Loading
Loading…
Loading…
Tender Value
₹2.5 Cr
EMD Value
₹5.0 L
Closing Date
15 May 2026, 3:00 pmClosed
No
No
Single Packet System
Normal Tender
No
Not Applicable
Lowest to Highest
60 days
Expenditure
Capital (Works)
Above/Below/Par
BUILDING
14 conditions · 2 needing a document upload
Financial Eligibility Criteria: The tenderer must have minimum average annual contractual turnover of V/N or V whichever is less; where V= Advertised value of the tender in crores of Rupees N= Number of years prescribed for completion of work for which bids have been invited. The average annual contractual turnover shall be calculated as an average of "total contractual payments" in the previous three financial years, as per the audited balance sheet. However, in case balance sheet of the previous year is yet to be prepared/ audited, the audited balance sheet of the fourth previous year shall be considered for calculating average annual contractual turnover. The tenderers shall submit requisite information as per Annexure-VIB, along with copies of Audited Balance Sheets duly certified by the Chartered Accountant/ Certificate from Chartered Accountant duly supported by Audited Balance Sheet. Non submission of the documents shall lead to summarily rejection of the offer.
(a)The tenderer must have successfully completed or substantially completed any one of the following categories of work(s) during last 07 (seven) years, ending last day of month previous to the one in which tender is invited: (i)Three similar works each costing not less than the amount equal to 30% of advertised value of the tender, or (ii)Two similar works each costing not less than the amount equal to 40% of advertised value of the tender, or (iii)One similar work costing not less than the amount equal to 60% of advertised value of the tender. (b) (1)In case of tenders for composite works (e.g. works involving more than one distinct component, such as Civil Engineering works, S&T works, Electrical works, OHE works etc. and in the case of major bridges - substructure, superstructure etc.), tenderer must have successfully completed or substantially completed any one of the following categories of work(s) during last 07 (seven) years, ending last day of month previous to the one in which tender is invited: (i)Three similar works each costing not less than the amount equal to 30% of advertised value of each component of tender, or (ii)Two similar works each costing not less than the amount equal to 40% of advertised value of each component of tender, or (iii)One similar work each costing not less than the amount equal to 60% of advertised value of each component of tender. Note for b(1): Separate completed works of minimum required values shall also be considered for fulfillment of technical eligibility criteria for different components. (b)(2)In such cases, what constitutes a component in a composite work shall be clearly pre-defined with estimated tender cost of it, as part of the tender documents without any ambiguity. (b) (3) To evaluate the technical eligibility of tenderer, only components of work as stipulated in tender documents for evaluation of technical eligibility, shall be considered. The scope of work covered in other remaining components shall be either executed by tenderer himself if he has work experience as mentioned in clause 7 of the Standard General Conditions of Contractor through subcontractor fulfilling the requirements as per clause 7 of the Standard General Conditions of Contract or jointly i.e., partly himself and remaining through subcontractor, with prior approval of Chief Engineer in writing. However, if required in tender documents by way of Special Conditions, a formal agreement duly notarised, legally enforceable in the court of law, shall be executed by the main contractor with the subcontractor for the component(s) of work proposed to be executed by the subcontractor(s), and shall be submitted along with the offer for considering subletting of that scope of work towards fulfillment of technical eligibility. Such subcontractor must fulfill technical eligibility criteria as follows: The subcontractor shall have successfully completed at least one work similar to work proposed for subcontract, costing not less than 35% value of work to be subletted, in last 5 years, ending last day of month previous to the one in which tender is invited through a works contract.
Defination of Similar Work :- Any Civil Engineering work.
13 conditions · 2 needing a document upload
Please enter the percentage of local content in the material being offered. Please enter 0 for fully imported items, and 100 for fully indigenous items. The definition and calculation of local content shall be in accordance with the Make in India policy as incorporated in the tender conditions.
Indian Railways Standard General Conditions of Contract, April 2022 (IRGCC, April 2022) with correction slips issued up to date of inviting tender will be applicable for this tender.
If the bidder submits Bid Security in form of Bank Guarantee, "The Original Bank Guarantee should be delivered in person Receive and Dispatch Section of this office (i.e. DRM office, Engineering Branch, West Central Railway, Jabalpur) before closing date for submission of bids (i.e. excluding the last date of submission of bids)."
Maintenance period will be 06 months or one monsoon whichever is later from the date of actual completion of work
New Katni Junction:- Improvement to drainage along with Epoxy flooring at ROH shed & CWSMF under Assistant Divisional Engineer(Maintenance) Katni sub- division. (Part of work :- New Katni Junction- Improvement to drainage of along with Epoxy flooring at ROH shed & CWSMF.)
DRMW-JBP-60-2026
DRMW-JBP-60-2026
Open
Works - General
12 Months
Jabalpur, Madhya Pradesh
₹0
₹5.0 L
15 May 2026
22 Apr 2026
1 May 2026
47 items across 1 schedule
| # | Description | Unit | Qty | Rate | Amount |
|---|---|---|---|---|---|
| CONCRETE WORK | — | — | — | — | |
| CEMENT CONCRETE (CAST IN SITU) | — | — | — | — | |
| Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - All work up to plinth level : | — | — | — | — | |
| 1 | 1:2:4 (1 cement : 2 coarse sand (zone-III) derived from natural sources : 4 graded stone aggregate 20 mm nominal size derived from natural sources) | cum | 100 | 7,365.15 | 7,36,515 |
| Centering and shuttering including strutting, propping etc. and removal of form work for : | — | — | — | — | |
| 2 | Foundations, footings, bases for columns | Sqm | 420 | 307.95 | 1,29,339 |
| CEMENT CONCRETE PRECAST | — | — | — | — | |
| Providing and fixing up to floor five level precast cement concrete string or lacing courses, copings, bed plates, anchor blocks, plain window sills, shelves, louvers, steps, stair cases, etc., including hoisting and setting in position with cement mortar 1:3 (1 Cement : 3 coarse sand), cost of required Centering complete. | — | — | — | — | |
| 3 | 1:1.5:3 (1 cement : 1.5 coarse sand(zone-III) derived from natural sources: 3 graded stone aggregate 20mm nominal size derived from natural sources) | cum | 2 | 9,277.75 | 18,555.5 |
| REINFORCED CEMENT CONCRETE | — | — | — | — | |
| CAST IN SITU | — | — | — | — | |
| Providing and laying in position specified grade of reinforced cement concrete, excluding the cost of centering, shuttering, finishing and reinforcement - All work up to plinth level : | — | — | — | — | |
| 4 | 1:1.5:3 (1 cement : 1.5 coarse sand (zone-III) derived from natural sources: 3 graded stone aggregate 20 mm nominal size derived from natural sources) | cum | 200 | 8,364.2 | 16,72,840 |
| FORM WORK | — | — | — | — | |
| Centering and shuttering including strutting, propping etc. and removal of form for | — | — | — | — | |
| 5 | Foundations, footings, bases of columns, etc. for mass concrete | Sqm | 500 | 307.95 | 1,53,975 |
| STEEL REINFORCEMENT | — | — | — | — | |
| Steel reinforcement for R.C.C. work including straightening, cutting, bending, placing in position and binding all complete above plinth level. | — | — | — | — | |
| 6 | Thermo-Mechanically Treated bars of grade Fe- 500D or more. | Kg | 18000 | 89.65 | 16,13,700 |
| STEEL WORK | — | — | — | — | |
| Steel work in built up tubular (round, square or rectangular hollow tubes etc.) trusses etc., including cutting, hoisting, fixing in position and applying a priming coat of approved steel primer, including welding and bolted with special shaped washers etc. complete. | — | — | — | — | |
| 7 | Hot finished welded type tubes | Kg | 4500 | 154.9 | 6,97,050 |
| Steel work welded in built up sections/ framed work, including cutting, hoisting, fixing in position and applying a priming coat of approved steel primer using structural steel etc. as required. | — | — | — | — | |
| 8 | In gratings, frames, guard bar, ladder, railings, brackets, gates and similar works | Kg | 6000 | 142.3 | 8,53,800 |
| FLOORING | — | — | — | — | |
| 9 | 52 mm thick cement concrete flooring with concrete hardener topping, under layer 40 mm thick cement concrete 1:2:4 (1 cement : 2 coarse sand : 4 graded stone aggregate 20 mm nominal size) and top layer 12 mm thick cement hardener consisting of mix 1:2 (1 cement hardener mix : 2 graded stone aggregate 6 mm nominal size) by volume, hardening compound mixed @ 2 litre per 50 kg of cement or as per manufacturer's specifications. This includes cost of cement slurry, but excluding the cost of nosing of steps etc. complete. | Sqm | 3500 | 855.9 | 29,95,650 |
| FINISHING | — | — | — | — | |
| CEMENT PLASTER (IN FINE SAND) | — | — | — | — | |
| 15 mm cement plaster on the rough side of single or half brick wall of mix : | — | — | — | — | |
| 10 | 1:4 (1 cement: 4 fine sand) | Sqm | 100 | 339.7 | 33,970 |
| EXTERIOR FINISHING | — | — | — | — | |
| Finishing with Epoxy paint (two or more coats) at all locations prepared and applied as per manufacturer's specifications including appropriate priming coat, preparation of surface, etc. complete. | — | — | — | — | |
| 11 | On steel work | Sqm | 600 | 201.7 | 1,21,020 |
| Painting with synthetic enamel paint of approved brand and manufacture to give an even shade : | — | — | — | — | |
| 12 | Two or more coats on new work | Sqm | 7500 | 131.45 | 9,85,875 |
| DISMANTLING AND DEMOLISHING | — | — | — | — | |
| Demolishing cement concrete manually/ by mechanical means including disposal of material within 50 metres lead as per direction of Engineer - in - charge. | — | — | — | — | |
| 13 | Nominal concrete 1:3:6 or richer mix (i/c equivalent design mix) | cum | 200 | 2,007.1 | 4,01,420 |
| Dismantling C.I. or asbestos rain water pipe with fittings and clamps including stacking the material within 50 metres lead : | — | — | — | — | |
| 14 | 150 mm dia pipe | Metre | 150 | 66.2 | 9,930 |
| Dismantling C.I. pipes including excavation and refilling trenches after taking out the pipes, manually/ by mechanical means breaking lead caulked joints, melting of lead and making into blocks including stacking of pipes & lead at site within 50 metre lead as per direction of Engineer- in-charge: | — | — | — | — | |
| 15 | Above 150 mm dia up to 300 mm dia | Metre | 300 | 448.15 | 1,34,445 |
| 16 | Disposal of building rubbish / malba / similar unserviceable, dismantled or waste materials by mechanical means, including loading, transporting, unloading to approved municipal dumping ground or as approved by Engineer-in- charge, beyond 50 m initial lead, for all leads including all lifts involved. | cum | 300 | 219.35 | — |
| DRAINAGE | — | — | — | — | |
| Providing and fixing square-mouth S.W. gully trap class SP-1 complete with C.I. grating brick masonry chamber with water tight C.I. cover with frame of 300 x300 mm size (inside) the weight of cover to be not less than 4.50 kg and frame to be not less than 2.70 kg as per standard design: | — | — | — | — | |
| Providing and laying non-pressure NP2 class (light duty) R.C.C. pipes with collars jointed with stiff mixture of cement mortar in the proportion of 1:2 (1 cement : 2 fine sand) including testing of joints etc. complete : | — | — | — | — | |
| 17 | 450 mm dia. R.C.C. pipe | Metre | 400 | 1,481.55 | — |
Tap a document below to read it instantly. You can also download everything as a ZIP if you prefer.
details.html
HTML
nit.pdf
NIT
Splcond.LetterofCredit.pdf
ATTACHMENT
ACS8to10ofIRGCCApril2022.pdf
ATTACHMENT
ACSno.11dated13.03.2026_compressed.pdf ACS 11 of IRGCC April 2022
ATTACHMENT
AnnexureVIB.pdf
ATTACHMENT
Specialconditionofwork.pdf
ATTACHMENT
Tenderdocument.pdf
ATTACHMENT
ACSno.11dated13.03.2026_compressed.pdf
ATTACHMENT
Download all tender documents and submit your bid
Disclaimer: TenderKart has made every reasonable effort to ensure that the information on this page is accurate and authentic, however it cannot be held liable for any third-party claims or losses or any damages. TenderKart makes no warranty, expressed or implied, as to the results obtained from the use of this information. If you notice any error or omission, please let us know at .