CERTAIN REPAIR TO PATH FENCING COMPOUND WALL GATE PILLARS AND GATES AND OTHER MISC B/R REPAIR AND STRENGTHENING OF ROAD BERMS CULVERTS FOOTPATHS ETC IN AREAS OF AGE B/R I UNDER GE SATWARI

Amount

Demolition of brick work built in cement mortar or cement lime mortar incl all quoins, arches pillars etc and removing unserviceable material exc 100 mtr all as specified.

Taking down cement plaster of any decription on brick work including racking out jointing hacking for key scrubbling down with water and removing all the demolished material outside cantt area.

Demolition cement concrete (unreinforced) Concrete in ground floors and pavings n exc 15 cm thickness (below or above ground level) incl removing from site to a distance n exc 500 m all as specified.

Demolition of cement (reinforced) concrete Concrete of any description and in any position any thickness (below or above ground level) complete all as specified.

M&L Cement concrete 75 mm thick, type D-2, 1:4:8 (40mm graded aggregate) laying as floor Complete all as spfd.

M&L providing and laying 80mm thick factory made chamfered edge cement concrete paver block of M-30 grade with approved colour, design & pattern as in footpath, parks, lawns, drive ways or light traffic parking etc. of required strength, thickness & size/ shape, made by table vibratory method using PU mould, laid in required colour & pattern over and including 50mm thick compacted bed of coarse sand, compacting and proper embedding/ laying of inter locking paver blocks into the sand bedding layer through vibratory compaction by using plate vibrator, filling the joints with fine sand and cutting of paver block as per required size and pattern, finishing and sweeping extra sand complete all as specified.

M&L Cement concrete tiles 25cm x 25cm x 25mm thick, machine pressed set jointed and pointed in neat cement slurry in floors, (with white cement and pigment) and cut and polished over 15 mm thick CM 1:4 complete all as specified.

M&L Pre-cast cement concrete block Type B1, 1:2:4 (20 mm graded agregate) as in kerb stone set in 1:6 cement mortar,fixed to side of foothpath complete all as specified.

M&L Providing and laying factory made kerb stone of M-25 grade cement concrete in position to the required line, level and curvature, jointed with cement mortar 1:3 , including making joints with or without grooves including making drainage opening wherever required complete all as specified.

M&L PVC (SWR) pipes single socketed, in any length with rubber ring joints, laid in trenches or in floors complete all as specified.

S&F Cast iron work grade FG 150 ( n exc 5 kg each) unmachined, in brackets, gully traps, gratings, railing, frames, manhole covers, fire and soot doors, dampers, stop valve boxes, gate stops, parts of ranges, balusters and similar articles

M&L Providing, cement concrete 1:2:4 Type B-0 ( 12.50mm graded aggregate) in cills, steps, seismic and other similar bands, plinth courses, string courses, lacing courses, copings, kneelers, apex stones, bed plates, kerbs, water troughs and the like including weathering, slightly rounded or chamfered angles and throating, all as directed.

M&L Cement concrete 1:2:4 type B-1 (20mm graded aggregate) as in walls or retaining walls, any thickness, size or shape including pilasters, buttresses columns, pillars, boundary pillars and posts (including caps and bases) complete all as specified.

Formwork to faces of walls, retaining walls, abutments, parapets and staircase railings and similar work including attached pillasters, buttresses, etc. vertical or to batter cpmplete.

Preparation old cement plaster/kerb stone old/untreated surface and applying one coat of synthetic enamel paint in black and white pattern or other deferent colored pattern over a coat of primer complete all as specified.

Dismantling posts or struts (wood, steel or R.C.C.) any section, including taking out embedded portion and making good disturbed ground

Excavation in post holes (or similar holes) each n exc 0.5 cum, getting out, returning, filling in and ramming earth or broken rubble mixed with earth around, in layers not exceeding 25 cm,

M&L Cement concrete in foundations,type D-2, 1:4:8 (40mm graded aggregate) filling and mass concrete complete all as specified.

M&L cement concrete type C-2 , 1:2:4 ( 20 mm graded aggregate) in foundations, filling and mass concrete complete all as specified.

S&F Hand rails, half round or other stock section or core for wooden hand-rail straight portion, drilled and countersunk for balusters running bars, for doors, balusters, nosing to steps including embeding in concrete and screwing etc. wind ties for roof including securing bolts, posts and struts in fencing including cutting tops to shape as directed, drilling holes, notching for wire, etc., flat iron fillets (for securing wire mesh etc.) including all necessary drilling, bolting or riveting, etc., and similar work conforming to Fe-290 Gde E-165

S&F Mild steel screw bolts (machine made) with hexagonal or square heads at one end and screwed the other, or screwed both ends, each screwed end to be fitted with washers and one hexagonal or square nut, n exc 5cm long complete all as specified.

Supply only 2 inch aperture Chain link MS galvanized fencing ( 4mm dia wire) to fix with angle iron with flat iron with suitable nut bolt any size or type complete all as specified.

Fixing only chain link fencing including line wires, any mesh, size and type to any type of standards, rails, straining bolts, etc. including provission of binding wire

Supply and fixing MS Round bars 10 mm dia, fix in chain link fencing using 0.90 mm dia GI wire as strengthing bar complete all as specified. Fe-410-W (Gde.E-250) quality-A or Fe 290 (Gde - E-165)

S&F in repair Galvanised, 2 strand, steel barbed wire 2.24mm dia barbed with 2mm dia barbs at 75mm spacings and straining and fixing to any type of standard rails straining bolts, including, securing or tying at crossings with and provision of galvanised mild steel wire, staples or steel pins, etc. as directed (each line wire to be measured) compete all as specified.

Discription as per above item No 25 but titening old barbed wire & Restraining resecuring including making good staples etc. complete all as specified & directed by Engr-in charge.

M &L reinforced cement concrete 1:2:4 type B-I (20 mm graded aggregate) in precast posts, fencing posts, straining or terminal posts, struts etc. for fencing, average sectional area n exc 100 sq. cm, with or without chamfered angles and flat, splayed, rounded or mitred tops as directed and fixed complete all as specified.

Excavating in trenches any type of soil, n exc1.5 m wide and n exc 1.5 m in depth; for foundation, etc. or for shafts, wells, cesspits, manholes, pier holes, etc. nexc 10 sq m on plan and n exc 1.5 m in depth and getting out in soft/Hard soil complete, all as specified.

Returning, filling in, including spreading, levelling, watering and well ramming in layers not exc 25 cm thick complete, all as specified.

Removing excavated material exc. 250 m but n exc. 500 m and depositing where directed complete all as specified.

Removing excavated material exc. 500 m but n exc. 1.5 km and depositing where directed by Engr-in-charge.

M&L Brickwork with subclass ‘B’ bricks, old size brick, straight or curved on plan exc 6m mean radius built in cement mortar 1:6 complete all as specified.

Ditto all as per item No. 32 but except brick cpmplete all as specified.

M&L Reinforced cement concrete 1:2:4 type- B-1 ( 20 mm graded aggregate) (nominal mix) in foundations, including rafts, footings, foundation beams, plinth beams, bases for columns, etc. and mass concrete complete all as specified.

M&L for mild steel TMT bars 10mm dia and over, cut to length, bent to shape required, including cranking, bending spirally for hooping for columns, hooking ends and binding with and including mild steel wire (annealed) not less than 0.9mm dia or securing with clips complete all as specified.

Ditto all as per item No 35 but 5mm dia and over upto and including 10mm dia as in stirrups, spacers and binders.

M&L for rendering 15mm thick CM 1:4 on fair faces of brick work or concrete surfaces or concrete surface finished even and fair without using extra cement all as specified and directed by Engr-in-charge.

M&L for preparation of new plastered surfaces of wall and applying two coats of cement base paint over a coat white wash (primer coat) complete all as specified.

M&L for preparation of old decorated plastered /concrete/ brick surfaces of walls and applying one coat of cement based paint on old decorated surfaces including preparation complete all as specified.

M&L for reinforced cement concrete louvres and jallies 35 mm thick ( measured solid) set in cement mortar 1:4 Type B 0 1:2:4 (12.5 mm graded aggregate) complete all as specified.

M&L for cement concrete type D-2, 1:4:8 ( 40 mm graded aggregate) as in floor 100 mm thick complete all as specified.

M&L Cement concrete type B-1, 1:2:4 ( 20 mm graded aggregate) as in floor 100 mm thick all as specified by Engr-in-charge.

M&L for forming 12mm thick ( thickness of concreat slab 100 mm) Expansion joints filled with pre-formed bituminous filler and top 30mm primed and sealed with sealing compound Grade ‘A’ all as per specified.

M&L Cement concrete type C-1 1:3:6 ( 20 mm graded aggrigate) in surface channels and drains complete all as specified.

Extra for forming fair finished drain or channel 30 cm inner girth in cement concrete, using extra cement, including forms, moulds, mitred/stopped ends etc.

M&L for preparation of new steel surfaces (with rubbing sand paper) of any description, over 10cm in width or girth, applying two coat of synthetic enamel paint over one coat of red oxide primer complete all as specified.

M&L for preparation of old steel surfaces (with rubbing sand paper) of any description, over 10cm in width or girth, applying one coat of synthetic enamel paint all as specified.

M&L RCC type B1, 1:2:4 using 20 mm graded aggregate as in slab, beam, column in floor, roof, landing etc any type of siiler work complete all as specified.

M&L Formwork to sides of pillars, posts, struts, piers, columns and stanchions complete all as specified.

Formwork to soffits of suspended slabs such as roof slabs, floorslabs, landings and similar work; not exceeding 200mm thick (Horizontal or sloping)r complete all as specified.

Formwork to edges of concrete flats, treads, breaks in floors, window cills, concrete railings, openings in concrete walls, floor and roofs n exc 20 cm wide and sides of RCC/ PCC bands in walls, horizontal or sloping and similar work exc 10cm but n exc 20cm wide complete all as specified.

M&L for framed work as in doors or gates of angle or other section with gusset plates, rails, braces, etc., complete, drilled for fixing of steel sheeting or other covering. Doors to be prepared for hanging or sliding with and including either hooks and hinges or steel hanging door fittings (exclusive of steel sheeting or other covering, running rails and guides) and hanging also fastening and fixing complete Fe-410- W(Gde- E-250) quality- B.

M&L Granite (of any type) work (table rubbed and polished) in steps, jambs, pillars, window- cills, cooking platforms and like in cement mortar (1:4) including pointing in white cement (1:2) using marble dust with admixture of pigment to match with shade of granite.

Dismantling floor, hearth or wall tiling including cement mortar bedding (but not backing), removing serviceable tiles to store and rubbish off the premises complete all as specified.

M&L glazed ceramic coloured tiles in vertical surface 300x450x7 mm thick, set and jointed in neat cement slurry and pointed white or colored cement to match the surface over and including 10 mm thick CM 1:4 all as specified.

Repair to steel gates ( including Slot pin, Pintol hinge, Ball bearing, hook and eye of standerad quality where required, resecuring of MS plates/sheets and Guard bars / grills by using welding equipments.

Rough excavation in any type of soil not exceeding 1.5 m deep and getting out and removing excavated materialn exc. 50m and depositing where directed at a level n exc. 1.5 m above the starting point complete all as specified.

Forming embankments including raising (or lowering) earth, watering, ramming/rolling and finishing to required size, shape, etc., n exc. 1.5 m high from base complete all as specified.

S&F Reinforced concrete pipes, bore of the pipe 300mm class NP2, laid and jointed complete with collars all as specified.

S&F Reinforced concrete pipes, bore of the pipe 450 mm class NP2, laid and jointed complete with collars all as specified.

M&L for preparing plastered/unplastered new surfaces and applying two coat of lime wash complete all as specified.

Rolling with Power roller ( Exc 8 tonne and n exc 12 tonee) and consolidating formation surfaces in cutting complete all as specified.

Surface excavation in soft soil n.exc (not exceeding) 30 cm deep and averaging 15cm deep and getting out & complete all as specified.

THAKUR BUILDERS AND CO

M/S MOHAN LAL GUPTA

M/S PARAMJEET SINGH

STAR CONSTRUCTIONS

M/S KEWAL MAHAJAN AND CO

M/S ANIL MAHAJAN

M/S Shesh Paul Gupta