in-charge. Technical Specificaton Clasue (SI.NO. 503).

Providing, laying and rolling of open - graded premix surfacing of 20 mm thickness composed of 13.2 mm to 5.6 mm aggregates using VG-10 Bitumen required line, grade and level to serve as wearing course on a previously prepared base, including mixing in a suitable plant, laying and rolling with a three wheele 80-100 kn static roller capacity, finished to required level and grades to be followed by Type-C seal coat. required for proper completion of work as per direction of Engineer-in-charge. as per Technical Specification Clause. 508.

Providing and laying Type-C seal coat with VG-10 bitumen sealing the voids in a bituminous surface laid to the specified levels, grade and cross fall using Type C. required for proper completion of work as per direction of Engineer-in-charge. as per technical specification clause 510.

Construction of embankment with approved materials obtained from borrow pits with a lift up to 1.5m transporting to site grading to required slope and compecting to meet requirement of tables 300.1 and 300.2 with a lead up to 1000m as per technical specification clause 301.5