Replacement of damaged / wornout parts of 110 ampere LT control panel cum fault analyzer cum auto starter installed at pumping station Kidmoo stage-2nd and replacement of wornout mechanical parts of 6000 PH x 300 meter head HC pump set of unit no. 1

Amount

Replacement of damaged / wornout parts of 110 ampere rating panel installed at pumping station Kidmoo stage-2nd . The job involves dismantling of all the incoming and outgoing power cables from the panel and shifting to workshop. Job includes extraction of damaged solid state fault analyzer cum controller (CB4SA) unit and worn-out contactor of MNX-110-2nos. Subsequently providing and fitting of new solid state fault analyzer cum controller (CB4SA) unit of same rating and specifications alongwith 02no. new MNX-110 power contactors of L&T make. Job also covers internal rewiring in place of wornout / damaged wiring and shifting back to the site. Testing of the equipment after repairs, without load and thereafter on full load. Job includes the cost of material, labour charges, hire charges of tools and tackles. Rebate, if any, should be quoted separately.

Replacement of wornout mechanical parts of 6000 GPH x 300 meter head HC pump set of unit no. 1 installed at pumping station Pinger stage-1st (New). The job involves unfastening of pump from base frame, suction and delivery, decoupling of pump from motor. Carriage of damaged pump set to road side through tough hilly terrain of approx 0.5 km by head load and then shifting the same to workshop by mechanical transport. Job includes dismantling the pump followed by replacement of damaged shaft by way of extraction of damaged shaft and fabrication, providing, and fitting of new shaft with turning and finishing to the original bearing size alongwith fabrication of key ways. Providing and fitting of impellers-4nos. diffusers-3nos. and diffuser bushes 3 nos. and neck ring-5nos. Repair to impellers 2 nos., diffuser 2 nos. Providing and fitting of new bearings N205 and N204 at driving and non-driving end, assembly the unit and thereafter shifting from workshop to road side by mechanical transport and then to station by manual carriage, coupling of pump with the motor and making proper leveling and alignment. Testing the pump-motor set on no load and then on full load. Complete job includes cost of material skilled / semi skilled / unskilled labour charges, hire charges of tools and tackles, to and fro manual carriage charges between road side and pumping station etc. (Rebate on unserviceable / old parts must be quoted separately)

TRIKUTA ELECTRICAL AND MECHANICAL WORKS

BEE AAR ENTERPRISES