Road Safety Works on Highway Connecting Sindhanoor Hemmadaga road (SH 30) at KM 116.45 near Siddaroodha math and at KM 117.75 infront of PLD Bank and at KM 117.25 infront of Sangalad Cement Shop in Ron Taluk Gadag District

RoadWorks & RSW

Mechanical Means -

Earth work in surface excavation by mechanical means for lowering & leveling the ground for all works other than foundation in all kinds of soils & upto depth not exceeding 300mm a...

Construction of Subgrade and Earthen Shoulders - Construction of sub-grade and earthen shoulders with approved material obtained from borrow pits with all lifts & leads, transporting...

Granular Sub-Base - By Mix in Place Method - Construction of Granular Sub-Base of required grading as per design spreading in uniform layers with motor grader on prepared sur...

Wet Mix Macadam (Plant Mix Method) - Providing, laying, spreading and compacting graded stone aggregate to wet mix macadam specification including premixing the Material with water at OMC ...

Prime Coat over WMM/WBM - Providing and applying primer coat with SS1 grade Bitumen Emulsion on prepared surface of granular base including cleaning of road surface and spraying ...

Tack coat on Granular surface treated with primer - Providing and applying tack coat with RS1 Bituminous Emulsion using emulsion pressure distributor at the rate of 0.25 kg/m2 on Granular Surface. R...

Tack coat on Bituminous surface - Providing and applying tack coat with RS1 Bituminous Emulsion using emulsion pressure distributor at the rate of 0.20 kg/m2 on the prepared bituminous surface clean...

Dense Graded Bituminous Macadam Grading - II for traffic <20 MSA - Providing and laying Dense Graded Bituminous Macadam with 40/60 TPH capacity HMP using crushed aggregates of specified gradi...

Bituminous Concrete Grading II for traffic <20 MSA - Providing and laying Bituminous Concrete with 40/60 TPH capacity hot mix plant using crushed aggregates of specified grading, pre...

Thin White Topping - Construction of Thin White Topping with M40 grade plain cement concrete pavement over existing Bituminous surface (Preparation to be done if necessary either...

Precast Cement Concrete Interlocking Blocks - Providing and laying 80mm thick factory made precast M -30 grade Cement Concrete Paver Block as per IRC SP 63:2018 & IS 15658 for Commercial Tra...

Road Marking with Hot Applied Thermoplastic Compound with Reflectorising Glass Beads on Bituminous Surface - Providing and laying of hot applied thermoplastic compound 2.5 mm thick including ref...

Supplying and Fixing of Molded Shank Raised Pavement Markers / Cats Eye made of polycarbonate and ABS moulded body and reflective panels with micro prismatic lens capable of providing total int...

Retro-Reflectorised Traffic Signs - Providing and fixing of retro- reflectorised cautionary, mandatory and informatory sign as per IRC:67:2022 made of Class B Type IV ret...

Providing and fixing board displaying information, such as Name of work, Tender cost, Name of Contractor, Work completion and liability period etc, having rectangular shape of 1.2...

Direction and Place Identification Signs upto 0.9 m2 Size Board. - Providing and erecting direction and place identification retro- reflectorised sign as per IRC:67:2022 made of high intensity...

Dismantling of Kerb Stone - Dismantling kerb stone by manual means and disposal of dismantled material with all lifts and lead. Ref to MoRT&H : IRC - 202 ---- Including cost and conveyance of all mat...

Cast in Situ Cement Concrete M20 Kerb - Construction of cement concrete kerb with top and bottom width 115 and 165 mm respectively, 250 mm high in M 15 grade foundation 150 mm t...

Pedestrian Crossings as per IRC 99-2018 - Providing Speed Breakers/Raised pedestrian crossings in Trapezoidal section with 2.5 m Top width and transition length of 0.8 m length and height of...

Steel Fabrication

Supplying, fitting and placing TMT FE 550 / 550D Steel Reinforcement including cost of all materials, machinery, labour, cleaning, straightening, cutting,...

Mechanical Means -

Earth work excavation for Foundation by mechanical means for all works & depth upto 3 m, as per drawing and technical specifications, including setting out, shoring, stru...

Providing and laying in position Cement Concrete for levelling course for all works in foundation. The granite/trap/basalt crushed graded coarse aggregates and fine aggregates ...

Providing and laying in position Cement Concrete for all Foundation works. The granite/trap/basalt crushed graded coarse aggregates and fine aggregates as per relevant IS Codes machine mixed with ...

Filling available excavated earth (excluding rock) in trenches, plinth, sides of foundations and other similar works etc. in layers not exceeding 20cm in depth, consolidating Each depos...

Steel Fabrication

Supplying, fitting and placing TMT FE 550 / 550D Steel Reinforcement including cost of all materials, machinery, labour, cleaning, straightening, cutting,...

Fixing halogen/metal halide /SVL/IL/LED floodlight fitting over existing pole / wall ceiling including clA, bolts, nuts and wiring using suitable capacity wires.

Octagonal hot dip Pole of 12 m

Supplying & fixing of Porcelain fuse channel with cut out on existing wooden/panel using necessary nuts, bolts and washers.100 A

---- Including cost and conveyance of all materials. labour, hi...

Supplying & fixing miniature circuit breakers on existing MCB distribution boards using necessary fixing materials and 'C' Type curve, indicator ON/OFF, energy cross-3 with Short circuit breaking capa...

Supplying & fixing miniature circuit breakers on existing MCB distribution boards using necessary fixing materials and 'C' Type curve, indicator ON/OFF, energy cross-3 with Short circuit breaking capa...

Supplying of Switch Disconnector Fuse Unit (TPN) HRC type (but without HRC fuses). With AC-23A duty and as per IS-13947. (PWD Electrical P-11 of 47, I-5.8.2) 100 Amps.fuse

---- Including cos...

Supplying and Fixing HRC fuse unit base on existing switch/panel board. 100A to 300 Amps 100A to 300 Amps

---- Including cost and conveyance of all materials. labour, hire charges of machiner...

Supplying and fixing HRC fuse link on exising switch fuse base with watt loss as per IS-13703. 63A to 200 Amps

63A to 200 Amps

---- Including cost and conveyance of all materials. labour, hire ...

Supplying and fixing of 4 pole power contractor with NO/NC contractors on existing wood/panel board using necessary bolts, nuts, washers and wiring etc., complete with AC-3 rating and as per IS-13947....

Supplying and Fixing Microprocessor based electronic timer (without contractor, din mounting using necessary bolts, nuts and washers etc.) 3- 120 sec. Setting

---- Including cost and conveyance...

Supplying and drawing Flexible Multicore Cable manufactured with electrolytic grade copper with flexible copper with low conductor resistance confirming to table

3 class 5 of IS:8130-1984 and (Virgin)...

Fabricating, supplying and mounting MS Box made outSWG suitable for floor/wall mounting, fully weather proof with provision for better heat dissipation, provided with hinged front cover, equipped with...

Supplying Amps rated 3 phase with neutral bus bar using required capacity electrolytic aluminium strips covered with heat shrinkable coloured PVC sleeve, mounted on phenolic/FRP/DMC insulator which ar...

Supplying and fixing angle iron frame work fabricated out of M.S. Angle ironand M.S. Flat with bolts, washers etc., and painted with 2 coats of red oxide and then two coats of approved paint.

Supplying HDPE pipes confirming to IS 4984:1995 with latest amendments and conveying to work site includng loading and unloading at both destination and rolling, lowering into trenches, laying true to...

Fabrication, Supplying, Erection, Testing and Commissioning of ms long Polygon high mast with Single/Multiple telescopic sections having, (minimum overlap distance of 1.5 times of top section) thickne...

Supply of LED Streetlight luminaire with pressure die cast aluminium housing body for optimal thermal dissipation. Lamp compartment comprising of anti glare clear diffuser with Injection moulded polyc...

Laying of cable in Existing Trench/GI pipe/Stone Ware/RCC Hume pipe using Wooden/Aluminum Rollers as directed by the departmental staff(31,LT Cable, 35 to 95 Sqmm

---- Including cost and convey...

Additionalities For Formwork, Centering , & Scaffolding Footing 8% (page no-111, I No-1(a)) (PWD SR 2023-24) Volume-1

---- Including cost and conveyance of all materials. labour, hire charges o...

Additionalities For Formwork, Centering , & Scaffolding For Columns 70% (page no-111, I No-1(a) (PWD SR 2023-24) Volume-1 (Corrigendum-3)

---- Including cost and conveyance of all materials. la...

DECORATIVE STRICTLIGHTS

Supplying tinned copper lugs and crimping and wiring to terminal point for wire of the following sizes. - 16 sqmm

---- Including cost and conveyance of all materials. labour, hire charges of machiner...

Labour charges for laying of 1.1 KV class UG cable in existing trench GI pipe/ stoneware pipe /on wall / on pole as required. In existing trench/duct. On wall/Structure - 6 sqmm to 16 sqmm

Supplying, fixing, wiring, earth electrode for grounding conduits, I.C. cutouts and other equipment's on the meter board using 40mm dia 2.90mm thick GI pipe 2.5 mtr long buried in a pit . The pit shou...

Decorative Median Light poles:Fabricating,supplying and erection of 10mtrs long(Vertical Height) hot dip galvanised conical pole with BSEN 10025 grade 355 JO steel plate for shaft,IS 2062 for base pla...

Supply of LED Streetlight luminaire with pressure die cast aluminium housing body for optimal thermal dissipation.

Lamp compartment comprising of anti glare clear diffuser with Injection moulded polyc...

Supplying and drawing Flexible Multicore Cable manufactured with electrolytic grade flexible copper with low conductor confirming to IS:8130-1984 and (Virgin) PVC insulation sheathed suitable for work...

Supplying of 1.1 KV LT UG cable XLPE or Heat resistant PVC insulated, PVC extruded Inner sheath armoured UG LT cable as per IS-1554 (Part-1) or IS-7098 Part-1, Armouring strip thickness in average +5%...

Fabricating supplying and mounting MS box made out .SWG suitable for floor / wall mounting, fully weather proof with provision for better heat dissipation, provided with hinged front cover, equipped w...

Supplying and fixing Microprocessor based Electronic timer (without contactor, Din Mounting using necessary bolts, nuts and washers etc.,.) 3-120sec setting. (KPWD Electrical Common SR of 2021-22 Item...

Supply and fixing of 4pole power contactor with NO/NC contacts on existing wood/panel board using necessary bolts, nuts, washers and wiring etc., complete with AC-3 Rating and as per IS-13947. 40 Amps...

Supplying and fixing angle iron frame work fabricated out of M.S. angle iron. and M.S. flat . with bolts, washers etc., and painted with 2 coats of red oxide and then two coats of approved paint. 40x4...

Supplying and fixing miniature circuit breakers on existing MCB distribution boards using necessary fixing materials and 'C' Type curve, indicator ON/OFF, energy cross-3 with Short circuit breaking ca...

Earth work excavation for Foundation by mechanical means for all works & depth upto 3 m, as per drawing and technical specifications, including setting out, shoring, strutting, barricading, caution li...

Providing, laying and jointing HDPE pipes of specified grade and

conforming to IS 4984-2016 with latest ammendments and conveying

to work site including loading and unloading at both destinations an...

Supplying and fixing Electronic trivector Meter (ETV) suitable for operation LT operation and CT-operated meter in polycarbonate body in class 0.5 accuracy as per IS 14697 and completely wired.