Improvement work of road and drain from house number 6/39 to house number6/34 Shiv Katra ward 24 Under Zone02

NA-FS17013-DIMOLITION & DISMENTLING-New Dismentalllng of B.O.E soling/Inter locking tiles Including Stacking of servicable direction of EI/C (Labour only)material and disposal Dismentalllng of B.O.E soling/Inter locking tiles Including Stacking of servicable direction of EI/C (Labour only)material and disposal of unservicable material within a lead of 50m as per-Rate-11 per 1 Sqm.

2.25 (a)-FS4008-Earth Work-Excavating, suppling and filling of local earth ( incuding royalty) by mechenical transport upto a lead of 1km also including ramming and watering of the earth in layers not exceeding 20cm in trenches, plinth sides of foundation etc. Excavating, suppling and filling of local earth ( incuding royalty) by mechenical transport upto a lead of 1km also including ramming and watering of the earth in layers not exceeding 20cm in trenches, plinth sides of foundation etc.-Rate-125.00 per 1 Cum.

2.6(2.6.1)-FS4002-Earth Work-E/W in Excavation in trenches for foundation pipe cable in ordinary soil including 1.5left and 50m and dressing of side and ramming of bottom and disposal of surplus axcavated earth Earth work in execavation in foundation and under plinth area lift 1.5 m lead 30 m with all charges complete.-Rate-174 per 1 Cum.

PWD (SCH.) -273-FS5007-Concrete/R.C.C. Work-Providing and laying In position cement concrete of specified grade excluding the cost of centering and shuttering - All work up to plinth level 1:6:12 (1 cement : 6 coarse sand (zone-Ill): 12 graded Brick aggregate 40 mm (nominal size)-Rate-4380 per 1 Cum.

NA-S31011-Non SOR-Non SOR Providing and laying at or near ground level factory made kerb stone of M-25 grade cement in position to the required line, level and curvature jointed with cement mortar 1:3 (1cement : 3 coarser sand) including making joints with or without grooves (thickness of joints except ar sharp curve shall not to more than 5mm) including making drainage, opening wherever required complete etc. as per direction of Engg-in-charge (Length of finished kerb shall be measured for payment)-Rate-458 per 1 Rmt

5.2.2-FS5025-Concrete/R.C.C. Work-RCC work with cement approved coarse sand and 20mm approved stone ballast in proportion for raft foundation with 1:1.5:3 (1 cemnt 1.5 C. sand 20 mm size stone ballast) RCC work with cement approved coarse sand and 20mm approved stone ballast in proportion for raft foundation with 1:1.5:3 (1 cemnt 1.5 C. sand 20 mm size stone ballast) including bending binding and fixing of reinfocement in position casting cutting of wall and satisfaction of the engineer in charge including cost of all material etc all complete (ch-5, sn-15, ref- 5.2.2)-Rate-8600.00 per 1 Cum.

5.34.1-FS5027-Concrete/R.C.C. Work-All works upto plinth level Providing and laying In position ready mixed M-25 grade concrete for reinforced cement concrete work, using cement content as per approved design mix, manufactured In fully automatic batching plant and transported to site of work In transit mixer for all leads, having continuous agitated mixer, manufactured as per mix design of specified grade for reinforced cement concrete work, Including pumping of R.M.C. from transit mixer to site of laying , excluding the cost of centering, shuttering finishing and reinforcement, including cost of admixtures In recommended proportions as per IS : 9103 to accelerate/ retard setting of concrete, improve workability without impairing strength and durability as per direction of the Engineer-In-charge. (Note :- Cement content considered In this item Is @ 330 kg/cum.Excess/less cement used as per design mix Is payable/recoverable separately).-Rate-9560.00 per 1 Cum.

37-A-F1055-Materials-Providing and laying of 125micron plastic sheet etc all complete. Providing and laying of 125micron plastic sheet etc all complete.-Rate-18.00 per 1 Sqm.

sor-F1057-Materials-Providing and laying Pre moulded joints filler 12 mm thick for expention including all labour work Providing and laying Pre moulded joints filler 12 mm thick for expention including all labour work-Rate-320.00 per 1 Sqm.

Non-Sor-F10021-MILD STEEL & IRON WORK-M.S. or iron in plain work such as hevey size as fabrication of M.S. M.S. or iron in plain work such as hevey size as fabrication of M.S.-Rate-7200.00 per 1 Qtl